Question is ⇒ CCIR system B employs, Options are ⇒ (A) 625 lines, (B) 625 lines with 2 : 1 interlace, (C) 625 lines with 4 : 1 interlace, (D) 500 lines with 2 : 1 interlace, (E) , Leave your comments or Download question paper.

Question is ⇒ CCIR system B employs, Options are ⇒ (A) 625 lines, (B) 625 lines with 2 : 1 interlace, (C) 625 lines with 4 : 1 interlace, (D) 500 lines with 2 : 1 interlace, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	CCIR system B employs
A.	625 lines [Wrong Answer]
B.	625 lines with 2 : 1 interlace [Correct Answer]
C.	625 lines with 4 : 1 interlace [Wrong Answer]
D.	500 lines with 2 : 1 interlace [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the transmission line of length 37.5 cm, which is terminated into zero resistance. This line is being exited by a source of 1 GHz which has an internal impedance of 50 Ω. What is the input impedance of the line as seen by the source?
50 Ω
Zero Ω
100 Ω
Infinite Ω

⇒ The power in the signal s(t) = 8 cos (20 p - p/2) + 4 sin (15 pt) is
40
41
42
82

⇒ Photo electric emission can occur only if the frequency of light is more than threshold frequency.
TRUE
FALSE

⇒ Which of the following introduces mode partition noise?
Coaxial line
Waveguide
Fibre transmission line
Both coaxial line and waveguide

⇒ What is the major cause of creeping in an energy-meter?
Over compensation for friction
Mechanical vibrations
Excessive voltage across the potential coil
Stray magnetic fields

⇒ In a receiver, at higher frequencies
tracking will be improved
tracking will be poor
selectivity will be poor
image frequency rejection will be poor

⇒ Consider the following BJT circ
2.46 kΩ
2.88 kΩ
200 Ω
18.48 Ω

⇒ A periodic voltage has following values for equal time intervals changing suddenly from one value to next : 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, - 5, - 10
31 v
32 v
insufficient data
none of these

⇒ The point P in the following figure is stock at 1. The output f wil
ABC
A
AB C
A

⇒ The band gap of Si at room temperature is
1.3 eV
0.7 eV
1.1 eV
1.4 eV

⇒

Assertion (A): Divide-64 counter is a Mod-64 counter and divides the input frequency by 64

Reason (R): A Mod 64 counter can be obtained by cascading Mod 16 and Mod 4 counters.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A lag compensator provides attenuation in
very low frequency range
low frequency range
high frequency range
none of the above

⇒ An amplifier has open loop gain of 100, input impedance 1 kΩ and output impedance 100 Ω. If negative feedback with β = 0.99 is used, the new input and output impedances are
10 Ω and 1 Ω
10 Ω and 10 kΩ
100 kΩ and 1 Ω
100 kΩ and 10 Ω

⇒ Which of the following is used to generate PDM?
Free running multi-vibrator
Monostable multi-vibrator
JK flip-flop
Schmitt trigger

⇒ A 50 Hz current has an amplitude of 10 A. The rate of change of current at t = 0.005 after i = 0 and is increasing is
2221.44 A/s
0
- 2221.44 A/s
- 3141.6 A/s

⇒ When p-n junction is reverse biased the holes in p material move towards the junction and electrons in n material move away from the junction.
TRUE
FALSE

⇒ The ability of a radio receiver to discriminate between different input signals and to accept only one definite signal is called its
sensitivity
attenuation
selectivity
modulation

⇒ In the FM wave described by equation v = 15 sin (4 x 10⁸ t + 3 sin 1100 t), the carrier frequency and signal frequency respectively are
63.66 MHz and 175 Hz
4 x 10⁸ Hz and 1100 Hz
175 Hz and 63.66 MHz
1100 Hz and 4 x 10⁸ Hz

⇒ For a given magnetic material operating in linear mode B = 0.06 T. Assume permeability = 51, then magnetization is:
44836 A/m
46834 A/m
946 A/m
936 A/m

⇒ Which addressing mode is suitable only for these instructions in which there is only one operand?
Implicit
Register
Direct
Immediate

⇒ In free space
phase velocity is greater than light velocity
phase velocity is equal to group velocity
phase velocity is equal to light velocity
Both (b) and (c)

⇒ A device which converts BCD to seven segment is called
encoder
decoder
multiplexer
none of these

⇒ In a communication system, noise is most likely to affect the signal
at the transmitter
in the channel
in the information source
at the destination

⇒ The amount of time between the creation and recombination of a free electron and hole is called
relaxation time
life time
lorentz time
collision time

⇒ With four Boolean variables, how many Boolean expressions can be performed?
16
256
1024 (1 K)
64K (64 x 1024)

⇒ Which statement is false as regards holes
Holes exist in conductors as well as semiconductors
Holes constitute positive charges
Holes exist only in semiconductors
Holes and electrons recombine

⇒ h parameters are used in transistor analysis.
TRUE
FALSE

⇒ The output, V-I characteristics of an Enhancement type MOSFET has
only an ohmic region
only a saturation region
an ohmic region at low voltage value followed by a saturation region at higher voltages
an ohmic region at large voltage values preceded by a saturation region at lower voltages

⇒ A single phase energy meter operates on induction principle.
TRUE
FALSE

⇒ As per BIS, the number of accuracy classes of instrument is
5
6
7
8