Question is ⇒ Consider the following statement in B, Options are ⇒ (A) 200, 250, 150 respectively, (B) 150, 200, 250 respectively, (C) 250, 200, 150 respectively, (D) 200, 150, 250 respectively, (E) , Leave your comments or Download question paper.

Question is ⇒ Consider the following statement in B, Options are ⇒ (A) 200, 250, 150 respectively, (B) 150, 200, 250 respectively, (C) 250, 200, 150 respectively, (D) 200, 150, 250 respectively, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Consider the following statement in B
A.	200, 250, 150 respectively [Correct Answer]
B.	150, 200, 250 respectively [Wrong Answer]
C.	250, 200, 150 respectively [Wrong Answer]
D.	200, 150, 250 respectively [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The integral of a unit step function is
a unit impulse function
a unit pulse function
a ramp function of slope 1
none of the above

⇒ The shape of torque-speed curve of a two phase servo- motor mostly depends on
ratio of rotor reactance to rotor resistance
ratio of stator reactance to rotor resistance
ratio of rotor reactance to rotor resistance and also the ratio of stator reactance to stator resistance
magnitude of stator voltages

⇒ A voltage v = 100 sin (100 pt + 45°) V is applied to an impedance 10 + j10 ohm. The current is
10 ∠45° A
7.07 ∠45° A
5 ∠45° A
5 ∠0 A

⇒ In a certain '12 channel TDM' system it is found that channel no. 3 and channel no. 8 are connected to the same input signal. This technique
wastes the channel capacity
takes care of different sampling rate
is required when different bandwidth signals are to be transmitted
reduces noise

⇒ The open loop gain of an actual op-amp is about 100.
TRUE
FALSE

⇒ For a half wave rectified voltage, the form factor and peak factor respectively are
1.11 and 2
1.57 and 2
1.11 and 1.11
1.57 and 2

⇒ Which of the following is not valid in case of bipolars?
It has a low input impedance
It has high voltage gain
It is a current controlled device
It is difficult to bias

⇒ For measurement of high voltage capacitors the suitable bridge is
Wien bridge
modified De Sauty bridge
Schering bridge
either (a) or (b)

⇒ In Pascal if I = 55, 10 * I div 10 =
55
50
5.5
5

⇒ Which of the following cannot be used to demodulate SSB?
Complete phase shift generator
Product detector
Diode balanced modulator
Bipolar transistor balanced modulator

⇒ Two network said to be dual to each other
if mesh equation of one is same to other of node equation
if mesh equation of both is same
if node equation of both is same
neither mesh equation nor node equation is same

⇒ In a semiconductor avalanche breakdown occurs when
reverse bias exceeds the limiting value
forward bias exceeds the limiting value
forward current exceeds the limiting value
potential barrier is reduced to zero

⇒ Examine the following statements

Pneumatic systems are fire proof.
Pneumatic systems are explosion proof.
Hydraulic systems are explosion proof.
Hydraulic systems are fire proof.

Which of the above statements are correct?
1 only
1 and 2 only
1 2, 3, 4
2, 3, 4 only

⇒ Poles and zeros of a driving point function of a network are simple and alternate on jω axis. The network consists of
R and C
L and C
R and L
R, L and C

⇒ Transfer function of a certain system
2 sec
4 sec
6 sec
8 sec

⇒ Which of the following will be hexadecimal number just for prior to F52B?
E 51 A
F 51 B
E 52 B
F 52 A

⇒ Class C amplifier is suitable for
a narrow frequency band
a wide frequency band
audio frequencies
either (b) or (c)

⇒ The compensator in the given figure
lag compensator
lead compensator
lag-lead compensator
none of the above

⇒ Nichols chart consists of M and N locii in log magnitude versus phase diagram.
TRUE
FALSE

⇒ In a conductor the conduction and valence bands overlap
TRUE
FALSE

⇒ If the atomic number of germanium is 32, the number of electrons in the outer most shell will be
2
3
4
6

⇒ BCD number 1100111 = __________ ₁₀
66
67
68
69

⇒ A series RLC circuit has a resonance frequency of 1 kHz and a quality factor Q = 100. If each of R, L and C is doubled from its original value, the new Q of the circuit is
25
50
100
200

⇒ In a microprocessor
one machine cycle is equal to one clock cycle
one clock cycle consists of several machine cycles
one machine cycle consists of several clock cycles
one machine cycle is always less than one clock cycle

⇒ In cellphone communication base antennas are connected to other base antennas in
line of sight communication
ionospheric propagation
ground wave propagation
medium wave propagation

⇒ A pulse train can be delayed by a finite number of clock periods by using
serial in-serial out shift register
parallel in serial out shift register
serial in-parallel out shift register
parallel in parallel out shift register

⇒ In a system an input resistance of 20 kΩ causes a noise voltage of 15μV. If two such input resistances each of 20 kΩ are used in parallel, the total noise voltage will be about
15 μV
30 μV
7.5 μV
10.6 μV

⇒ Which of the following statements regarding two transistor model of p-n-n-p device is correct?
It explain only the turn on portion of the device characteristics
It explain only the turn off portion of the device characteristics
It explain only the negative region portion of the device characteristics
It explain all the regions of the device characteristics

⇒ A sawtooth current wave is passed through a resistance
the waveshapes of voltages across resistance and power will also the sawtooth
the waveshape of voltage across resistance will be sawtooth
the waveshape of power will be sawtooth
neither the voltage waveshape nor power wave-shape will be sawtooth

⇒

Match the following:

	List I (Octal)		List II (Hexadecimal)
A.	66	1.	3 F
B.	77	2.	36
C.	55	3.	27
D.	47	4.	3D

A-1, B-3, C-2, D-4
A-2, B-1, C-4, D-3
A-3, B-1, C-2, D-4
A-4, B-1, C-2, D-3