Question is ⇒ Calculate the stability factor and change in Ic from 25°C to 100°C for, β = 50, RB/RE = 250, ΔICO = 19.9 nA for emitter bias configuration, Options are ⇒ (A) 42.553, 0.85 μF, (B) 40.91, 0.58 μF, (C) 38.53, 0.85 μF, (D) 41.10, 0.39 μF, (E) , Leave your comments or Download question paper.

Question is ⇒ Calculate the stability factor and change in Ic from 25°C to 100°C for, β = 50, RB/RE = 250, ΔICO = 19.9 nA for emitter bias configuration, Options are ⇒ (A) 42.553, 0.85 μF, (B) 40.91, 0.58 μF, (C) 38.53, 0.85 μF, (D) 41.10, 0.39 μF, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Calculate the stability factor and change in I_c from 25°C to 100°C for, β = 50, R_B/R_E = 250, ΔI_CO = 19.9 nA for emitter bias configuration
A.	42.553, 0.85 μF [Correct Answer]
B.	40.91, 0.58 μF [Wrong Answer]
C.	38.53, 0.85 μF [Wrong Answer]
D.	41.10, 0.39 μF [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In steady state condition inductor behave as
open circuit
short circuit
current source
voltage source

⇒ In a PCM system, if the code word length is increased from 6 to 8 bits, the signal to quantization noise ratio improves by the factor.
42953
12
16
8

⇒ The rate of change of digital signals between High and Low level is
very fast
fast
slow
very slow

⇒ For a stable system having two or more gain crossover frequencies the phase margin is measured
at lowest gain crossover frequency
at highest gain crossover frequency
at the gain crossover frequencies
none of the above

⇒ A 4 bit DAC gives an output of 4.5 V for input of 1001. If input is 0110, the output is
1.5 V
2.0 V
3.0 V
4.5 V

⇒ The resonant frequency of an R_F amplifier is 1 MHz and its bandwidth is 10 kHz. The Q factor will be
10
100
0.01
0.1

⇒ In an insulated gate FET, the polarity of inversion layer is the same as that of
minority carriers in source
majority carriers in source
charge on gate electrode
minority carriers in drain

⇒ In the two ports network shown in the figure, Z₁₂ and Z₂₁ are, respecti
r_e and βr₀
0 and - βr₀
0 and βr₀
r_e and - βr₀

⇒ Derivative control action is effective?
Only during steady state periods
Only during transient state periods
During both steady state and transient state periods
Either during steady state or during transient state periods

⇒ In a 4 input AND gate, the total number of High outputs for 16 input states are
16
8
4
1

⇒ In the given figure the phase angle of Fn is either 0 or &
TRUE
FALSE

⇒ Ebers Moll model is applicable to
bipolar Junction transistor
N MOS transistor
unipolar junction transistor
field effect transistor

⇒ Which of the following statement about TRIAC is incorrect?
It is not particularly suited to A.C. or mains power control
Any one of its main terminals can be used either as cathode or as anode
It can be triggered in response to both positive and negative gate terminals
None of the above

⇒ A rectangular waveguide, in dominant TE mode, has dimensions 10 cm x 15 cm. The cut off frequency is
10 GHz
1 GHz
15 GHz
25 GHz

⇒ Which of the following is a better propagation mode to propagate television frequency modulation and radar signals?
Satellite communication
Ground propagation
Polarized communication
None of the above

⇒ For a class B amplifier using a supply of V_CC = 30 V and driving a load of 16 Ω the maximum efficiency will be __________ .
0.724
0.7854
0.624
0.6854

⇒ For the wave shown in figure, the average valu
14.14 A
15 A
17.17 A
19.19 A

⇒ Which of the following is not a valid arithmetic statement in C?
x = x + 1
x = y ^* z
x ^* y = z
z = y / x

⇒ As per BIS, solid insulators are classified into 6 categories.
TRUE
FALSE

⇒

Assertion (A): For a given system only one of the static error constants is finite and significant.

Reason (R): If finite static error constant is large, the loop gain becomes smaller as ω approaches zero.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Rotation of a geosynchronous satellite means its
drift from stationary position
wobbling
three-axis stabilization
three-dimensional stabilization

⇒ The current flowing in a certain P-N junction at room temperature is 2 x 10^-7 Amp. When a large reverse biased voltage is applied. Calculate the current flowing when 0.1 volts is applied.
9 μA
10 μA
2 μA
4 μA

⇒ The parameter β of a BJT change by 300%. If self bias is used in the amplifier using this BJT, the quiescent value of I_C and V_CE remain almost the same.
TRUE
FALSE

⇒ As the temperature of semiconductor is increased
the average number of free charge carriers decreases
the average number of free charge carriers increases
the average number of free charge carriers remains the same
the average number of free charge carriers may increase or decrease

⇒ It is required to measure temperature in the range of 1300-1520°C. The most suitable thermocouple is
chromel constantan
iron constantan
chromel aluminium
platinum-rhodium

⇒ Saturation of iron core causes distortion.
TRUE
FALSE

⇒

Assertion (A): Light triggering is very suitable for HVDC transmission.

Reason (R): Light triggering has the advantage of complete electrical isolation of gate circuit.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ One T state is precisely equal to one clock period.
TRUE
FALSE

⇒ The function Y = AC + BD + EF is
POS
SOP
Hybrid
none of the above

⇒ When a semi-conductor is doped, its electrical conductivity
increases
decreases in the direct ratio of the doped material
decreases in the inverse ratio of the doped material
remains unaltered