Question is ⇒ Consider the following about 'arrays' in C <ol style="list-style-type: decimal; padding-bottom:10px;"><li style="padding-top:10px;">An array is a collection of similar elements.</li><li style="padding-top:10px;">An array can not have 10 numbers 5 of which are ints and 5 are floats.</li><li style="padding-top:10px;">An array can have ints and chars in the same array.</li></ol> Which of the above are correct?, Options are ⇒ (A) All, (B) 1 and 2 only, (C) 1 and 3 only, (D) 2 and 3 only, (E) , Leave your comments or Download question paper.

An array is a collection of similar elements.

An array can not have 10 numbers 5 of which are ints and 5 are floats.

An array can have ints and chars in the same array.

Which of the above are correct?, Options are ⇒ (A) All, (B) 1 and 2 only, (C) 1 and 3 only, (D) 2 and 3 only, (E) , Leave your comments or Download question paper. '/>

An array is a collection of similar elements.

An array can not have 10 numbers 5 of which are ints and 5 are floats.

An array can have ints and chars in the same array.

Which of the above are correct?, Options are ⇒ (A) All, (B) 1 and 2 only, (C) 1 and 3 only, (D) 2 and 3 only, (E) , Leave your comments or Download question paper. '/>Previous question Next question


Q1.	Consider the following about 'arrays' in C An array is a collection of similar elements. An array can not have 10 numbers 5 of which are ints and 5 are floats. An array can have ints and chars in the same array. Which of the above are correct?
A.	All [Wrong Answer]
B.	1 and 2 only [Correct Answer]
C.	1 and 3 only [Wrong Answer]
D.	2 and 3 only [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a 7 segment display the segments a, c, d, f, g are lit. The decimal number displayed will be
9
5
4
2

⇒ Consider the following program in B
2.827
28.27
282.7
2827

⇒ The output resistance of a microphone is 20 ohms. It is to feed a line of impedance 320 ohms. To ensure maximum power transfer, the turn ratio of transformer is
16
256
2
4

⇒ In a superheterodyne receiver, the IF stage has better selectivity than RF stage because
of higher frequency
of lower frequency
of high L/C ratio
of constant passband

⇒ Consider the following stateme
1 only
1 and 2
2 and 3
2 and 4

⇒ A crystal is frequently used in digital circuits for timing purpose because of its
low cost
high frequency stability
simple circuitry
ability to set frequency at desired value

⇒ In p type semiconductor, the hole concentration
is nearly equal to density of acceptor atoms
is much greater than density of acceptor atoms
is much less than density of acceptor atoms
may be equal to or more or less than density of acceptor atoms

⇒

Assertion (A): The modified ramp function of the given figure can be represented s sum of two ramp functions of the given fig
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The magnitude response of a normalised Butterworth low pass filter is
linear starting with value of unity at zero frequency and 0.707 at cut off frequency
non linear all through but with values of unity at zero frequency and 0.707 at cut off frequency
linear upto cut off frequency and nonlinear thereafter
nonlinear upto cut off frequency and linear thereafter

⇒

Match the following:

	List I (BJT amplifier)		List II (Characteristics)
A.	CE	1.	good voltage gain, good current gain
B.	CC	2.	voltage gain less than 1, high current gain
C.	CB	3.	current gain less than 1, voltage gain high

A-1, B-2, C-3
A-1, B-2, C-3
A-3, B-1, C-2
A-3, B-2, C-1

⇒ In a P-N-P transistor, electrons flow
into the transistor at the collector only
into the transistor at the base and the collector leads
out of the transistor at base and collector leads
out of the transistor at base, collector as well as emitter leads

⇒ In a dynamometer instrument, the moving coil is pressure coil.
TRUE
FALSE

⇒ A short circuited stub is preferred to an open circuited stub because an open circuited stub
is more difficult to fabricate and construct
is made of transmission line of different Z₀
is liable to radiate
is incapable of giving full range of reactance

⇒ In an FM signal, the power
increases as the modulation index increases
reduces as the modulation index increase
increases as the modulation index decreases
remains constant when the modulation index increases

⇒ An 8-bit microprocessor has 16 bit address bus A₀ - A₁₅. The processor addresses a 1-K byte memory chip as shown. The address range for the chi
(F00F)_H TO (F40E)_H
(F000)_H TO (F3FF)_H
(F100)_H TO (F4FF)_H
(F700)_H TO (FAFF)_H

⇒ Which of the following statement is false?
A stationary process is always a ergodic process
A ergodic process is always a stationary random process
It is possible to have a stationary random
None of the above

⇒ The circuit of figur
clipper, sine wave clipped at - 2 V
clamper
clamper, sine wave clamped at zero V
clipper, sine wave clipped at + 2 V

⇒ Which of the following pulse modulation is analog?
PCM
Differential PCM
PWM
Delta

⇒ Access time of a storage is the time required
to write one word into the memory
to read one word from the memory
to write one word into and to read one word from the memory
either to write one word or to read one word

⇒ Optical encoders most commonly used in control systems are
absolute encoders
secondary encoders
incremental encoders
none of the above

⇒ An insulator will conduct when the
voltage applied is more than the breakdown voltage
temperature is raised to very high level
either (a) or (b) above
none of the above

⇒ By placing an inverter between both inputs of an S-R flip-flop, the resulting flip-flop becomes
J-K flip-flop
D-flip-flop
T-flip-flop
Master salve JK flip-flop

⇒

Assertion (A): Impedance matching can be done by using stubs.

Reason (R): A double stub is used for impedance matching when frequency of signal varies.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A rare gas having N atoms/m³ is subjected to an electric field E. The electric dipole moment per unit volume is proportional to N and E.
TRUE
FALSE

⇒ An RLC series circuit has Q = 100 and ω₀ = 20 rad/sec. The bandwidth is
0.2 rad/sec
2 rad/sec
20 rad/sec
2000 rad/sec

⇒ Neutralization is used in RF amplifiers to
stop oscillation
increase bandwidth
improve selectivity
all of the above

⇒ For a transfer function H(s) = P(s)/Q(s), where P(s) and Q(s) are polynomials in s
the degrees of P(s) is always greater than degree of Q(s)
the degree of P(s) and Q(s) are equal
the degree of P(s) is independent of degree of Q(s)
the maximum difference in degrees of P(s) and Q(s) is 1

⇒ A coil is connected across a 200 V, 50 Hz supply and takes a current of 10 A. The loss in the coil is 1000 W. The impedance and resistance of the coil are
10 Ω, 8 Ω
15 Ω, 8 Ω
20 Ω, 10 Ω
30 Ω, 15 Ω

⇒ The total field developed by an antenna array at a distant point is
phasor sum of fields produced by individual antennas of the array
algebraic sum of fields produced by individual antennas of the array
either (a) or (b) depending on type of array
neither (a) nor (b)

⇒ The rotation of direction of E field of a linearly polarized wave passing through a magnetised ferric medium is called
Lorentz rotation
Faraday rotation
Steinmitz rotation
Fleming's rotation