Question is ⇒ Common emitter transistor has, Options are ⇒ (A) high current and high voltage gain, (B) low current gain and low voltage gain, (C) high current gain and low voltage gain, (D) low current and voltage gain, (E) , Leave your comments or Download question paper.

Question is ⇒ Common emitter transistor has, Options are ⇒ (A) high current and high voltage gain, (B) low current gain and low voltage gain, (C) high current gain and low voltage gain, (D) low current and voltage gain, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Common emitter transistor has
A.	high current and high voltage gain [Correct Answer]
B.	low current gain and low voltage gain [Wrong Answer]
C.	high current gain and low voltage gain [Wrong Answer]
D.	low current and voltage gain [Wrong Answer]
View Answer 24 -9 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following draws minimum power from source?
PMMC
Electronic voltmeter
Electrostatic voltmeter
Moving iron voltmeter

⇒ The waveshape of output voltage of half bridge inverter is
sinusoidal
square
triangular
either (a) or (b)

⇒ When a diode is not conducting, its bias is
forward
zero
reverse
zero or reverse

⇒ In an n type semiconductor the fermi level is 0.35 eV below the conduction band, the concentration of donor atoms is increased to three times. The new position of Fermi level will be
0.35 eV below conduction band
about 0.32 eV below conduction band
about 0.32 eV above conduction band
about 0.1 eV below conduction band

⇒

Match the following:

	List I		List II
A.	200 MHz	1.	SHF
B.	20 GHz	2.	UHF
C.	500 kHz	3.	VHF
D.	500 MHz	4.	MF

A-3, B-1, C-4, D-2
A-3, B-2, C-4, D-1
A-3, B-4, C-1, D-2
A-3, B-4, C-2, D-1

⇒ A clipper
adds a dc component to the input signal
removes signal voltages above or below a specified value
both (a) and (b)
either (a) or (b)

⇒ Consider the following applications

Switch
Attenuator
Phase shifter
Oscillator

In which of the above can a PIN diode be used?
1 2 3 and 4
1 2 and 3 only
1 and 2 only
2, 3 and 4 only

⇒ An RC driving point impedance function has zeros at s = - 2 and s = - 5. The admissible poles are
s = 0 and s = -6
s = -1 and s = -3
s = 0 and s = -1
s = -3 and s = -4

⇒ The input impedance of op-amp circuit of figur
120 k ohm
110 k ohm
infinity
10 k ohm

⇒ Two resistances R₁ = 18.7 Ω. and R₂ = 3.624 Ω in series. The total resistance to the appropriate number of significant figures is
22.324 Ω
22.32 Ω
22.3 Ω
22 Ω

⇒ To increase Q factor of a coil, the wire should be
long
thin
thick
long and thin

⇒ A square corner reflector is used in
radio astronomy
tv broadcast
point to point communication
all of the above

⇒ If B, H and M denote flux density, field intensity and magnetisation, B = μ₀ (H + M).
TRUE
FALSE

⇒ TV receivers use flyback switched mode power supply because
it can supply many voltage outputs
it does not require a filter choke and is cheap
it has very good regulation at all loads
both (a) and (c)

⇒ In 8085 microprocessor, what is the length of Data Buffer Register?
6 bits
8 bits
12 bits
16 bits

⇒ The terms RMS and average values apply only to sine waves.
TRUE
FALSE

⇒ In a Parallel connection of circuit the bandwidth in terms of R, L, C is
B = 1/RC
B = 1/RL
B = 1/RLC
B = RLC

⇒ Fourier transform o the function f(t) = 1 is
2p δ (ω)
p δ (ω)
δ(ω)/2p
δ(ω)/p

⇒ An electromagnetic wave incident on a perfect conductor is
fully transmitted
partially transmitted
entirely reflected
none of the above

⇒ A 1 μF capacitor is connected to 12 V battery. The energy stored in the capacitor is
12 x 10^-6 J
24 x 10^-6 J
48 x 10^-6 J
72 x 10^-6 J

⇒ The current wave shown in figure is applied by a 0.1 F capacitor at t = 0. At t = 0⁺, the voltage across capacito
0
4 V
10 V
20 V

⇒

Assertion (A): Fourier series can also be written in exponential form.

Reason (R): sin (n ωt) and cos (n ωt) can be expressed as sum or difference of exponentials.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Four terminal approach is used in measuring low resistance because it
eliminates thermoelectric energy
eliminates stray capacitance
eliminates stray inductance
eliminates the effect of leads and contacts

⇒ For an m x n matrix A, the eigen values are the roots of the characteristic equation
|I - A|
|λI - A| = 0
|λA - I| = 0
|A - I| = 0

⇒ The I/P impedance of a short circuited quarter wave long transmission line is
purely reactive
purely resistive
depend on the characteristic impedance of the line
none of the above

⇒ Which of the following is true?
Intel 8080 was the ancestor of Intel 8085
Intel 8080 was the ancestor of Intel Z 80
Intel 8080 was the ancestor of both Intel 8085 and Z 80
Intel 8085 was the ancestor of Intel 8085

⇒ The loss of charge method can be used to measure
resistance of shunt
insulation resistance of cable
resistance of shunt winding
both (b) and (c)

⇒ An inductor filter has a ripple that __________ with load resistance and consequently is used only with relatively __________ load currents.
decreases, low
decreases, high
increases, low
increases, high

⇒ 74 HC series can sink upto 4 mA. The 74 LS series has I_IL(max) - 0.4 mA. How many 74 LS inputs be driven by 74 HC output?
100
none
8
10

⇒ An RLC series circuit is excited by an ac voltage v = 1 sint. If L = 10 H, C = 0.1 F peak value of voltage across R is
0.707 V
1 V
1.44 V
indeterminate as value of R is not given