Question is ⇒ Consider the following statements as regards IF in radio receivers <ol style="list-style-type: decimal; padding-bottom:10px;"><li style="padding-top:10px;">If IF is too high, poor selectivity and poor adjacent channel rejection could result</li><li style="padding-top:10px;">If IF is high, tracking difficulties increase</li><li style="padding-top:10px;">A very low IF makes selectivity too sharp</li><li style="padding-top:10px;">As IF is decreased, image frequency rejection becomes better</li></ol> Which of the above are correct?, Options are ⇒ (A) 1, 2, 3, 4, (B) 1, 2, 3, (C) 2, 3, 4, (D) 1, 3, 4, (E) , Leave your comments or Download question paper.

Question is ⇒ Consider the following statements as regards IF in radio receivers <ol style="list-style-type: decimal; padding-bottom:10px;"><li style="padding-top:10px;">If IF is too high, poor selectivity and poor adjacent channel rejection could result</li><li style="padding-top:10px;">If IF is high, tracking difficulties increase</li><li style="padding-top:10px;">A very low IF makes selectivity too sharp</li><li style="padding-top:10px;">As IF is decreased, image frequency rejection becomes better</li></ol> Which of the above are correct?, Options are ⇒ (A) 1, 2, 3, 4, (B) 1, 2, 3, (C) 2, 3, 4, (D) 1, 3, 4, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Consider the following statements as regards IF in radio receivers If IF is too high, poor selectivity and poor adjacent channel rejection could result If IF is high, tracking difficulties increase A very low IF makes selectivity too sharp As IF is decreased, image frequency rejection becomes better Which of the above are correct?
A.	1, 2, 3, 4 [Wrong Answer]
B.	1, 2, 3 [Correct Answer]
C.	2, 3, 4 [Wrong Answer]
D.	1, 3, 4 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The characteristic impedance of a twin wire feeder used for TV signals is about
1000 ohm
500 ohm
300 ohm
100 ohm

⇒ A parallel RLC network has R = 4Ω, L = 4H, C = 0.25F. Then at resonance Q =
1
10
20
40

⇒ A full subtractor has a total of
2 inputs
3 inputs
4 inputs
5 inputs

⇒ Y signal has maximum percentage of
red colour
blue colour
green colour
red and blue colours

⇒ The absorption of radio waves by the atmosphere depends on
the polarization of the waves
the polarization of the atmosphere
frequency of the waves
their distance from the transmitter

⇒ For a plane good conductor, skin depth varies
directly as square root of permeability
directly as square root of frequency
inversely as permittivity
inversely as square root of conductivity

⇒ The Voltage e₀ in the figu
2 V
4 V
4/3 V
8 V

⇒ A proportional controller is basically
an amplifier with adjustable gain
an integrating amplifier
an amplifier with infinite gain
an amplifier with almost zero gain

⇒ The parity bit is
always 1
always 0
1 or 0
none of the above

⇒ In high power AM transmission modulation is done at
IF stage
RF power
buffer stage
oscillator stage

⇒ 8 bit data can have 256 numbers ranging from 00000000 to 111 111 11.
TRUE
FALSE

⇒ In a broadcast superheterodyne receiver
the local oscillator operates below the signal frequency
local oscillator frequency is normally double the IF
RF amplifier normally works at kHz above the carrier frequency
mixer input must be tuned to the signal frequency

⇒ In a tape recorder
the width of air gaps of record and erase heads is almost equal
the air gap of record head is wider than the air gap of erase head
the air gap of erase head is wider than the air gap of record head
any of the two air gaps can be wider than the other

⇒ The stator of phase shifting transformer for use in conjunction with an ac potentiometer has a
single phase winding
two phase winding
3 phase winding
either (a) or (c)

⇒ Probability density function of thermal noise is
Poisson
Binomial
Gaussian
None of the above

⇒ The amplifier circuit shown below uses a silicon transistor. The capacitors C_c and C_E can be assumed to be short at signal frequency and the effect of output resistance r₀ can be ignored. If C_E is disconnected from the circuit, which one of the following statements is T
The input resistance R_i increases and the magnitude of voltage gain A_v decreases
The input resistance R_i decreases and the magnitude of voltage gain A_v decreases
Both input resistance R_i and the magnitude of voltage gain A_v decrease
Both input resistance R_i and the magnitude of voltage gain A_v increase

⇒ Antenna radiation efficiency can be increased by
reducing radiation resistance of the system
increasing radiation resistance of the system
providing effective earthing
any of the above

⇒ Temperature is analogous to
voltage
flux
charge
none of the above

⇒ A 1 mA meter is to be converted to 1 A ammeter. The meter resistance is 100 Ω. The value of shunt resistance is
0.001 Ω
0.1001 Ω
100 Ω
1000 Ω

⇒ A single phase half wave converter is used to charge a battery of 50 V. The thyristor is continuously fired by dc signal. Input voltage is v = V_m sin ωt. The thyristor will conduct
from 0 to 180°
when v > 50 V
from 0 to 90°
When v < 50 V

⇒ A megger has a hand driven dc generator.
TRUE
FALSE

⇒ A voltage gain of a CE amplifier connected in collector to base configuration is 50. Collector to base resistor R_F = 1 kΩ, R_C = 4Ω, the O/P resistance R₀ =?
800 Ω
813 Ω
817 Ω
819 Ω

⇒ The autocorrelation function of the white noise is
impulse function
step function
constant
none of the above

⇒ The initial contents of ACC and CY in 8085 are

CY = 1
ACC = 10000001

After instruction RAL is executed once the contents of CY and ACC respectively will be
1 and 00000011
0 and 00000011
1 and 00000001
0 and 00000001

⇒

Assertion (A): A composite video signal has synchronising pulses.

Reason (R): It is necessary to synchronise the scanning process in the transmitter and receiver.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A rectangular waveguide having TE₁₀ mode as dominant mode is having a cut off frequency of 18 GHz for the TE₃₀ mode. The inner broad wall dimension of the rectangular waveguide is
5/3 cm
5 cm
5/2 cm
10 cm

⇒ For a photo conductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in the intensities of optical illumination results in
change in open circuit voltage
change in short circuit current
a reduction resistance
an increase of resistance

⇒ In a shift register the data is loaded in one operation but shifted out one bit at a time, The shift register is
serial in-serial out
parallel in-serial out
serial in-parallel out
parallel in-parallel out

⇒ Which of the following types of noise assumes greater importance at high frequencies?
Transit time noise
Shot noise
Impulse noise
Random noise

⇒ A number is expressed in binary 2's complement as 10011 decimal equivalent value is
19
13
-19
-13