Question is ⇒ Compared to coaxial lines, the advantages of wave guides are, Options are ⇒ (A) higher power handling capacity, (B) lower loss per unit length, (C) cheaper and simple mechanical structure, (D) all of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Compared to coaxial lines, the advantages of wave guides are, Options are ⇒ (A) higher power handling capacity, (B) lower loss per unit length, (C) cheaper and simple mechanical structure, (D) all of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Compared to coaxial lines, the advantages of wave guides are
A.	higher power handling capacity [Wrong Answer]
B.	lower loss per unit length [Wrong Answer]
C.	cheaper and simple mechanical structure [Wrong Answer]
D.	all of the above [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In CE approximation, the upper end of d.c. load line is called the __________ point and the lower end is the __________ point.
Q, base
base, Q
saturation, cut off
cut off, saturation

⇒ A 4 bit ripple counter uses flip flops with propagation delay of 50 ns each. The maximum clock frequency which can be used is
5 MHz
10 MHz
20 MHz
25 MHz

⇒ If carrier is modulated by a digital bit stream having one of the possible phases of 0°, 90°, 180°, and 270°, then modulation is called
BPSK
QPSK
QAM
MSK

⇒ When Schrodinger equation is applied to the motion of electron in the field of protons, the physically acceptable solutions for the wave function exist for quantum number which are
2
3
4
5

⇒ Pre-emphasis and De-emphasis is done by using R-C circuit.
TRUE
FALSE

⇒ In figure the total inductance of the circui
L₁ + L₂
L₁ + L₂ - M
L₁ + L₂ - 2M
L₁ + L₂ + M

⇒ Integral error compensation changes a second order system to
first order system
third order system
fourth order system
either (a) or (b) depending on the system

⇒ In radio receivers, the value of IF is
100 kHz
225 kHz
455 kHz
850 kHz

⇒ In D-type FF, Preset (Pr) and clear (Clr) inputs are called
Synchronous
Asynchronous
Data
None

⇒ The primary colours are
blue and green
blue and red
red and green
blue, red and green

⇒ (62)₁₀ in binary system is
110000
111100
111110
111111

⇒ Mouse is a very suitable input device for computers.
TRUE
FALSE

⇒ Measurement of an unknown voltage with a dc potentiometer loses its advantage of open circuit measurement when
the primary circuit battery is changed
standardization has to be done again to compensate for drifts
voltage is larger than range of the potentiometer
range reduction by a factor of 10 is employed

⇒ Consider the following program segment written for 8085 based sys
CE
20
indeterminate
none of these

⇒ A transconductance amplifier has
high input impedance and low output impedance
low input impedance and high output impedance
high input and output impedance
low input and output impedance

⇒ A fully controlled bridge converter feeds a highly inductive load such that the load current can be assumed to be constant. The wave shape of input current is
dc
sinusoidal
rectangular
none of the above

⇒ The input and output signals for CE amplifier are always
equal
in phase
out of phase
complementary to each other

⇒ The command ^C in MS WORD
copies the text in clip board
copies the text in secondary storage device
copies the text in file
None of the above

⇒ Which of the following circuits can be used as parallel-to-series converter?
Digital counter
Decoder
Demultiplexer
Multiplexer

⇒ 0.1011₂ = __________ .
0.6875₁₀
0.6800₁₀
0.0100₁₀
0.5000₁₀

⇒ In forward active region, the operation of a BJT
both junctions are forward biased
both junctions are reverse biased
emitter base junction is forward biased and base collector junction is reverse biased
emitter base junction is reverse biased and base collector junction is reverse biased

⇒ Tellegen's theorem is applicable to
circuits with passive elements only
circuits with linear elements only
circuits with time invariant elements only
circuits with active or passive, linear or nonlinear and time invariant or time varying elements

⇒ The polarization of dielectric materials results in
production of eddy currents
creation of electric dipoles
absorption of electrons
release of high velocity protons

⇒ In figure, V_{0-1 V
2 V
+1 V
+15 V}

⇒ Which of the following is used for generating time varying wave forms?
MOSFET
PIN diode
Tunnel diode
UJT

⇒ Induction wattmeter can be used in
ac circuit only
dc circuit only
both ac and dc circuit
ac 3 phase only

⇒ In a metal the probability of a state 0.1 eV below Fermi level being occupied
is more than the probability of state 0.1 eV above Fermi level being occupied
is the same as the probability of state 0.1 eV above Fermi level being occupied
is less than the probability of state 0.1 eV above Fermi level being occupied
may be equal to or more or less than the probability of state 0.1 eV above Fermi level being occupied

⇒ Six sets of electromagnetic waves are given bel
VLF, LF, MF, HF, VHF, UHF
LF, VLF, MF, HF, VHF, VHF
LF, VLF, HF, MF, VHF, UHF
VHF, VLF, HF, MF, LF, UHF

⇒

Assertion (A): The forward dynamic resistance of p-n diode varies inversely with current.

Reason (R): The forward dynamic resistance of p-n diode varies with the operating voltage.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Two CE stages, 1 and 2 are coupled through a capacitor. V_CC is the same for both. Base resistances R_B1 and R_B2 are such that R_B1 > R_B2. Then
base currents for both stages are equal
base current of stage 1 is more than that of stage 2
base current of stage 2 is more than that of stage 1
either (b) or (c)