Question is ⇒ Consider the CMOS circuit shown, where the gate voltage VG of the n-MOSEFT is increased from zero, while the gate voltage of the p-MOSFET is kept constant at 3 V. Assume that, for both transistor, the magnitude of the threshold voltage is 1 V and the product of the transconductor parameter and the (W/L) ratio, i.e. the quality μC0x(W/L), is 1mA. V-2</s, Options are ⇒ (A) Both the MOSFET are in saturation region, (B) Both the MOSFET are in triode region, (C) n-MOSFET is in triode and p-MOSFET is in saturation region, (D) n-MOSFET is in saturation and p-MOSFET is in triode region, (E) , Leave your comments or Download question paper.

Question is ⇒ Consider the CMOS circuit shown, where the gate voltage VG of the n-MOSEFT is increased from zero, while the gate voltage of the p-MOSFET is kept constant at 3 V. Assume that, for both transistor, the magnitude of the threshold voltage is 1 V and the product of the transconductor parameter and the (W/L) ratio, i.e. the quality μC0x(W/L), is 1mA. V-2</s, Options are ⇒ (A) Both the MOSFET are in saturation region, (B) Both the MOSFET are in triode region, (C) n-MOSFET is in triode and p-MOSFET is in saturation region, (D) n-MOSFET is in saturation and p-MOSFET is in triode region, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Consider the CMOS circuit shown, where the gate voltage V_G of the n-MOSEFT is increased from zero, while the gate voltage of the p-MOSFET is kept constant at 3 V. Assume that, for both transistor, the magnitude of the threshold voltage is 1 V and the product of the transconductor parameter and the (W/L) ratio, i.e. the quality μC_0x(W/L), is 1mA. V^-2
A.	Both the MOSFET are in saturation region [Correct Answer]
B.	Both the MOSFET are in triode region [Wrong Answer]
C.	n-MOSFET is in triode and p-MOSFET is in saturation region [Wrong Answer]
D.	n-MOSFET is in saturation and p-MOSFET is in triode region [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A resistor is rated at 0.75 watt, 1 kΩ. Its current rating is
1 mA
27.386 mA
1.268 mA
5.393 mA

⇒ Ferrities are particularly suited for high frequency applications because of their
low distortion
low eddy current loss
high conductivity
high mobility

⇒ Consider the following statements about transport-lag

It is of non-minimum phase behaviour
It normally exists in thermal, hydraulic and pneumatic systems
It has an excessive phase lag with no attenuation at high frequency

Which of the above statements are correct?
1 only
1 and 2
All
2 and 3

⇒ The dielectrics having only one kind of atoms are known as elemental dielectrics.
TRUE
FALSE

⇒

Assertion (A): A class C amplifier can also be used as frequency multiplier

Reason (R): When narrow current pulses drive a resonant circuit the output can be a near perfect sine wave

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Waveguides are generally used above
20 MHz
100 MHz
200 MHz
1000 MHz

⇒ Which of the following voltmeters would you use for measuring voltage across 20 kΩ resistance?
Voltmeter having a resistance of 5 kΩ
Voltmeter having a sensitivity of 1 kW/V
Voltmeter having sensitivity of 10 kW/V
None of the above

⇒ A certain transistor has a_dc of 0.98 and a collectors leakage current of 5 μA. If I_E = 1 mA, the base current will be
35 μA
25 μA
15 μA
5 μA

⇒ The factors which govern fan out of CMOS gates are
maximum permissible propagation delay
input capacitance of each load
both (a) and (b)
neither (a) nor (b)

⇒ The V MOS can handle __________ currents than a conventional MOSFET.
much lower
almost same
almost half
much larger

⇒ Consider the instructions

MOV M, B
OUT 4
LDA X

Which of the above uses IO/W cycle?
1 only
1 and 2 only
2 only
3 only

⇒ Audio amplifiers need
Bass control
Treble control
Both Bass and Treble control
Either Bass or Treble control

⇒ Figure shows the arrangement
FM
PM
AM-DSB
AM-SSB

⇒ A three stage telephone switching structure is to have 128 input and 128 output terminals. It has been found that at peak time the utilization probability is 0.1. The number of intermediate links required for non-blocking configuration is 15. If the actual number of intermediate links is 5, the probability of blocking of call is
0.01
0.005
0.002
0.001

⇒ The open collector gates in the given figure are tied together. The output
A + B + C + D
A + B + C + D
(A + B) (C + D)
AB + CD

⇒

Assertion (A): In a common source amplifier with source terminal at ac ground the voltage gain is about g_m r_d

Reason (R): A common source amplifier is a source follower circuit

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ When large amount of power is required, a push pull amplifier is designed for operation as
class A
class B
class C
class AB

⇒ Which statement is incorrect for the signal x(t) = 5 sin (2p x 10³t) sin (2p x 10⁶t)?
Upper side band frequency is 1001000
Carrier amplitude is 5
Lower sideband frequency is 990000
x(t) is DSB-SC

⇒ The total lumens emitted by a source of 1 candle are
0.4 p
4 p
2 p
8 p

⇒ The terminals of a power BJT are called
emitter, base, collector
emitter, base, drain
source, base, drain
source, base, collector

⇒ An electron (charge -e) is rotating in a circular orbit of radius R, around a proton with charge +e at a constant angular velocity ω. The orbital magnetic dipole moment is
0.5 eω R²
eω R²
2 eω R²
0.5 eω R³

⇒ An 8 bit wide 4 word sequential memory has
Eight 4 bit shift registers
Eight 8 bit shift registers
Four 8 bit shift registers
Foui 4 bit shift registers

⇒

Assertion (A): In drawing an electric circuit analogous to a mechanical circuit, spring is replaced by capacitance.

Reason (R): The behaviour of a spring and capacitor are similar.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In figure, V reads 45V. Then
10.1 A
13.3 A
16.1 A
19.4 A

⇒ Consider the differential amplifier shown in figure. (Assume β is very hi
1 MΩ
100 kΩ
15 kΩ
≈ 0

⇒ If A = 629 ± 8 and B = 131 ± 3, A - B with range of doubt is
498 ± 8
498 ± 4
498 ± 11
498 ± 13

⇒ In active filter circuits, inductances are avoided mainly because they
are always associated with some resistance
are bulky and unsuitable for miniaturisation
are non-linear in nature
saturate quickly

⇒ In the wave mechanical theory, the maximum of the charge distribution in the ground state occurs for a distance from the nucleus equal to
first Bohr radius
second Bohr radius
third Bohr radius
either first or second Bohr radius

⇒ Parallel adder is
sequential circuit
combinational circuit
either sequential or combinational circuit
none of the above

⇒

Assertion (A): A transducer needs an output measuring or display device for measuring a non electrical quantity.

Reason (R): In some transducers the output voltage is too small and needs amplification before it can be measured.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true