Question is ⇒ Circular polarized waves result when, Options are ⇒ (A) magnitudes are the same, (B) phases are the same, (C) magnitudes are same and phase difference is 90°, (D) magnitudes are same and phase difference is zero, (E) , Leave your comments or Download question paper.

Question is ⇒ Circular polarized waves result when, Options are ⇒ (A) magnitudes are the same, (B) phases are the same, (C) magnitudes are same and phase difference is 90°, (D) magnitudes are same and phase difference is zero, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Circular polarized waves result when
A.	magnitudes are the same [Wrong Answer]
B.	phases are the same [Wrong Answer]
C.	magnitudes are same and phase difference is 90° [Correct Answer]
D.	magnitudes are same and phase difference is zero [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In figure which diode will conduct and what will be the value of V_{0D₃, 1 V
D₁, 2 V
D₂, 5 V
D₁, 5 V}

⇒ A microwave junction is matched at all ports if the S matrix
has all diagonal elements zero
has all diagonal elements equal but not zero
has all diagonal elements complex
is Hermitian

⇒ The intrinsic resistivity of silicon at 300 K is about
1 Ω-cm
400 Ω-cm
10000 Ω-cm
230000 Ω-cm

⇒ The emitter resistor R_E in the emitter of CE amplifier stabilizes the dc operating point against variation in
temperature only
β of transistor
both temperature and β
none of the above

⇒ Antenna reciprocity is put to use in
radar system
commercial broadcast
TV broadcast system
none of the above

⇒ Consider the following stateme
1 and 2 only
1, 2 and 4
2 and 3 only
2, 3 and 4

⇒ The radiation resistance of a circular loop of one turn is 0.01 ohm. For 5 turn loop the radiation resistance is
0.002 Ω
0.01 Ω
0.05 Ω
0.25 Ω

⇒ In the BJT amplifier shown in the figure is the transistor is biased in the forward active region. Putting a capacitor across R_E
decrease the voltage gain and decrease the I/P impedance
increase the voltage gain and decrease the I/P Impedance
decrease the voltage gain and Increase the I/P impedance
none of the above

⇒ Which of the following number specification refers to FET with one gate?
2N
3N
3Y
3X

⇒ Transit time is considered as significant at
HF
MF
LF
all of the above

⇒ In a varactor diode the increase in width of depletion layer results in
decrease in capacitance
increase in capacitance
no change in capacitance
either (a) or (b)

⇒ A seven bit (even parity) code 0010001 may have error. The correct code is
10001
1110001
11001
1111110

⇒ In which of the transformer is the secondary nearly short circuited under normal operating conditions?
CT
PT
Distribution transformer
Power transformer

⇒

Match the following:

	List I		List II
A.	Detection of a periodic signal in noise	1.	Increase in band-width
B.	Recovery of a band limited signal from its uniformly sampled values	2.	Slope over load error
C.	Finer quantization	3.	Nyquist rate of signals
D.	Delta modulation	4.	Cross correlation

A-4, B-3, C-1, D-2
A-3, B-2, C-1, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-4, D-1

⇒ Consider the following statements in amplitude modulation

The harmonic and intermodulation distortion may occur in audio and RF amplifiers
The sum and difference frequencies are present in the output of mixer
The diode detector has audio frequencies in its output
A balanced modulator cannot produce an AM with suppressed carrier

Which of the above are true?
1, 2, 3, 4
1, 2, 3
1, 2
3, 4

⇒ In the circuit of figure the d
will conduct as the whole cycle
will conduct in the positive half cycle
will not conduct
will conduct from 30° to 150° in the positive half cycle

⇒ A string constant in basic is
a string of capital alphabets A to Z, included in question mark
a string of capital alphabets A to Z and digits 0 to 9 included in question mark
a string of capital alphabets A to Z, digits 0 to 9 and special characters
a string of capital alphabets A to Z, digits 0 to 9 and special characters included in question mark

⇒

Match the following:

	List I (Application of circuit)		List II (Circuit Name)
A.	Divider	1.	Astable multivibrator
B.	Clips input voltage at two predetermined levels	2.	Schmitt trigger
C.	Square wave generator	3.	Bistable multivibrator
D.	Narrow current pulse generator

A-4, B-2, C-1, D-3
A-3, B-2, C-1, D-4
A-4, B-1, C-2, D-3
A-3, B-1, C-2, D-4

⇒ Symbol shown in figure represen
Enhancement only N-channel MOSFET
UJT with p-type base
N-channel DMOSFET with internal protection
Phototransistor

⇒ Which of these has a magnetic brake?
Thermocouple ammeter
Energy meter
Dynamometer wattmeter
Frequency meter

⇒ In 8085, which instructions are useful for writing and using subroutines?
CALL
RET
CALL and RET
none of the above

⇒ For satellite transmission, analog signals may be converted into digital form with the help of
modem
transponder
codec
compandor

⇒ In measuring a resistance by voltmeter-ammeter method, the voltmeter can be connected either across supply or across the resistance. If the resistance is low, the voltmeters should be connected
across the supply
across the resistance
either in two positions
preferably across the supply

⇒ In two level logic, logic race does not occur.
TRUE
FALSE

⇒ In a receiver, which of the following device has RF input but IF output?
Loudspeaker
Frequency changer
Demodulator
Audio amplifier

⇒ Solution of Laplace equations, which are continuous through the second derivative, are called
bessel functions
odd functions
harmonic functions
fundamental functions

⇒ The resonant frequency of a series resonant circuit is
arithmetic mean of half power frequencies
independent of inductance of the circuit
independent of capacitance of the circuit
geometric mean of half power frequencies

⇒ A power supply has full-load voltage of 20 V. What will be its no load voltage when its voltage regulation is 100%
0 V
10 V
20 V
40 V

⇒ A series RLC circuit has a resonant frequency of 1000 Hz. The maximum voltage across C is likely to occur at a frequency of about
1000 Hz
2000 Hz
1025 Hz
975 Hz

⇒ Power spectral density of white noise
is constant with frequency
increases with frequency
decreases with frequency
none