Question is ⇒ Consider the sequence x(n) whose fourier transform X(ejω) is depicted for - p ≤ ω ≤ p as shown in fig, Options are ⇒ (A) 1 - True, 2 - True, 3 - True, 4 - True, (B) 1 - False, 2 - True, 3 - False, 4 - True, (C) 1 - True, 2 - False, 3 - True, 4 - False, (D) 1 - False, 2 - False, 3 - False, 4 - True, (E) , Leave your comments or Download question paper.

Question is ⇒ Consider the sequence x(n) whose fourier transform X(ejω) is depicted for - p ≤ ω ≤ p as shown in fig, Options are ⇒ (A) 1 - True, 2 - True, 3 - True, 4 - True, (B) 1 - False, 2 - True, 3 - False, 4 - True, (C) 1 - True, 2 - False, 3 - True, 4 - False, (D) 1 - False, 2 - False, 3 - False, 4 - True, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Consider the sequence x(n) whose fourier transform X(e^jω) is depicted for - p ≤ ω ≤ p as shown in fig
A.	1 - True, 2 - True, 3 - True, 4 - True [Wrong Answer]
B.	1 - False, 2 - True, 3 - False, 4 - True [Correct Answer]
C.	1 - True, 2 - False, 3 - True, 4 - False [Wrong Answer]
D.	1 - False, 2 - False, 3 - False, 4 - True [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In drawing phasor diagrams, RMS values are used.
TRUE
FALSE

⇒ In the circuit of figure the current through 5 Ω resistance at t = 0^{+0.166666666666667
2.5 A
3.1 A
0}

⇒ A 400 W carrier is amplitude modulated with m = 0.75. The total power in AM is
400 W
512 W
588 W
650 W

⇒ An antenna couple is used due to all of the following reasons except
to prevent reradiation of the local oscillator
to discriminate against harmonics
to make the antenna look resistive
to provide the output amplifier with the correct load impedance

⇒ Auto correlation for t = 0 is equal to
average power S of waveform
square of average power S of waveform
half of average power S of waveform
square root of average power S of waveform

⇒ The frequency response of an ideal tuned amplifier should be as represented in figur
A
B
C
D

⇒ The response of a thermistor overs the whole of its temperatures range is
linear
non-linear
almost linear
either (a) or (c)

⇒ Which two rows represent identical binary numbers?
A second and fourth
Fifth and eight
Third and seventh
Second and third

⇒ The temperature coefficient of resistivity of semiconductors is
positive
negative
may be positive or negative
very low

⇒

Assertion (A): In liquid system the ratio of change in liquid level to change in flow rate is called resistance of liquid flow.

Reason (R): In liquid level systems the ratio of change in liquid stored in a tank to the change in head is called capacitance of tank.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒

Match the following:

	List I		List II
A.	Resistance	1.	Current noise
B.	Diode	2.	Partition noise
C.	Triode	3.	Shot noise
D.	p-n junction	4.	Atmospheric noise
		5.	Johnson noise

A-5, B-3, C-2, D-1
A-1, B-2, C-3, D-5
A-3, B-5, C-1, D-2
A-3, B-5, C-2, D-1

⇒ In Pascal if I = 45, I div 10 * 10 =
45
40
0.45
0.4

⇒ In free space, line of sight propagation case, the transmission losses between transmitter and receiver increase with frequency (f) as
f
f²
f⁴
f^1/2

⇒

Assertion (A): A small section of high impedance line is equivalent to a series inductance.

Reason (R): A small section of a low impedance line is equivalent to a series resistance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following are the memory performance parameters?

Access time and latency
Block size and Block access time
Cycle time and Bandwidth

Select the correct answer from the codes given below:
1 only
1 and 2 only
2 and 3 only
1, 2 and 3

⇒ A series resonant circuit has parameters 10 ω, 1 H and 0.1 F. It is excited by a voltage v = 100 sin ωt. At resonant frequency, the power dissipated in the circuit is
1000 W
707 W
500 W
414.14 W

⇒ Automatic sensitivity control by target voltage control is easily possible in
Vidicon
Plumbicon
New vicon
both (b) and (c)

⇒ An m derived low pass filter has f_c = 1000 Hz and m = 0.6. This filter will have infinite attenuation at
f = 1250 Hz
all frequencies above 1000 Hz
f = 1562.5 Hz
f = 1666.67 Hz

⇒ Assume that x = 5 and y = 2. Then in Java operation x + = y, the result is
x = 7
x = 2
x = 3
x = 2

⇒ A transmission line is feeding 1 watt of power to a horn antenna having a gain of 10 dB. The antenna is matched to the transmission line. The total power radiated by the horn antenna into the free space is
10 watt
1 watt
0.1 watt
0.01 watt

⇒ The initial state of a Mod-16 counter is 0110. After 37 clock pulses the state of counter will be
1011
110
10
1

⇒ In a flip flop which input determines the state to which output will transistion?
Control input
Clock input
Both control and clock input
Either control or clock input

⇒ A transmitter serial current contains
carrier frequencies
audio frequencies
radio frequencies
none of the above

⇒ When a ferromagnetic substance is magnetised there are small changes in dimensions. This phenomenon is called
hysteresis
magnetostriction
diamagnetism
dipolar relaxation

⇒ In telephone systems, load is expressed in the unit of
erlangs
decibels
bells
watts

⇒ In two level logic, logic race does not occur.
TRUE
FALSE

⇒ Between which points does UJT exhibit negative resistance characteristics
between peak and valley points
before peak point
after peak point
after valley point

⇒ If a capacitor is charged by a square wave current source the voltage across the capacitor is
triangular wave
step function
zero
square wave

⇒ The core of a solenoid is made of material of relative permeability μ_r. A small cavity area dA and length dl is cut in the core. If it is desired that flux density in the cavity should be equal to B₀
the fields inside and outside the cavity must be equal
the field inside the cavity must be made stronger than field outside the cavity
the field inside the cavity must be made weaker than the field outside the cavity
none of the above

⇒ Which of the wave remains unaffected whether it is a day or night?
Sky wave
Ground wave
Tropospheric wave
Space wave