Question is ⇒ Choose proper substitutes for x and y to make the following statement corr, Options are ⇒ (A) x : Reverse, y : Reverse, (B) x : Reverse, y : forward, (C) x : Forward, y : Reverse, (D) x : forward, y : forward, (E) , Leave your comments or Download question paper.

Question is ⇒ Choose proper substitutes for x and y to make the following statement corr, Options are ⇒ (A) x : Reverse, y : Reverse, (B) x : Reverse, y : forward, (C) x : Forward, y : Reverse, (D) x : forward, y : forward, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Choose proper substitutes for x and y to make the following statement corr
A.	x : Reverse, y : Reverse [Wrong Answer]
B.	x : Reverse, y : forward [Wrong Answer]
C.	x : Forward, y : Reverse [Correct Answer]
D.	x : forward, y : forward [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the circuit of figure, Thevenin's resistance is 10 &
25 Ω
10 Ω
13.33 Ω
6 Ω

⇒ In an SSB transmitter one is most likely to find
class C audio amplifier
tuned modulator
class B RF amplifier
class AB power amplifier

⇒ The main advantage of superheterodyne receiver is
better tracking
simple cut
better alignment
improvement in selectivity and sensitivity

⇒ The stray capacitance between the last stage and the first stage of an oscillator may cause
unwanted low frequency oscillations
unwanted high frequency oscillations
unwanted oscillations at low and high frequencies
large feedback

⇒ The difference between measured value and true value is called
gross error
relative error
probable error
absolute error

⇒ Impedance inversion may be obtained with
half wave line
a short circuited stub
complex impedance Z connected in series with line
quarter wave line

⇒ A UPS contains
rectifier
inverter
either rectifier or inverter
both rectifier and inverter

⇒ McMurrary full bridge inverter uses
auxiliary commutation
complementary commutation
natural commutation
any of the above

⇒ An 8085 microprocessor based system uses a 4 k x 8 bit RAM whose address in AAOOH. The address of the last byte in this RAM is
OFFFH
1000H
B9FFH
BA00H

⇒ The turn ratio of a transformer is 20:1, if a load of 10Ω is connected across the secondary, what will be the effective resistance seen looking into the Primary?
2 kΩ
4 kΩ
8 kΩ
32 kΩ

⇒ The selectivity curve of a standard receiver is represente
curve A
curve B
curve C
curve D

⇒

Assertion (A): A band elimination filter attenuates signals whose frequencies lie between the cutoff frequencies.

Reason (R): A band elimination circuit is very different from band pass circuit.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ If the transmission parameters of the given networks are A = C = 1, B = 2 and D = 3, then the value of Z_{m12/13 Ω
13/12 Ω
3 Ω
4 Ω}

⇒ Choose the correct option

Mesh is the smallest loop of circuit
Loop is smallest path of circuit
Loop does not contain any mesh
Loop may have one or more than one mesh

1, 2, 3, 4
3, 4, 2
1, 4
3, 2

⇒ The register set and instruction set of 8088 is similar to that of
8085
8086
partly 8085 and partly 8086
none of the above

⇒ The number of bits of information required to indicate the correct selection of 3 independent consecutive events out of 75 equally probable events is
6.23
18.69
10.46
24.92

⇒ Diffraction of electromagnetic wave
is caused by reflection from the ground
may occur around the edge of a sharp obstacle
arises only with spherical wavefronts
none of these

⇒

Assertion (A): Microprocessor 8085 has an 8 bit register called accumulator which stores intermediate answers during a computer operation.

Reason (R): Accumulator can send or receive data.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In following figure, the initial contents of the 4-bit serial in parallel out, right shift, shift register as shown in figure are 0110. After 3 clock pulses the contents of the shift register wil
0
101
1010
1110

⇒ An antenna having a high Q has
lower BW
higher BW
flat response
none of the above

⇒ For addition and subtraction operations, phasors
must be represented in polar form
must be represented in rectangular form
may be represented in any form
none of the above

⇒ Which of these instruments has highest power consumption?
Dynamometer
Electrostatic
Moving coil
Hot wire

⇒ Consider the following sets of values of E, R and C for the circuit in the given fig
1 and 4
1 and 2
3 and 4
2 and 3

⇒ A pair of 21114s can store __________ words of __________ bits each.
2114, 8
1024, 8
4228, 16
2114, 16

⇒ In a klystron amplifier the bunching effect
converts velocity modulation into current modulation of beam
converts current modulation into velocity modulation of beam
both (c) and (b)
neither (a) nor (b)

⇒ For a symmetrical network
h₁₁ = h₂₂
h₁₂ = h₂₁
h₁₁ h₂₂ - h₁₂ h₂₁ = 0
h₁₁ h₂₂ - h₁₂ h₂₁ = 1

⇒ What is the characteristic of a good control system?
Sensitive to parameter variation
Insensitive to input command
Neither sensitive to parameter variation nor sensitive to input commands
Insensitive to parameter variation but sensitive to input commands

⇒ A communication satellite is a repeater between
a transmitting station and a receiving station
a transmitting station and many receiving station
many transmitting station and many receiving station
none

⇒ The given figure shows log magnitude versus ω plots of a system for different values of gain. For this sy
curve 1 shows highest gain margin and curve 2 shows poorest gain margin
gain margins shown by the three curves are equal
curve 1 shows poorest gain margin and curve 3 shows highest gain margin
curve 3 shows poorest gain margin while curve 1 shows highest gain margin

⇒ The ac input voltage of an amplifier
is always equal to ac signal voltage
may be equal to or more than ac signal voltage
is always less than ac signal voltage
may be equal or more or less than ac signal voltage