Question is ⇒ Consider the following statements about constants in 8085 <ol style="list-style-type: decimal; padding-bottom:10px;"><li style="padding-top:10px;">The assembler treats 64 H as hexadecimal constant.</li><li style="padding-top:10px;">The assembler treats 154 as binary constant.</li><li style="padding-top:10px;">The assembler treats 540 as octal constant.</li><li style="padding-top:10px;">The assembler treats 138 as decimal constant.</li></ol> Which of the above are correct?, Options are ⇒ (A) 1, 2 and 3 only, (B) 1, 3 and 4 only, (C) 1 and 3 only, (D) 2 and 4 only, (E) , Leave your comments or Download question paper.

Question is ⇒ Consider the following statements about constants in 8085 <ol style="list-style-type: decimal; padding-bottom:10px;"><li style="padding-top:10px;">The assembler treats 64 H as hexadecimal constant.</li><li style="padding-top:10px;">The assembler treats 154 as binary constant.</li><li style="padding-top:10px;">The assembler treats 540 as octal constant.</li><li style="padding-top:10px;">The assembler treats 138 as decimal constant.</li></ol> Which of the above are correct?, Options are ⇒ (A) 1, 2 and 3 only, (B) 1, 3 and 4 only, (C) 1 and 3 only, (D) 2 and 4 only, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Consider the following statements about constants in 8085 The assembler treats 64 H as hexadecimal constant. The assembler treats 154 as binary constant. The assembler treats 540 as octal constant. The assembler treats 138 as decimal constant. Which of the above are correct?
A.	1, 2 and 3 only [Wrong Answer]
B.	1, 3 and 4 only [Correct Answer]
C.	1 and 3 only [Wrong Answer]
D.	2 and 4 only [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a certain '12 channel TDM' system it is found that channel no. 3 and channel no. 8 are connected to the same input signal. This technique
wastes the channel capacity
takes care of different sampling rate
is required when different bandwidth signals are to be transmitted
reduces noise

⇒ A uniform plane magnetic wave incident normally on a plane surface of a dielectric material is reflected and the percentage of reflected power is 75% What is VSWR?
14
1.4
15
13

⇒ The temperature below which certain materials are antiferromagnetic and above which they are paramagnetic is called
Weiss temperature
Curie temperature
Neel temperature
None of the above

⇒ In communication systems the frequency range used for voice is
15 Hz to 150 Hz
30 Hz to 1000 Hz
100 Hz to 1500 Hz
300 Hz to 3800 Hz

⇒ Decimal 8 in excess-3 code =
1000
1001
1011
1111

⇒ The coding system generally used in digital telemetry is
PPM (Pulse position modulation)
PAM (Pulse amplitude modulation)
PCM (Pulse code modulation)
PDM (Pulse duration modulation)

⇒ If r_e is ac resistance of diode, the Thevenin input impedance of a differential amplifier is
r_e
br_e
2 br_e
0.5 br_e

⇒ The EHT voltage in a picture tube of TV is
about 1000 kV
about 100 kV
about 15 kV
about 1 kV

⇒ A cycloconverter is
ac-dc converter
dc-ac converter
dc-dc converter
ac-ac converter

⇒

Assertion (A): Transient periods are of short duration but can result in dangerously high voltages and currents.

Reason (R): Circuit equations in transient analysis are integral differential equations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The temperature coefficient of a thermistor
is positive
is negative
zero
may be positive or negative depending on its composition

⇒ The use of coaxial microwave line should be restricted to frequencies
below cut off frequency of TE₁₁ mode
above cut off frequency of TE₁₁ mode
at frequencies much lower than cut off frequency of TE₁₁ mode
at frequencies much higher than cut off frequency of TE₁₁ mode

⇒ The magnetic moment in units of Bohr magneton of a ferrous ion in any ferrite is
zero
2
4
6

⇒ Given figure shows a 90° sector of spherical reflector with vertex 'V', centre of curvature 'C' and equal distances VD, DF, FE and EC. When a beam of EM wave is incident parallel to the axis, all the energy will pass through the reg
VD
DF
EF
EC

⇒ Class A amplifiers are preferred when
minimum distortion is required
maximum voltage gain is required
output signal is desired in phase with input signal
signal having A.C. superimposed on D.C. are to be amplified

⇒ Gold is often diffused into silicon P-N junction devices to
increase recombination rate
reduce recombination rate
make silicon a direct gap semiconductor
make silicon semimetal

⇒ PWM can be generated
by a free running multivibrator
by integrating the signal
by a monostable multivibrator
by differentiating pulse position modulation

⇒ MF is generally used for
telegraphy
radio and television links
satellite communication
broadcasting, navigation

⇒ In a three cavity klystron amplifier, the oscillations are excited in
input cavity
output cavity
intermediate cavity
both (a) and (b)

⇒ In the amplifier circuit of figure h_fe = 100 and h_ie = 1000 Ω. The voltage gain of amplifier is a
0.33
0.5
0.66
1

⇒ The velocity factor of a transmission line
mainly depends on the skin effect
is always higher for a solid dielectric than for air
mainly depends on the dielectric constant of the material used
increases the velocity along the transmission line

⇒ A vertical wire of 1 meter length carries a current of 1 A at 10 MHz. The total radiated power is nearly
0.13 W
0.88 W
7.3 W
73 W

⇒ A practical Parallel resonant circuit has a coil in Parallel with a 0.14 μf capacitor. The coil has an inductance of 1 mH and a resistance of 10 ohms. The Q of the circuit is
1000
100
10
1

⇒ In the following transistor circuit V_BE = 0. 7 V, r_c = 25mV/I_E, and β and the capacitance are very l
1 mA
2 mA
5 mA
10 mA

⇒ Which one of the following statements regarding DSI is wrong?
It is a digital form of TASI
Though it is more efficient than TASI, it is much slower
A speaker has to wait (it at all) for only a few milliseconds for reallocation of channel
It has increased the capacity of satellite channels by a factor of 2.2 or more with out degrading speech quality

⇒ A permanent magnet moving coil measures
true rms value
dc value
peak value
rms plus dc value

⇒ Ripple factor RF and form factor FF are related as
RF = FF² - 1
RF = (FF² - 1)^0.5
RF = FF - 1
RF = (FF - 1)^0.5

⇒ Consider a control system shown in given figure. For slight variation in G, the ratio of open loop sensitivity to closed loop sensitivity will be give
1 : (1 + GH)
1 : (1 + GH)^{- 1}
1 : (1 - GH)
1 : (1 - GH)^{- 1}

⇒ For a standard 2nd order system the maximum overshoot is 10% to an unit step input. If the magnitude of the input is doubled, then maximum overshoot and percentage of maximum overshoot is:
maximum overshoot doubles and percentage of maximum overshoot is less than double
maximum overshoot doubles and percentage of maximum overshoot do not change
maximum overshoot remain same and percentage of maximum overshoot is double
maximum overshoot more than double and percentage of maximum overshoot is less than double

⇒ Which one of the systems described by the following I/P - O/P relations is time invariant
y(n) = n x(n)
y(n) = x(n) - x(n - 1)
y(n) = x(- n)
y(n) = x(n) cos 2pf₀n