Question is ⇒ <code>JCOKE, Options are ⇒ (A) 8, (B) 11, (C) 16, (D) 20, (E) , Leave your comments or Download question paper.

Question is ⇒ <code>JCOKE, Options are ⇒ (A) 8, (B) 11, (C) 16, (D) 20, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	`JCOKE`
A.	8 [Wrong Answer]
B.	11 [Correct Answer]
C.	16 [Wrong Answer]
D.	20 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For the truth table of the given figure
A + B + C
A + BC
A
B

⇒

Assertion (A): For same drain current rating N-channel MOSFET occupies more area than p-channel MOSFET.

Reason (R): Electron mobility is much higher than hole mobility.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ A transistor is operated as non-saturated switch to eliminate
turn on time
turn off time
storage time
delay time

⇒ When transistor is used as a switch __________ is defined as the interval which elapses between the transition of input waveform and the time when to transition to 90% of I_c(sat).
storage time
fall time
turn-on time
turn-off time

⇒ In an RC impedance function
the highest critical frequency is a pole
the highest critical frequency is a zero
the highest critical frequency is a pole or zero
the highest critical frequency is a pole at s = 0

⇒ A buffer amplifier should have
high input impedance and low output impedance
high input impedance and high output impedance
low input impedance and high output impedance
low input impedance and low output impedance

⇒ The system shown in figure remains stable wh
k £ - 1
-1 < k < 1
l < k < 3
k > 3

⇒

LPEPSI
3
9
13
23



⇒ Which of the following method cannot be used to increase the bandwidth for cascaded RF amplifier stages?
Wave traps in each stage
Stagger tuning
A shunt damping resistor across each tuned circuit
Doubled tuned transformers with tighter coupling

⇒ The r.m.s. value of a half-wave rectified current is 100 A. Its value for full-wave rectification would be __________ amperes.
141.4
200
200/p
40/p

⇒ The inductance of a coil can be increased by
choosing core material having high relative permeability
decreasing diameter of the former
decreasing the number of turns
increasing core length

⇒ In a BJT CE amplifier circuit the value of coupling capacitor should be such that
its reactance is small for the lowest frequency in the input and output
its reactance is high for the lowest frequency in the input and output
its reactance is zero for the lowest frequency in the input and output
its reactance is infinite for the lowest frequency in the input and output

⇒ The most important primary force of attraction in the formation of solids is
electromagnetic
electrostatic
quantum-electrostatic
quantum electromagnetic

⇒ In a JK flip flop toggle means
set Q = 1 and Q = 0
set Q = 0 and Q = 1
change the output to the opposite state
no change in output

⇒ What is the addressing mode used in instruction MOV M, C?
Direct
Indirect
Induced
Immediate

⇒ Emitter follower is in which of following configuration.
common Base
common Emitter
common collector
common Base or common Emitter

⇒ Magnetic flux density has the dimensions
MI^-1T^-2
M^-1I^-2T^-2
ML^-3T^-2
MI^-1T^-3

⇒ The wave applied to X plates, for ohtaining trace of voltage wave, is
sawtooth wave
sinusoidal wave
rectangular wave
either (a) or (c)

⇒ Assertion (A): In an intrinsic semiconductor J = (μ_n x μ_p)en_i.
Reason (R): Intrinsic charge concentration n_i at temperature T is given by n_i² = A₀ T³ e^-E_G0/kT.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Assertion (A): An artificial transmission line can be used as a pulse generator.
Reason (R): A pulse function is used very frequently in network analysis.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a JFET
gate source cut off voltage is equal to V_DS
gate source cut off voltage is equal to pinch off voltage
gate source cut off voltage is twice the pinch off voltage
gate source cut off voltage is equal to negative pinch off voltage

⇒ An SUS is
exactly similar to SCR but with higher rating
similar to UJT
PUT and avalanche diode connected in anti parallel
SCR and avalanche diode connected in parallel

⇒ The number of tightly bound electrons in silicon atom are
14
10
6
4

⇒ Which of the following uses a capacitor in the feedback path?
Active low pass filter
Active high pass filter
Both (a) or (b)
Neither (a) nor (b)

⇒ Periodic recharging of the memory cells at regular intervals of 3 to 8 millisecond is required in a
ROM
Static RAM
Dynamic RAM
PLA

⇒ A satellite that simply reflect back the signals from one region of the earth to the other region is known as
orbiting satellite
geostationary satellite
active satellite
passive satellite

⇒ Match the following:
 List I (Amplifier coupling)  List II (Feature) 
A. RC 1. High voltage gain and impedance matching
B. Inductive 2. Ability to amplify dc and low frequency signals
C. Transformer 3. Minimum non-linear distortion
D. Direct 4. Low collector supply voltage can be used

A-4, B-1, C-3, D-2
A-3, B-4, C-1, D-2
A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1

⇒ The element in the feedback circuit of a logarithmic amplifier using op-amp is
a resistor
a capacitor
an inductor
a diode

⇒ In the given figure assume that initially Q = 1 with Clock Pulses being given, the subsequent states of Q wil
1, 0, 1, 0, 1......
0, 0, 0, 0, 0......
1, 1, 1, 1, 1......
0, 1, 0, 1, 0......

⇒ Mobility is directly proportional to Hall coefficient.
TRUE
FALSE

	List I (Amplifier coupling)		List II (Feature)
A.	RC	1.	High voltage gain and impedance matching
B.	Inductive	2.	Ability to amplify dc and low frequency signals
C.	Transformer	3.	Minimum non-linear distortion
D.	Direct	4.	Low collector supply voltage can be used









Users Also Read
Previous Papers
Aptitude
Reasoning
Gen.Knowledge
Speak English
English / Verbal
Online / Mock Test
Vedic Math







    
	
	



    
	StudySite.org is world's best online study provider, Copyright © 2023 by 
StudySite.org All Rights Reserved