Question is ⇒ Consider the following statement in FORTRAN 77 <c, Options are ⇒ (A) 2 values could be read and stored asX (0), Y (0), (B) 4 values could be read and stored asX (0), Y (0), X (2), Y (2), (C) 6 values could be read and stored as X (0), Y (0), Y (2), X (3), Y (3), (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Consider the following statement in FORTRAN 77 <c, Options are ⇒ (A) 2 values could be read and stored asX (0), Y (0), (B) 4 values could be read and stored asX (0), Y (0), X (2), Y (2), (C) 6 values could be read and stored as X (0), Y (0), Y (2), X (3), Y (3), (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Consider the following statement in FORTRAN 77
A.	2 values could be read and stored asX (0), Y (0) [Wrong Answer]
B.	4 values could be read and stored asX (0), Y (0), X (2), Y (2) [Correct Answer]
C.	6 values could be read and stored as X (0), Y (0), Y (2), X (3), Y (3) [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The V-i relation for a varistor is
i = kvⁿ
v = kiⁿ
i = kv³
v = ki³

⇒ The name field effect is related to the __________ layers of a JFET.
depletion
drain
source
gate

⇒ Which is a digital coding technique?
PCM
DM
DPCM
All

⇒ Frequency shift keying is used mostly in
telephony
telegraphy
radio transmission
none of the above

⇒ In figure I_D = 4 mA. Then V_{GS4.4 V
-4.4 V
0.44 V
-0.44 V}

⇒ A sinusoidal ac voltage of amplitude 100 V is applied to a rectifying device which offers 10 Ω resistance in forward direction and infinite resistance in reverse direction. The reading on hot wire ammeter will be
0.416666666666667
0.208333333333333
3.185 A
1.414 A

⇒ In 8085 microprocessor system, can an input and output port have same port address?
Yes
No
Insufficient data
None of these

⇒

Assertion (A): A coaxial line is a non-radiating line.

Reason (R): In a coaxial line the electric and magnetic fields are confined to the region between the concentric conductors.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ If a transistor is operating with both of its Junctions forward biased, but with the collector base forward biased, but with the collector base forward bias greater than the emitter-base forward bias, then it is operating in the
forward active mode
reverse saturation mode
reverse active mode
forward saturation mode

⇒ The units for apparent power are watts.
TRUE
FALSE

⇒ Poynting theorem relates the electric intensity E, magnetic intensity H to the rate of energy flow per unit area at a point P as
P = E/H
P = H/E
E = 1/E x H
P = E x H

⇒ Graphic equaliser system in stereophonic systems generally have
3 or 4 bands
1 band
more than 8 bands
large number of bands

⇒ At room temperature, a possible value for the mobility of electrons in the inversion layer of a silicon n-channel MOSFET is
450 cm²/V-s
1350 cm²/V-s
1800 cm²/V-s
3600 cm²/V-s

⇒ Which rectifier has the best ratio of rectification?
Half wave rectifier
Full wave rectifier
Bridge rectifier
Three phase full wave rectifier

⇒ When the channel is noisy, producing a conditional probability of error p = 0.5; the channel capacity and entropy function would be, respectively,
1 and 1
1 and 0.5
0.5 and 1
0 and 1

⇒ If V_A = - 10 V and V_B = - 15 V, VAB = 5 V.
TRUE
FALSE

⇒ In a pulsed RADAR typical value of pulse duration and pulse frequency respectively are
1 μs and 50 Hz
1 μs and 500 Hz
4 μs and 50 Hz
4 μs and 500 Hz

⇒ The most widely used LC oscillator is
Hartley oscillator
Crystal oscillator
Colpitt's oscillator
Clapp's oscillator

⇒ The start of modern computer age was started by the event
development of disc drive
development of transistor
development of Hollerith code
design of EVIAC computer

⇒ The chip 8257 is a
programmable interrupt controller
programmable DMA controller
programmable peripheral interface
none of the above

⇒ An incremental model of a solid state device is one which represents the
ac property of the device at desired operating point
dc property of the device at all operating points
complete ac and dc behaviour at all operating points
ac property of the device at all operating points

⇒ Which of the following is not a non-linear element?
Transistor
Heater coil
Diode
Electric arc with unlike electrodes

⇒

Match the following:

	List I		List II
A.	Detection of a periodic signal in noise	1.	Increase in band-width
B.	Recovery of a band limited signal from its uniformly sampled values	2.	Slope over load error
C.	Finer quantization	3.	Nyquist rate of signals
D.	Delta modulation	4.	Cross correlation

A-4, B-3, C-1, D-2
A-3, B-2, C-1, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-4, D-1

⇒ If in a radio receiver, RF signal has a frequency of 800 kHz and local oscillator that of 1000 kHz, then at the output of the mixer, the frequencies found would be __________ kHz.
800 to 1000
200, 800, 1000, 1800
only 200
only 1800

⇒ For a quadratic factor in transfer function the phase angle is not a function of damping factor.
TRUE
FALSE

⇒ The transistor of following figure in Si diode with a base current of 40 μA and I_CBO = 0, if V_BB = 6V, R_E = 2 kΩ and β = 90, I_BQ = 20 μA then R_{B200 kΩ
265 kΩ
150 kΩ
100 kΩ}

⇒ A 2 bit BCD D/A converter is a weighted resistor type with E_R = 1V, R = 1 MΩ and R_f = 10KΩ then Resolution in percent and volt is __________ .
1%, 1 mv
10%, 10 mv
10%, 1 mv
1%, 10 mv

⇒ The current flowing through the resistance R in the circuit in the figure has the form 2 cos 4t, where
(0.18 + j0.72)
(0.46 + j1.90)
- (0.18 + j1.90)
(0.23 - 0.35 j)

⇒ In a junction transistor, the collector cut-off current 'I_CB0' reduces considerably by doping the
emitter with high level of impurity
emitter with low level of impurity
collector with high level of impurity
collector with low level of impurity

⇒ Consider the following statements

An assembler is a program having assembly language program as input and machine language program as output.
A macro assembler is an assembler with additional macro facilities.
A cross assembler for a μP X is an assembler which executes on source microcomputer with a different CPU than X bit generates code for X.
Assemblers generally do not provide macro facilities.

Of the above statement
All are correct
only 1, 2, 3 are correct
only 1, 2, 4 are correct
only 1, 3, 4 are correct