Question is ⇒ Consider the following statements regarding electro-dynamometer type indicating instrum, Options are ⇒ (A) 1 and 2 are corect, (B) 3 and 4 are correct, (C) 1 and 3 are correct, (D) 1, 2, 3, 4 are correct, (E) , Leave your comments or Download question paper.

Question is ⇒ Consider the following statements regarding electro-dynamometer type indicating instrum, Options are ⇒ (A) 1 and 2 are corect, (B) 3 and 4 are correct, (C) 1 and 3 are correct, (D) 1, 2, 3, 4 are correct, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Consider the following statements regarding electro-dynamometer type indicating instrum
A.	1 and 2 are corect [Wrong Answer]
B.	3 and 4 are correct [Wrong Answer]
C.	1 and 3 are correct [Wrong Answer]
D.	1, 2, 3, 4 are correct [Correct Answer]
View Answer 2 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which has the highest power dissipation per gate?
ECL
TTL
CMOS
PMOS

⇒ If antenna diameter is increased four times, the maximum range is increased by a factor of
2
2
4
0.2

⇒ Which of the following may result in instability problem?
Large error
High selectivity
High gain
Noise

⇒ His rather casual remarks on politics __________ his lack of seriousness about the subject.
masked
belied
cherish
conserve

⇒ A series resonant circuit is capacitive at f = 150 Hz. The circuit will be inductive somewhere at
f greater than 150 Hz
f less than 150 Hz
f equal to 150 Hz by increasing the value of the resistance
none of the above

⇒ In a series R, L, C circuit the impedance triangle is the same when X_L < X_C and X_L > X_C .
TRUE
FALSE

⇒ A single phase semiconverter is feeding a highly inductive load and has freewheeling diode across the load. The waveshapes of output voltage and output current
are similar
are not similar
may be similar or dissimilar
are similar only if firing angle is zero

⇒ In the circuit of figure, the current through battery E_{34 A charging
4 A discharging
4 A charging or discharging depending on value of E₃
4 A charging or discharging depending on values of E₁, E₂, E₃}

⇒ Full duplex operation-permits transmission in both directions at the same time.
TRUE
FALSE

⇒ The attenuation factor in parallel plane guides is given by
a = power lost/power transmitted
a = 2 x power lost/power transmitted
a = power lost per unit length/2 x power transmitted
a is always constant

⇒ Which is correct with respect to computer memory?
Only a particular address can have a particular memory
Any address can have any memory
To read a word from computer memory, it is not necessary to specify a location
None of the above

⇒ In rectangular waveguides the ratio of width to height is about
0.5
1
2
4

⇒ In a CE amplifier, the collector resistance is 6 kΩ and load resistance is 3 kΩ. The ac load resistance is
9 kΩ
6 kΩ
3 kΩ
2 kΩ

⇒

Assertion (A): Many times a radar cannot detect 'grounding hopping' military aircraft.

Reason (R): Ground interference limits the range of radar.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following voltmeters would you use for measuring voltage across 20 kΩ resistance?
Voltmeter having a resistance of 5 kΩ
Voltmeter having a sensitivity of 1 kW/V
Voltmeter having sensitivity of 10 kW/V
None of the above

⇒ A current of 1 A in the coil of an iron cored electromagnet causes B = 0.5T. If current is 2A, B =
0.5 T
1 T
1 T or more
1 T or less

⇒ A computer window has a bar at its top to bear the name of window. This bar is called
title bar
status bar
menu bar
control bar

⇒ For the circuit, let us assume that R = 1 Ω, L = 10^-3 H, and V(t) = 10 cos (1000t + 30°)V and the differential equation for I(t) is give
7.07 cos (1000t + 15°) A
70.7 cos (1000t - 30°) A
7.07 cos (1000t - 15°) A
7.07 cos (1000t + 15°) A

⇒ Curl of gradient A is
∇ x (∇A) = 1
∇ x (∇A) = ∞
∇ x (∇A) = 0
∇ x (∇A) = - ∞

⇒ The number of leads in an SCR are :
2
3
4
5

⇒ The holes diffuse from P-region to the N-region in a P-N junction diode because
there is greater concentration of holes in the P-region as compared to N-region
there is greater concentration of holes in the N-region as compared to P-region
the free electrons in the N-region attract them
potential difference facilities such transfer

⇒ Consider the following statements about 8085

The instruction LDA uses direct addressing mode.
The instruction MVI uses direct addressing mode.
The instruction MVI uses immediate addressing mode.
The instruction LDA uses immediate addressing mode.

Which of the above are correct?
1 and 3 only
3 and 4 only
1 and 2 only
2 only

⇒ A varactor diode is used for
tuning
rectification
amplification
rectification and amplification

⇒ If the amplitude of the voltage is kept constant, but its frequency is raised to 6 kHz, the new deviation will be for the modulation index is, if f_m = 500 Hz, Δf = 2.25
6 kHz
12 kHz
27 kHz
54 kHz

⇒ For a npn BJT transistor f_β is 1.64 x 10⁸ Hz. C_μ = 10^-14 F; C_p = 4 x 10^-13 F and DC current gain is 90. Find f_T and g_m (f_β = cut off frequency, C_μ = capacitance, C_p = parasitic capacitance, g_m = transconductance, f_T = gain BW product)
f_T = 1.47 x 10¹⁰ Hz ; g_m = 38 milli mho
f_T = 1.64 x 10⁸ Hz ; g_m = 30 milli mho
f_T = 1.47 x 10⁹ Hz ; g_m = 38 mho
f_T = 1.33 x 10¹² Hz; g_m = 0.37 m-mho

⇒ Which of the following closely represents the resistance-temperature characteristics of thermistor?
R_T = a R₀ e^b/t
R_T = a R₀ E^-b/t
R_T = - a R₀ e^-b/t
R_T = - R₀ e^b/t

⇒

Assertion (A): A tuned amplifier uses a parallel tuned circuit

Reason (R): A tuned amplifier is used to amplify a narrowband frequencies

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ To avoid objectionable noise in a microwave TV link, the SNR should be about
50 or more
10 or more
25 or more
200 or more

⇒ DVD uses
Laser beam for both recording and playback
Laser beam for recording and video head for playback
Video head for recording and laser beam for playback
None of the above

⇒ Which of the following elements act as donor impurities?

Gold
Phosphorus
Boron
Antimony
Arsenic
Indium

Select the correct answer using the codes given below:
1, 2, 3
1, 2, 4, 6
3, 4, 5, 6
1, 4, 5