Question is ⇒ Commercial Frequency deviation of FM is, Options are ⇒ (A) 70 kHz, (B) 75 kHz, (C) 80 kHz, (D) 65 kHz, (E) , Leave your comments or Download question paper.

Question is ⇒ Commercial Frequency deviation of FM is, Options are ⇒ (A) 70 kHz, (B) 75 kHz, (C) 80 kHz, (D) 65 kHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Commercial Frequency deviation of FM is
A.	70 kHz [Wrong Answer]
B.	75 kHz [Correct Answer]
C.	80 kHz [Wrong Answer]
D.	65 kHz [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In 8085 microprocessor, what is the length of PC (program counter)?
6 bits
8 bit
12 bits
16 bits

⇒ An AM signal and a narrowband FM signal with identical carriers, modulating signals and modulation index of 0.1 are added together. The resultant signal can be closely approximated by
Broadband FM
SSB with carrier
DSB-SC
SSB without carrier

⇒ A heater is rated at 230 V, 5 A AC. Then
both the current and voltage are peak values
both the current and voltage are rms values
the current is peak value and voltage is rms value
the current is rms value and voltage is peak value

⇒ Which of the following statement is wrong?
A depletion type N-channel MOSFET conducts even when V_GS = 0
A BJT is very sensitive to radiation whereas FET is relatively immune
Bipolars need higher supply voltage than FETs
Both N-channel as well as p-channel JFETs work in the depletion mode

⇒ So-called 'grounded' antennas are often found insulated from the ground electrically.
TRUE
FALSE

⇒ Figure shows the variation of Z(ω) for a positive real function. The functio
RC impedance
RL impedance
RLC impedance
Reactance function

⇒ A shadow zone does not receive any space wave
TRUE
FALSE

⇒ The factors which govern fan out of CMOS gates are
maximum permissible propagation delay
input capacitance of each load
both (a) and (b)
neither (a) nor (b)

⇒ For type 1 system the velocity lag error is
inversely proportional to bandwidth of system
directly proportional to gain constant
inversely proportional to gain constant
independent of gain constant

⇒ An audio signal of FM radio station is sampled at a rate of 15% above the Nyquist rate. Signal is sampled in 512 levels and bandwidth of the signal is 4 KHz. The minimum bandwidth required to transmit this signal will be
77 K bits/sec
92 K bits/sec
84.8 K bits/sec
82.8 K bits/sec

⇒ FM signal can be generated by
diode reactance modulator
saturable reactor modulator
reactance tube modulator
none of the above

⇒ Point out the false statem
Building, for the time, a body-stabilized geosynchronous communication satellite with its own apogee propulsion and control systems
Attitude control and station management operations for a geostationary satellite
Building launching rocket Ariane for putting APPLE in orbit
Domestic communications on an experimental basis

⇒ Given figure shows a unity feedback system. The ratio of time constants for open loop and closed loop response
0.0423611111111111
0.0840277777777778
0.126388888888889
0.0854166666666667

⇒ If the characteristic equation is (λ + 1) (λ + 2) (λ + 3) = 0, the eigen values are
-1, -2, -3
1, 2, 3
0, 1, 2
0, 2, 3

⇒ In atomic physics, a state with l = 0 is called p state.
TRUE
FALSE

⇒ The radiation pattern of Hertzian dipole in the plane perpendicular to dipole is a
null
circle
figure of eight
none of the above

⇒ The h parameter equivalent circuit of BJT has one voltage source and one current source.
TRUE
FALSE

⇒ 268₁₀ = __________ .
10A₁₆
10B₁₆
10C₁₆
10D₁₆

⇒ An antenna has a gain of 44 dB. Assuming that the main beam of the antenna is circular in cross-section the beamwidth will be
0.4456°
1.4456°
2.4456°
3.4456°

⇒ Electric dipole moment is expressed in debye unit.
TRUE
FALSE

⇒ Read the following statements about sets

If A and B are sets then A + B denotes union of sets A and B.
The union of A and B is that set whose elements are in either A or B or both.
If A and B are sets, then difference of sets A and B is denoted by A - B.
A - B in the set obtained by removing elements of A from B.

Which of the above are true?
All
1, 2 and 3 only
2 and 3 only
1 and 4 only

⇒ For 2 port reciprocal network, o.c. output voltage divided by input current is equal to
B
z₁₂
1/y₁₂
h₁₂

⇒ A single phase half wave controlled rectifier circuit has a free wheeling diode. The load is a combination of R and L. The firing angle is a. The period of conduction of SCR and free wheeling diode respectively are
a < ωt < p and p < ωt < (2p + a)
a < ωt < p and p < ωt < 2p
a < ωt < (p + a) and (p + a) < ωt < 2p
a < ωt < p and p < ωt < (2p - a)

⇒

Assertion (A): In microprocessor 8085 DMA allows direct access to memory to speed up data transfer.

Reason (R): HOLD and HLDA signals are used for DMA operations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Two voltages 50 V each have a phase difference of 45°. The rms value of resultant sum of the two voltages is
70.7 V
80.4 V
92.4 V
100 V

⇒ Which of the following is not valid in case of bipolars?
It has a low input impedance
It has high voltage gain
It is a current controlled device
It is difficult to bias

⇒ An impulse function consist of
pure dc
pure a.c
entire frequency range with constant phase
infinite bandwidth with linear phase vaariations

⇒ The chemical properties of atoms are determined by all the electrons and their configuration.
TRUE
FALSE

⇒ The pure capacitor connected across an A.C. voltage consumed 20 W. This is due to
the capacitive reactance in ohms
the current flowing in the capacitor
the fused capacitor was a big one
none of the above

⇒ Which of the following is not a special purpose peripheral?
Programmable DMA controller
Programmable Floppy disc controller
Programmable Hard disc controller
Programmable CRT controller