Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | Consider the following circuits. Assume all gates to have finite propagation d |

A. | (1) only [Wrong Answer] |

B. | (1) and (2) only [Wrong Answer] |

C. | (2) (3) and (4) only [Correct Answer] |

D. | All (1) (2) (3) and (4) [Wrong Answer] |

View Answer
Explanation:-
Answer : CDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ In the given figure, if R = X

*, voltage gai*

_{C}0 dB

3 dB

-3 dB

20 dB

⇒ A hexadecimal odometer displays F52F. The next reading will be

E 52 F

E 52 E

E 53 F

F 53 O

⇒ Fourier series is applicable for

periodic

finite duration

non periodic

a and b

⇒ A buffer is a device that isolates other devices. Typically a buffer has

a high input impedance and a low output impedance

a high input impedance as well as output impedance

a low input impedance and a high output impedance

a low input impedance as well as output impedance

⇒ A 4 bit parallel type A/D converter uses a 6 volt reference. How many comparators are required and what is the resolution in volts?

0.375 V

15 V

4.5 V

10 V

⇒ For the circuit shown in the figure, what is the frequency of the outpu

Twice the input clock frequency

Half the input clock frequency

Same as input clock frequency

Inverse of the propagation delay of the FF

⇒ The range of value "

*a*" for which system will be stable. If impulse response of DT system is =

*a*

*∪[*

^{n}*n*]

*a*> 1

*a*< 1

1 <

*a*< ∞

-1 <

*a*< 1

⇒ If

*f*(-

*t*) =

*f*(

*t*), the function

*f*(

*t*) has only cosine terms.

TRUE

FALSE

⇒

`LPEPSI`

3

9

13

23

⇒ A sinusoidal voltage has peak to peak value of 100 V. The rms value is

50 V

70.7 V

35.35 V

141.41 V

⇒ The open loop gain of an amplifier is 200. If negative feedback with β = 0.2 is used, the closed loop gain will be

200

40.12

4.878

2.2

⇒ Which of the following laws of electromagnetic theory is associated with the force experienced by two loops of a wire carrying currents?

Maxwell's law

Coulomb's law

Ampere's law

Laplace's law

⇒ The problem of current lagging is associated with

DCTL gates

DTL gates

ECL gates

CMOS gates

⇒ Consider the following statements Timer 555 can be used as - monostable multivibrator
- bistable multivibrator
- astable multivibrator

Which of the above statements are correct?

1 and 2

1 and 3

2 and 3

1, 2, 3

⇒ The current *i*(*t*) through a 10 Ω resistor in series with an inductance is given by *i*(*t*) = 3 + 4 sin (100*t* + 45°) + 4 sin (300*t* + 60°) Amperes. The RMS value of the current and the power dissipated in the circuit are

41 A, 410 W respectively

35 A, 350 W respectively

5 A, 250 W respectively

11 A, 1210 W respectively

⇒ The efficiency of a direct radiating cone type loudspeaker is about

0.05

0.2

0.5

0.8

⇒ In standard TTL, the 'totem pole' stage refers to

the multi-emitter I/P stage

phase splitter

the O/P buffer

open collector O/P stage

⇒ In direct addressing mode of 8085

All instructions are 3 bytes long

All instructions are 3 bytes long except IN instruction which is 2 bytes long

All instructions are 3 bytes long except IN and OUT instructions which are 2 bytes long

All instructions are 2 bytes long

⇒ Which of the following algorithms design techniques is used in quick sort algorithm?

Dynamic programming

Backtracking

Divide and conquer

Greedy

⇒ The current due to thermionic emission is given by Richardson Dushman equation.

TRUE

FALSE

⇒ The minimum gate source voltage that creates the *n*-type inversion layer is called

cut off voltage

on voltage

threshold voltage

zener voltage

⇒ It is desired to reduce the reflection at an air porcelain by use of 7/4 plate (for Porcelain μ = 40, and ε_{r} = 7). The thickness of the polystyrene plate required at 10 GHz will be

5.039 cm

50.39 cm

0.5039 cm

0.05039 cm

⇒ **Assertion (A):** SSB and ISB receivers have good S/N ratio

**Reason (R):** SSB and ISB receivers have good suppression of adjacent channels.

Both A and R are correct and R is correct explanation of A

Both A and R are correct but R is not correct explanation of A

A is correct but R is wrong

A is wrong but R is correct

⇒ **Assertion (A):** Transient periods are of short duration but can result in dangerously high voltages and currents.

**Reason (R):** Circuit equations in transient analysis are integral differential equations.

Both A and R are correct and R is correct explanation of A

Both A and R are correct but R is not correct explanation of A

A is true, R is false

A is false, R is true

⇒ The Boolean function A + BC is reduced form of

AB + BC

AB + ABC

(A + B) (A + C)

(A + C)B

⇒ An AC source or RMS voltage 20V with internal impedance Z_{s} = (1 + 2*j*) Ω feeds a load of impedance Z_{L} = (7 + 4*j*) Ω in the figure below. The reactive power consumed by the loa

8 VAR

16 VAR

28 VAR

32 VAR

⇒ Which of the following components is essential for a voltage multiplier circuit?

Resistor

Inductor

Capacitor

Both (a) and (c)

⇒ Which of the following sampling frequencies is considered adequate in voice telephony?

4 kHz

8 kHz

16 kHz

32 kHz

⇒ In a communication system, a process in which statistical averages and time averages are equal is called as,

stationary

ergodic

Gaussian

BIBO stable

⇒ Which of the following theorems can be conveniently used to find power consumed in 10 Ω resistor in fig

Thevenin theorem

Maximum power transfer theorem

Millman's theorem

Superposition theorem

```
```

```
```

```
```

```
```