Question is ⇒ Consider the following instruments <ol style="list-style-type: decimal; padding-bottom:10px;"><li style="padding-top:10px;">Tangent galvanometer</li><li style="padding-top:10px;">Rayleigh current balance</li><li style="padding-top:10px;">Household energy meter</li><li style="padding-top:10px;">Hot wire ammeter</li></ol> Out of above absolute instruments are, Options are ⇒ (A) 1, 2 and 3, (B) 1, 2 and 4, (C) 1 and 2, (D) 2, 3 and 4, (E) , Leave your comments or Download question paper.

Question is ⇒ Consider the following instruments <ol style="list-style-type: decimal; padding-bottom:10px;"><li style="padding-top:10px;">Tangent galvanometer</li><li style="padding-top:10px;">Rayleigh current balance</li><li style="padding-top:10px;">Household energy meter</li><li style="padding-top:10px;">Hot wire ammeter</li></ol> Out of above absolute instruments are, Options are ⇒ (A) 1, 2 and 3, (B) 1, 2 and 4, (C) 1 and 2, (D) 2, 3 and 4, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Consider the following instruments Tangent galvanometer Rayleigh current balance Household energy meter Hot wire ammeter Out of above absolute instruments are
A.	1, 2 and 3 [Wrong Answer]
B.	1, 2 and 4 [Wrong Answer]
C.	1 and 2 [Correct Answer]
D.	2, 3 and 4 [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The pole zero plot of the given figure is
non-minimum phase function
minimum phase function
all pass function
either (b) or (c)

⇒ Noise can be measured by
D.C. voltmeter
A.C. voltmeter
either of the above
none of the above

⇒ 39.12₁₀ = __________ ₁₀
10111.0001111
100011.0001111
100001.0001111
1111.0001111

⇒ Special circuits using neon tubes, contact relays and capacitors are used in many domestic appliances. The role of capacitor in figure i
reduce power loss
function as resistor when relay is on
delay the operation of the contact relay after switching on
open circuit the relay terminals

⇒ A rectangular waveguide of internal dimensions (a = 4 cm and b = 3) is to be operated in TE₁₁ mode. The minimum operating frequency is
6.25 GHz
6.0 GHz
5.0 GHz
3.75 GHz

⇒ A duplexer is used to
couple two antennas to a transmitter
isolate the antenna from the local oscillator
prevent interference between two antennas connected to receiver
use an antenna for reception or transmission without interference

⇒ If the inputs to a 3 bit binary adder are 111₂ and 111₂, the output will be 110₂
TRUE
FALSE

⇒ A transistor will operate in inverted region when
emitter junction is forward biased and collector junction is reverse biased
emitter junction is reverse biased and collector junction is forward biased
emitter junction as well as collector junction are forward biased
emitter junction as well as collector junction are reverse biased

⇒ Which of the following is not correct in C?
6 / 4 = 1
2 / 5 = 0
2.0 / 5 = 0
2.0 / 5.0 = 0.4

⇒ Good frequency stability can be available
crystal oscillators
Hartley oscillators
colpitts oscillators
none of the above

⇒ In the following figure C = 0.02 μF, and V_th is known to be of frequency ω = 10⁷ rad/sec and r_d = 2.5 Ω and Z_Th = R_Th = 10 Ω Then phase angle between i_d and V_{d26.5°
25°
30°
0°}

⇒ Which of the following couplings may cause unwanted clamping?
Resistive
Inductive
Capacitive
Both (a) or (b)

⇒ In figure, the time constant for the capacitor chargin
6 μs
10 μs
15 μs
25 μs

⇒ A 2 bit binary multiplier can be implemented using
2 inputs ANDs only
2 I/P XOR and 4 I/P AND gate only
two 2 inputs NORs and One XNOR gate
XOR gates and shift registers

⇒ In a radio receiver the input from local oscillator is fed to
RF amplifier
mixer
IF amplifier
detector

⇒ An SCR is triggered at 80° in the positive half cycle, only. The rms anode current is 25 A. If the firing angle is changed to 160°, the rms current is likely to be
25 A
12.5 A
less than 25 A
less than 12.5 A

⇒ The input impedance for folded dipole antenna (two half dipole) is
73 n²
377 n²
73 n
377 n

⇒ LCD uses
nematic crystals
sematic crystals
cholesteric crystals
twisted nematic crystal

⇒ A(A + B) =
A
A B
AB
AB

⇒ Which one of the following is correct? Energy of a power signal is
finite
zero
infinite
between 1 and 2

⇒ The amplitude of a pair of composite sinusoidal signal y(n) = x₁(n) + x₂(n) with x₁(n) = sin (5pn) x₂(n) = 3 sin (5pn) is __________ .
2
3
4
1

⇒ Which of the following pairs of semiconductors and current carriers is correctly matched?
Intrinsic : number of electrons = number of holes
P type : number of electrons > number of holes
N type : number of electrons < number of holes
Bulk : neither electrons nor holes

⇒ For a photoconductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in intensity of optical illumination results in
a change in o.c voltage
a change in s.c current
decrease in resistance
increase in resistance

⇒ - 56 is not a valid real constant in Fortran.
TRUE
FALSE

⇒ A source is delivering maximum power to a resistance through a network. The ratio of power delivered to the source power,
is always 0.5
may be 0.54 or less
may be 0.5 or less
may be 0.5 or more

⇒ A variable reluctance type tachometer has 150 teeth on rotor. The counter records 13500 pulse/sec. The rotational speed is
4800 RPM
5400 RPM
6000 RPM
7200 RPM

⇒ For measuring a very high resistance we should use
Kelvin's double bridge
Wheatstone bridge
Meggar
Either (a) or (c)

⇒ Two infinitely long wires carrying current are as shown in the figure below. One wire is in the y-z plane and parallel to the y-axis. The other wise is in the x-y plane and parallel to the x-axis. Which components of the resulting magnetic field are non-zero at the ori
x, y, z components
x, y components
y, z components
x, z components

⇒ The response to sinusoidal excitation can be found by
settings s = jω in the network function
settings s = - jω in the network function
taking inverse transform of network function
none of the above

⇒ The circuit consisting of two transistor connected in series with the d.c. supply voltage is called
push pull
differential pair
stacked V⁺
complementary symmetry