Question is ⇒ Consider the following BJT circ, Options are ⇒ (A) 2.46 kΩ, (B) 2.88 kΩ, (C) 200 Ω, (D) 18.48 Ω, (E) , Leave your comments or Download question paper.

Question is ⇒ Consider the following BJT circ, Options are ⇒ (A) 2.46 kΩ, (B) 2.88 kΩ, (C) 200 Ω, (D) 18.48 Ω, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Consider the following BJT circ
A.	2.46 kΩ [Correct Answer]
B.	2.88 kΩ [Wrong Answer]
C.	200 Ω [Wrong Answer]
D.	18.48 Ω [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The given figure shows a constant current source driving a parallel RC circuit. It is equivalen
a lag network
a lead network
a lag-lead network
either (a) or (b)

⇒ The most noise resistant modulation system is
PCM
SSB suppressed carrier
FM
pulse position modulation

⇒ The amount of dielectric heating is inversely proportional to frequency.
TRUE
FALSE

⇒ Which of the following noise does not occur in transistors?
Partition noise
Shot noise
Flicker noise
Resistance noise

⇒

Assertion (A): In liquids and glassy substances, dielectric losses occur.

Reason (R): The orientation polarization in many substances is frequency dependent.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a communication receiver, a squelch circuit is normally inserted
before detector
after detector
before mixer
after power amplifier

⇒ In an AM system, doubling of modulation index doubles the antenna current. The system is
single side band full carrier
vestigial side band
single side band suppressed carrier
double side band full carrier

⇒

Assertion (A): Energy meters use induction principle.

Reason (R): Induction wattmeter is less accurate than a dynamometer wattmeter.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ (SI - A)^-1 = adj(sI - A)/det (sI - A)
TRUE
FALSE

⇒ Consider the following logical IF statement in FORTRAN 77 IF (SALT - PEPPER) 13, 11, 13
IF (SALT - PEPPER) 11, 11, 13
IF (SALT - PEPPER) 11, 13, 13
IF (SALT - PEPPER) 13, 11, 11

⇒ Which of the following is the disadvantage of PDM and PPM?
It requires pulses of larger widths
More samples are needed per second
More powerful transmitter is required
None of the above

⇒ Consider the following statements

The effect of feedback is to reduce system error
Feedback increases the system gain at one frequency but reduces the system gain as another frequency
Feedback can cause an originally stable system to become unstable

Which of the above statements are correct?
1, 2, 3
1, 2
2, 3
1, 3

⇒ In a resistance strain gauge, G = 2, stress = 1050 kg/cm², R = 1000 Ω. The value of ΔR will be
2 Ω
3 Ω
4 Ω
1 Ω

⇒ At 0 K the forbidden energy gap in intrinsic semi conductor is about
10 eV
6 eV
1 eV
0.2 eV

⇒ A minimum function has
poles and zeros on imaginary axis of s plane
no poles or zeros on imaginary axis of s plane
only poles but no zeros on imaginary axis of s plane
only zeros but no poles on imaginary axis of s plane

⇒ The property not valid for basic singularity function is
it is even signal
convolution of any arbitrary function x{t) and an impulse is the original function itself.
the sum of two impulses at same location is the impulse with the strength equal to the summation of individual strengths.
none of these.

⇒ Compared to bipolar junction transistor, a JFET has
lower input impedance
high input impedance and high voltage gain
higher voltage gain
high input impedance and low voltage gain

⇒

Assertion (A): Cut-in voltage for Germanium diode is greater than that for silicon diode.

Reason (R): Germanium diode has a higher reverse saturation current than silicon diode.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Consider the following:

Si
Ge
GaAs
InP

Which of the above semiconductors should be used for making highly efficient photodiodes?
1 and 4 only
3 and 4 only
1, 3 and 4
2, 3 and 4

⇒ The mechanical system shown below has its pole(s)
- K/D
- D/K
- DK
0, - K/D

⇒ At a given probability of error, binary coherent FSK is interior to binary coherent PSK by
6 dB
3 dB
2 dB
0 dB

⇒ In a 4 bit D/A converter, the offset error is the output voltage when input digital voltage is
1111
0
either 1111 or 0000
none of the above

⇒ In the given figure, if R = X_C, voltage gai
0 dB
3 dB
-3 dB
20 dB

⇒

JCOKE
8
11
16
20



⇒ The carrier mobility in a semiconductor is 0.4 m²/Vs. Its diffusion constant at 300k will be (in m²/s).
0.43
0.16
0.04
0.01

⇒ In CE configuration, the output characteristics of a bipolar junction transistor is drawn between
I_C and V_CB
I_E and V_CB
I_C and V_CE
I_E and V_CE

⇒ A dc amplifier can operate
at zero frequency
only at low frequency
only at high frequencies
both at low and high frequencies

⇒ In C the range of real constants expressed in exponential form is
-2.3 e 37 to + 2.3 e 37
-3.4 e 38 to + 3.4 e 38
-3.4 e 37 to + 3.4 e 37
-2.3 e 38 to + 2.3 e 38

⇒ If two network is connected in series-parallel connection then
h = [h_a] + [h_b]
[a_a] + [b_b]
[Z] = [Z_a] - [Z_b]
none

⇒ In which of the following schemes are several channels interleaved and transmitted together?
TDM
FDM
group
subgroup









Users Also Read
Previous Papers
Aptitude
Reasoning
Gen.Knowledge
Speak English
English / Verbal
Online / Mock Test
Vedic Math







    
	
	




    
	StudySite.org is world's best free online study content provider, Copyright © 2024 by 
StudySite.org All Rights Reserved