Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | Capacitive reactance is more when |

A. | Capacitances is less and frequency of supply is less [Correct Answer] |

B. | Capacitance is less and frequency of supply is more [Wrong Answer] |

C. | Capacitance is more and frequency of supply is less [Wrong Answer] |

D. | Capacitance is more and frequency of supply is more [Wrong Answer] |

View Answer
Explanation:-
Answer : ADiscuss it below :Krishna Kumar Said on 2018-01-13 11:06:22Xc=1/jwc Virendra Said on 2016-11-09 02:07:14Xc=1/wc=1/2*pi*f*c Pallavi Said on 2015-08-24 07:33:26Xc=1/jwC !! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ The r.m.s. value of a sinusoidal A.C. current is equal to its value at an angle of____ degrees

90

60

45

30

⇒ The r.m.s. value of a sine wave is 100A. Its peak value is

70.7 A

141.4A

150A

282.8 A

⇒ Form factor for a sine wave is

1.414

0.707

1.11

0.637

⇒ The r.m.s. value of a half-wave rectified current is 100 A. Its value for full-wave rectification would be____ amperes.

141.4

200

200/π

40/π

⇒ The dual of a loop is

Twig

Node pair

Mesh

Tree

⇒ The r.m.s. value of pure cosine function is

0.5 of peak value

0.707 of peak value

Same as peak value

Zero

⇒ The power is measured in terms of decibles in case of

Electronic equipment

Transformers

Current transformers

Auto-transformers

⇒ In a series resonant circuit, the impedance of the circuit is

Minimum

Maximum

Zero

None of the above

⇒ Form factor is the ratio of

Average value/r.m.s. value

Average value/peak value

r.m.s. value/average value

r.m.s. value/peak value

⇒ Which of the following circuit component opposes the change in the circuit voltage

Inductance

Capacitance

Conductance

Resistance

⇒ In a R-L-C series circuit if voltage V across the circuit is reduced to half the current I will change to

2 I

I/2

3/4 I

5/8 I

⇒ In an A.C. circuit I sin Φ is called

Active component

Wattless component

Any of the above

None of these

⇒ The shunt element in a band pass filter is

Capacitive

Inductive

Parallel combination of L and C

Series combination of L and C

⇒ Two sinusoidal quantities are said to be phase quadrature, when their phase difference is

0

30°

45°

90°

⇒ A heater is rated as 230 V, 10 KW, AC. The value 230 V refers t

Average voltage

r.m.s. voltage

Peak voltage

None of these

⇒ The transient currents are associated with the

Changes in the stored energy in the inductors and capacitors

Impedance of the current

Applied voltage to the circuit

Resistance of the circuit

⇒ The ratio of the bandwidth to the resonance frequency is called the____ of the circuit.

Impedance

Susceptance

Quality factor

Selectivity

⇒ In an A.C. circuit power is dissipated in

Resistance only

Inductance only

Capacitance only

None of the above

⇒ In an A.C. circuit, a low value of kVAR compared with kW indicates

Low efficiency

High power factor

Unity power factor

Maximum Load current

⇒ For the same peak value, which of the following wave has the least mean value ?

Half wave rectified sine wave

Triangular wave

Sine wave

Square wave

⇒ In a series resonant circuit, the impedance of the circuit is

Maximum

Minimum

Zero

Infinite

⇒ Inductance affects the direct current flow

Only at the time of turning off

Only at the time of turning on

At the time of turning on and off

At all the time of operation

⇒ Skin effect occurs when a conductor carries current at____ frequencies.

Very low

Low

Medium

High

⇒ The dual of a link is

Twig

Node

Loop

Tree branch

⇒ The power factor of incandescent bulb is

0.8 lagging

0.8 leading

Unity

Zero

⇒ The power factor of a series R-L-C circuit at its half-power points is

Unity

Lagging

Leading

Lagging or leading

⇒ The power factor at resonance in RLC parallel circuit is

Zero

0.08 Lagging

0.8 Leading

Unity

⇒ For a sine wave with peak value I

_{max}the r.m.s. value is

0.5 I

_{max}

0.707 I

_{max}

0.9 I

_{max}

1.414 I

_{max}

⇒ The unit of frequency of an A.C. signal is

Cycle

Cycle-sec

Hertz

Hertz/sec

⇒ For a sine wave with peak value E

_{max}the average value is

0.636 E

_{max}

0.707 E

_{max}

0.434 E

_{max}

1.414 E

_{max}