Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | Consider the following `ON GO TO` statement in Ba |

A. | 10, 20, 30, 20 respectively [Correct Answer] |

B. | 10, 20, 20, 30 respectively [Wrong Answer] |

C. | 20, 30, 20, 10 respectively [Wrong Answer] |

D. | 10, 30, 20, 20 respectively [Wrong Answer] |

View Answer
Explanation:-
Answer : ADiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ In an op-amp differentiator

the amplitude of output is proportional to rate of change of input

the amplitude of output is proportional to input

output occurs when input is finite and constant

polarity of input and output is the same

⇒ The function A

*e*where

^{st}*s*= s +

*j*ω represents

A phasor whose magnitude changes with time

A phasor whose frequency is ω

A phasor rotating in counterclockwise direction at angular frequency ω and whose magnitude increases with

*t*

A phasor rotating in clockwise direction at angular frequency ω and whose magnitude increases with

*t*

⇒ The time constant of the capacitance circuit is defined as the time during which voltage

falls to 36.8% of its final steady value

rises to 38.6% of its final steady value

rises to 63.2% of its final steady value.

none of the above.

⇒ In a tape recorder

the width of air gaps of record and erase heads is almost equal

the air gap of record head is wider than the air gap of erase head

the air gap of erase head is wider than the air gap of record head

any of the two air gaps can be wider than the other

⇒ Which of the following are universal gates?

- NAND
- NOR
- XOR

1 and 2 only

1 and 3 only

2 and 3 only

1, 2 and 3

⇒ For exponential function

*e*

^{-at}the Laplace transform 1/(

*s*-

*a*)

TRUE

FALSE

⇒ SSB can be generated by

filter method

phase shift method

weaver's method

none of the above

⇒ A semiconverter feeding an RLE load operates in

first quadrant only

first and second quadrants

first and fourth quadrants

first and third quadrants

⇒ The bandwidth of DSB suppressed carrier modulation system when the modulating frequency varies between 500 Hz and 5 kHz is

555 kHz

505 kHz

500 kHz

9 kHz

⇒ Astable multivibrator has

one stable state

two stable state

two quasi-stable states

one quasi stable state

⇒ Kirchoff's laws are applicable to

steady state conditions only

transient conditions only

both steady state and transient condition

both steady state and transient condition but with some constraints

⇒ A network has two sources of different frequencies. The only method of analysis which can be used to find current and voltages of different branches is the use of

Kirchoff's laws

Superposition theorem

Thevenin's theorem

Tellegen's theorem

⇒ The bridge is balanced when the value of R is

50 Ω

100 Ω

200 Ω

250 Ω

⇒ Radiation resistance of an antenna is a

dc resistance

ac resistance

either (a) or (b)

none of the above

⇒ Under low level injection assumption, the infected minority carrier current for an extrinsic semiconductor is essentially the

diffusion current

drift current

recombination current

induced current

⇒ Which data transfer scheme is used when large block of data is to be transferred in a computer?

DMA

Programmed data transfer

Either (a) or (b)

Neither (a) nor (b)

⇒ Choose correct option for a stable system :

- Roots of the characteristic equation of the system are real and negative
- Area within the impulse response is finite

I is true, II is true

I is true, II is false

I is false, II is true

I is false, II is false

⇒ An instruction used to set the carry flag in a computer can be classified as

data transfer

arithmetic

Logical

program control

⇒ Fourier transform F(

*j*ω) of an arbitrary signal has the property

F(

*j*ω) = F(-

*j*ω)

F(

*j*ω) = - F(-

*j*ω)

F(

*j*ω) = F*(-

*j*ω)

F(

*j*ω) = - F*(

*j*ω)

⇒ In which computer language is 'break' statement used

Fortran 77

Pascal

C

none of the above

⇒ For the two port of figure,

*z*

_{2226/7 Ω6/7 Ω2/3 Ω1 Ω}

⇒ A synchro transmitter receiver unit is a

two phase ac device

3 phase ac device

dc device

1 phase ac device

⇒ Zero bias works only with

D MOSFETs

E MOSFETs

both D and E MOSFETs

neither D nor E MOSFETs

⇒ If the iron core of a coil is removed so that it becomes an air cored coil, its inductance

will increase

will decrease

will remain the same

may increase or decrease

⇒ The voltage gain of an amplifier without and with feedback are 100 and 20. The negative feedback is

0.04

0.05

0.2

0.8

⇒ Which of the following statement is correct?

The input impedance of CE amplifier is usually around 10 Ω

The voltage gain of a transistor amplifier in CE mode is always less than unity

The output impedance of a transistor amplifier is independent of the transistor configuration

The voltage gain of a transistor amplifier is independent of the load resistance

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after ADI A4H?

4 AH, 0

4 AH, 1

4 BH, 0

4 BH, 1

⇒ The orbital period of a geostationary communication satellite is

12 hours

24 hours

36 hours

48 hours

⇒ A microcomputer has memory locations from 0000 to FFFF, each storing 1 byte. How many bytes can be the memory store?

12333

14666

16384

16655

⇒ In a circuit containing a complex impedance, maximum power transfer takes place when load is

pure resistance

equal to the complex impedance

conjugate complex of the circuit impedance

none of the above