Question is ⇒ Consider the following statements<ol style="list-style-type: decimal; padding-bottom:10px;"><li style="padding-top:10px;">In 8085 address and data buses are multiplexed.</li><li style="padding-top:10px;">In Z 80 address and data buses are multiplexed</li><li style="padding-top:10px;">In Z 80 address and data buses are not multiplexed.</li><li style="padding-top:10px;">Z 80 has 16 bit address bus and 8 bit data bus.</li></ol> Which of the above statements are correct?, Options are ⇒ (A) 1 and 2 only, (B) 1, 3 and 4 only, (C) 1, 2 and 4 only, (D) 2 and 4 only, (E) , Leave your comments or Download question paper.

Question is ⇒ Consider the following statements<ol style="list-style-type: decimal; padding-bottom:10px;"><li style="padding-top:10px;">In 8085 address and data buses are multiplexed.</li><li style="padding-top:10px;">In Z 80 address and data buses are multiplexed</li><li style="padding-top:10px;">In Z 80 address and data buses are not multiplexed.</li><li style="padding-top:10px;">Z 80 has 16 bit address bus and 8 bit data bus.</li></ol> Which of the above statements are correct?, Options are ⇒ (A) 1 and 2 only, (B) 1, 3 and 4 only, (C) 1, 2 and 4 only, (D) 2 and 4 only, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Consider the following statements In 8085 address and data buses are multiplexed. In Z 80 address and data buses are multiplexed In Z 80 address and data buses are not multiplexed. Z 80 has 16 bit address bus and 8 bit data bus. Which of the above statements are correct?
A.	1 and 2 only [Wrong Answer]
B.	1, 3 and 4 only [Wrong Answer]
C.	1, 2 and 4 only [Correct Answer]
D.	2 and 4 only [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The rms voltage measured across each of the circuit element in figure is as shown, when the circuit is excited by a sinusoidal voltage E_s, the rms value of the source voltage e_{s10 volt
2 volt
E_s
5 volt}

⇒ Bipolar IC memories are fabricated using
high density versions of MOSFET or low density versions of bipolar transistor flip-flop.
high density version of MOSFET or bipolar transistor flip-flop
low density versions of MOSFETs
high density versions of the bipolar transistor flip-flop.

⇒ In a specimen of n type semiconductor, the initial concentration of holes and electrons is p_no and n_no. When the specimen is subjected to radiation, the hole and electron concentration increase to p_n and n_n. Then
p_n - p_no = n_n - n_no
p_n + p_no = n_n + n_no
p_n - p_no = n_no + n_no
p_n + p_no = n_n - p_no

⇒ A band limited signal is sampled at the Nyquist rate. The signal can be recovered by passing the samples through
an RC filter
an envelope detector
a PPL
an ideal low pass filter with the appropriate bandwidth

⇒ A boot strap generally incorporates
CB configuration
CE configuration
emitter follower
none of the above

⇒ Consider the following stateme
2 and 4
1 and 2
1 only
3 and 4

⇒ The range of value "a" for which system will be stable. If impulse response of DT system is = aⁿ ∪[n]
a > 1
a < 1
1 < a < ∞
-1 < a < 1

⇒

Assertion (A): A demultiplexer can be used as a decoder.

Reason (R): A demultiplexer can be built by using AND gates only.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Degaussing in a picture tube means
Adding magnetism in mask and mounting frame
Removing residual magnetism in mask, shield etc...
Increasing resistance of coils to decrease time constant
Decreasing resistance of coils to increase time constant.

⇒ An antenna is considered to be in free space where its height above the ground is
λ
2λ
less than 3λ
more than 5λ

⇒ The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The input signal-to noise ratio is
2
10
20
100

⇒ Which of the following parameters is not specified for digital ICs?
Gate dissipation
Propagation delay
Noise margin
Bandwidth

⇒

Assertion (A): The use of 2's complement has simplified the computer hardware for arithmetic operations

Reason (R): 2's complement is obtained by adding 1 to 1's complement.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The channel required for FM telemetry is
same as required for AM telemetry
smaller than that required by AM telemetry
100 times that required for AM telemetry
10 times that required for AM telemetry

⇒ The advantage of semiconductor strain gauge over resistance strain gauge is
it is more sensitve
it is more linear
it is less temperature dependent
it is cheaper

⇒ In a tape recorder
the width of air gaps of record and erase heads is almost equal
the air gap of record head is wider than the air gap of erase head
the air gap of erase head is wider than the air gap of record head
any of the two air gaps can be wider than the other

⇒ Consider the following statements regarding the class-B power amplifiers (Complementary symmetry type):

The efficiency of the amplifier is higher than that of class-A amplifier
The power output is low
Crossover distortion is present
The standby power dissipation is absent.

Which of the above statements are correct?
1, 2 and 3
1, 2 and 4
1, 3 and 4
2, 3 and 4

⇒ Thermistor has a positive temperature coefficient.
TRUE
FALSE

⇒ A ramp input applied to a unity feedback system results in 5% steady state error. The type number and zero frequency gain of the system are respectively.
1 and 20
0 and 20
0 and 1/20
1 and 1/20

⇒ A system with transfer function H(z) has impulse response h(.) defined as h(2) = 1, h(3) = -1 and h(k) = 0 otherwise. Consider the following statem
Only S2 is true
Both S1 and S2 are false
Both S1 and S2 are true, and S2 is a reason for S1
Both S1 and S2 are true, but S2 is not a reason for S1

⇒ An RLC series circuit has R = 8 Ω, X_L = 8 Ω and X_C = 8 Ω Its impedance is
8 + j 16 Ω
8 + j 8 Ω
8 Ω
24 Ω

⇒ Binary 101010 is equivalent to decimal number
24
42
44
64

⇒ In FM modulation pre-emphasis is done for
high frequency components
low frequency components
middle frequency components
both (a) and (b)

⇒ The z-transform of a particular signal is gi
casual and stable
non-casual and stable
non-casual and unstable
casual and unstable

⇒ Electric dipole moment is expressed in debye unit.
TRUE
FALSE

⇒ In figure the voltage drop across the 10 Ω resistance is 10 V. The resistan
is 6 Ω
is 8 Ω
is 4 Ω
cannot be found

⇒ Wienbridge oscillator uses
-ve feedback
+ve feedback
both +ve, -ve feedback
feedback is not required

⇒

Assertion (A): Many instruments use eddy current damping.

Reason (R): Eddy currents set up a magnetic flux which opposes the original movement which generates them.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In a varistor, as the voltage increases beyond a certain value, its resistance
rapidly increases
rapidly decreases
becomes negative, i.e., varistor goes into negative resistance region
none of these

⇒ MICR stands for
Magnetic Ink Chart Receipt
Magnetic Ink Character Recognition
Magnetic Ink Chart Recognition
Magnetic Ink Character Receipt