Question is ⇒ Consider the following statements about transport-lag <ol style="list-style-type: decimal; padding-bottom:10px;"><li style="padding-top:10px;">It is of non-minimum phase behaviour</li><li style="padding-top:10px;">It normally exists in thermal, hydraulic and pneumatic systems</li><li style="padding-top:10px;">It has an excessive phase lag with no attenuation at high frequency</li></ol> Which of the above statements are correct?, Options are ⇒ (A) 1 only, (B) 1 and 2, (C) All, (D) 2 and 3, (E) , Leave your comments or Download question paper.

Question is ⇒ Consider the following statements about transport-lag <ol style="list-style-type: decimal; padding-bottom:10px;"><li style="padding-top:10px;">It is of non-minimum phase behaviour</li><li style="padding-top:10px;">It normally exists in thermal, hydraulic and pneumatic systems</li><li style="padding-top:10px;">It has an excessive phase lag with no attenuation at high frequency</li></ol> Which of the above statements are correct?, Options are ⇒ (A) 1 only, (B) 1 and 2, (C) All, (D) 2 and 3, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Consider the following statements about transport-lag It is of non-minimum phase behaviour It normally exists in thermal, hydraulic and pneumatic systems It has an excessive phase lag with no attenuation at high frequency Which of the above statements are correct?
A.	1 only [Wrong Answer]
B.	1 and 2 [Wrong Answer]
C.	All [Correct Answer]
D.	2 and 3 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A series RL circuit is excited by a voltage v(t) = V_msin (ωt + Φ). The transient current will be zero if
Φ = 0
ω = 0
Φ = tan^-1 (ωL/R)
ω - tan^-1 (ωL/R) = p/2

⇒ The load circuit of a single phase full bridge inverter
must be underdamped
must be overdamped
may be underdamped or overdamped
may be any type of load

⇒

Assertion (A): For a reciprocal microwave junction the S matrix is symmetrical.

Reason (R): In a symmetrical matrix S_ij = S_ji.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): For same drain current rating N-channel MOSFET occupies more area than p-channel MOSFET.

Reason (R): Electron mobility is much higher than hole mobility.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): A video monitor does not need RF tuner and IF amplifier

Reason (R): The picture tube in TV is basically a CRT.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following devices uses a helix?
Klystron amplifier
Klystron oscillator
TWT
Both (a) and (b)

⇒ In a monolithic IC, resistors are formed from
ceramic material
manganin wire
P-type semiconductor
aluminium ribbon

⇒ Varactor diodes use
silicon
GaAs
either (a) or (b)
neither (a) nor (b)

⇒ The magnetic field due to current I equals
I/2 pr
I/4 pr
I²/2 pr
I²/4 pr

⇒ If A = 131 ± 4 and B = 106 ± 4, the percentage range of doubt in A - B is
0.04
0.08
0.16
0.32

⇒ A Colpitt's oscillator uses
a tapped inductor
an inductor and two capacitors
both (a) and (b)
either (a) or (b)

⇒ If the ratio p(s)/q(s) represents a transfer function then
the degree of p(s) may be as small as zero, independent of degree of q(s)
the degree of p(s) and q(s) must be equal
the degrees of p(s) and q(s) must not be equal
the degrees p(s) and q(s) must differ by at least two

⇒ Which of following antenna does not depend upon the frequency?
Log-periodic
Parabolic
Conical
All of the above

⇒

Assertion (A): BCD code is used in pocket calculators

Reason (R): BCD code is slower than binary.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A ripple counter has propagation delay.
TRUE
FALSE

⇒ If figure, power dissipated in 30Ω resistance will be maximum when value of
30 Ω
16 Ω
9 Ω
zero

⇒ If V = 20 + j20, then log_e(A) A is
3.342 + j 45
28.28 ∠45°
400 ∠45°
3.342 + j 0.785

⇒ The open loop gain of an amplifier is 200. If negative feedback with β = 0.2 is used, the closed loop gain will be
200
40.12
4.878
2.2

⇒ A universal shift register can shift left or right.
TRUE
FALSE

⇒ To study electromagnetic radiations from astronomical objects, radio astronomers use
low frequencies
medium frequencies
microwaves
either (a) or (b)

⇒ Which of the following can be used to isolate a low impedance from a high impedance source?
Emitter follower
p filter
Darlington pair
Any of the above

⇒

Assertion (A): In Darlington pair, the overall β is product of individual β_s

Reason (R): The voltage gain of a base driven amplifier is equal to ac collector voltage divided by ac base voltage

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A 400 W carrier is amplitude modulated with m = 0.75. The total power in AM is
400 W
512 W
588 W
650 W

⇒ The binary number 0.10110111101 is equal to hexadecimal number
B3A
B5A
B7A
BA7

⇒

Match the following:

	List I		List II
A.	Servomotor	1.	Error detector
B.	Amplidyne	2.	Transducer
C.	Potentiometer	3.	Actuator
D.	Flapper valve	4.	Power amplifier

A-3, B-1, C-2, D-4
A-4, B-3, C-2, D-1
A-3, B-4, C-1, D-2
A-3, B-4, C-2, D-1

⇒ Consider an input x(t) as sh
-2 < t < 6
0 < t < 11
-2 < t < 5
2 < t < 6

⇒ Which of the following can be used as a tachogenerator in control systems?
Microsyn
DC servomotor
AC servomotor
Magnetic amplifier

⇒ If B = 4 + j3, (B)^1/3 =
2 ∠30°
2 ∠36.87°
1.71 ∠12.3°
1.71 ∠30°

⇒ The function off an oxide layer in an IC device is to

mask against diffusion or ion implantation
insulate the surface electrically
increase the melting point of Si
produce a chemically stable protective layer

1, 2, 3
1, 3, 4
2, 3, 4
4, 1, 2

⇒ Expression ++i is equivalent to
i = i + 2
i = i + 1
i = i - 1
i = i + i + i