Question is ⇒ Cells are connected in parallel in order to increase the, Options are ⇒ (A) life of the cells., (B) efficiency., (C) current capacity., (D) voltage rating., (E) , Leave your comments or Download question paper.

Question is ⇒ Cells are connected in parallel in order to increase the, Options are ⇒ (A) life of the cells., (B) efficiency., (C) current capacity., (D) voltage rating., (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Cells are connected in parallel in order to increase the
A.	life of the cells. [Wrong Answer]
B.	efficiency. [Wrong Answer]
C.	current capacity. [Correct Answer]
D.	voltage rating. [Wrong Answer]
View Answer 15 -4 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ During electrodeposition. the amounts of different substances liberated by same quantity of electricity are proportional to
atomic weights.
valency.
chemical equivalents.
atomic numbers

⇒ Pickling is
protection of surface from rusting.
a layer coating for preventing surface deterioration.
removal of scale, grease etc. from the surface.
none of the above.

⇒ In a battery, cover is placed over the elements and sealed at the top of the battery container. This is done in order to
exclude dirt and foreign matter from the electrolyte.
reduce evaporation of water from electrolyte.
both (a) and (b).
none of the above

⇒ The emf of a lead battery
increases with the increase in specific gravity of the electrolyte.
slightly increases with the increase in temperature.
decreases with the increase in temperature.
both (a) and (b).

⇒ Rust, scales and oxides can be removed from a surface with the help of
various acids.
alkali and salt solution.
mechanical abrasion.
electrolytic cleaning any of the above.

⇒ First electrochemical cell was designed by
Galvani
Faraday
Lechlanche
None of these

⇒ During discharging of lead acid cells, the terminal voltage decreases with the decrease in
temperature.
discharge rate.
state of charge.
none of these.

⇒ Short circuiting of a cell may be caused by
buckling of plates.
breakdown of one or more separators.
excessive accumulation of sediments at the bottom of the cell.
lead particles forming circuits between positive and negative plates.

⇒ Sulphated cells are indicated by the
low specific gravity.
low voltage on discharge.
low capacity.
all of the above.

⇒ The electric cell is a device to obtain
Electrons
Electric charge
Electric energy from chemical energy
Electric force

⇒ Addition of which of the following substances in electrolyte promotes smooth deposition?
Albumen.
Glucose.
Phenol.
Any of these.

⇒ During electroplating the weight of a substance deposited depends upon
shape of the article
quantity of electricity
room temperature
all of the above

⇒ What carries current in an electrolyte
Electrons only
- ve ions only
+ ve ions only
Both + ve and - ve ions

⇒ The arrangement of 12 cells, each of internal resistance 1.5 ω, to give maximum current in external load resistance of 2 ω will be
all 12 cells in series.
all 12 cells in parallel.
4 cells in series with 3 rows in parallel.
3 cells in series with 4 rows in parallel.

⇒ Battery charging equipment should be installed
in well ventilated, clean and dry place.
as near as practical to the battery under charge.
both (a) and (b).
wherever convenient.

⇒ In a lead acid battery, fillers are provided to
facilitate flow of gasses
prevent flow of gasses.
recover acid losses through vapours.
reduce tendency for polarisation.

⇒ What happens during the charging of acid cell ?
Voltage increases
Energy is given out
Both
None of these

⇒ For achieving uniform thickness of deposit on irregular surface
anode and cathode are kept farther apart
anode and cathode are kept closer.
high current densities are used.
electrolyte is agitated constantly

⇒ A battery is connected to a resistance causing a current of 0.5 A in the circuit. The current drops to 0.4 A when an additional resistance of 5 ω is connected in series. The current will drop to 0.2 A when the resistance is further increased by
10 ω
15 ω
25 ω
40 ω

⇒ Which of the following statements is incorrect about lead acid batteries ?
The electrolyte in weak sulphuric acid.
When fully charged both of the plates become lead-per-oxide.
The number of plates is always odd.
The number of negative plates is one more than the number of positive plates.

⇒ Which of the following is not the name of a secondary cell ?
Acid cell
Alkali cell
Fuel cell
Storage cell

⇒ Five cells are connected in series in a row and then four such rows are connected in parallel to feed the current to a resistive load of 1.25 ω. Each cell has an emf of 1.5 V with an internal resistance of 0.2 ω. The current through the load will be
3.33 A
23.33 A
5 A
1 A

⇒ The amount of ions liberated by 96500 C of charge passed through the electrolyte is called ?
Electrochemical equivalent
Chemical equivalent
Gram equivalent
None of these

⇒ Vent plug is provided in each lead acid cell to
pour water or electrolyte when needed.
check the electrolyte level.
allow escape out of gases during charging.
all of the above.

⇒ Standard cell
will have precise and accurate constant voltage when current drawn from it is few microamperes only.
will have precise and accurate constant voltage when few milliamperes are drawn from it.
will continue to have constant voltage irrespective of loading conditions.
can supply voltages up to 10 V.

⇒ Capacity of a dry cell is
more when it supplies current continuously.
more when it supplies current intermittently.
not affected by the type of discharge.
none of the above.

⇒ In a lead acid battery, separators are provided to
reduce internal resistance.
facilitate flow of the current.
avoid internal short circuits.
increase the energy efficiency.

⇒ The capacity of a lead acid battery is adversely affected by increase in
discharge rate.
charge rate.
temperature.
specific gravity of the electrolyte.

⇒ The capacity of a lead acid battery does not depend upon
charge rate.
discharge rate.
temperature.
density of electrolyte & quantity of active material.

⇒ Charging of a sulphated battery at high rate causes
warping of plates.
boiling of electrolyte owing to gassing.
damage to separators, cell caps, covers and battery case due to excessive temperature.
all of the above.