Question is ⇒ Boolean expression for the output of XNOR (Equivalent) logic gate with inputs A and B is, Options are ⇒ (A) AB + AB, (B) AB + AB, (C) (A + B). (A + B), (D) (A + B). (A + B), (E) , Leave your comments or Download question paper.

Question is ⇒ Boolean expression for the output of XNOR (Equivalent) logic gate with inputs A and B is, Options are ⇒ (A) AB + AB, (B) AB + AB, (C) (A + B). (A + B), (D) (A + B). (A + B), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Boolean expression for the output of XNOR (Equivalent) logic gate with inputs A and B is
A.	AB + AB [Wrong Answer]
B.	AB + AB [Wrong Answer]
C.	(A + B). (A + B) [Correct Answer]
D.	(A + B). (A + B) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The number of bits in EBCDIC is
12
10
8
6

⇒ The frame of an electric motor is earthed through three earthing plates resistances 30 Ω, 20 Ω and 10 Ω respectively. During fault the energy dissipated by three plates are W₁, W₂ and W₃. Then
W₁ > W₂ > W₃
W₁ < W₂ < W₃
W₁ = W₂ = W₃
W₁ + W₃ < W₂

⇒ Consider the following rectifier circuits :

half-wave rectifier without filter
full-wave rectifier without filter
full-wave rectifier with series inductance filter
full-wave rectifier with capacitance filter.

The sequence of these rectifier circuits in decreasing order of their ripple factor is
1, 2, 3, 4
3, 4, 1, 2
1, 4, 3, 2
3, 2, 1, 4

⇒ The input gate current of a FET is
a few amperes
a few milli amperes
a few micro amperes
negligible

⇒ Two thyristors of the same rating and specifications
will have equal on state voltage drops
will have equal forward blocking voltage for the same current
will have different on state voltage drops
may have equal or different on state voltage drops and equal or different forward blocking voltage's for the same current

⇒ An interrupt in which the external device supplies its address as well as the interrupt is known as
vectored interrupt
maskable interrupt
polled interrupt
non-maskable interrupt

⇒ The conductivity of intrinsic semiconductor is given by
en_i(μ_p - μ_n)
en_i(μ_p + μ_n)
n_i(μ_p + μ_n)
n_i(μ_pμ_n)

⇒ Most of the memory chips in static RAM
do not require any supply
need 2 V supply
need 5 V supply
need 12 V supply

⇒ A static excitation system uses
transformer and thyristors
transformer and ac exciter
dc exciter and ac exciter
transformer and dc exciter

⇒ If f is more than f_unity the gain of op-amp becomes less than 1.
TRUE
FALSE

⇒ In figure the bridge is balanced when Z₄
120∠70°
187.5∠ - 10°
187.5∠ - 70°
333.3∠ - 70°

⇒ In a platinum RTD, the change in resistance for a temperature rise of 50° C is about
0.02
0.1
0.2
0.4

⇒ V_R at t < T, t = &in
500e^-40x10⁴t, 0
100e^-40x10³t, 0
100e^-40x10⁶t, 0
100e^-40x10⁴t, 0

⇒ The full form of the abbreviations TTL and CMOS in reference to logic families are
Triple Transistor Logic and Chip Metal Oxide Semiconductor
Tristate Transistor Logic and Chip Metal Oxide Semiconductor
Transistor Transistor logic and Complementary Metal Oxide Semiconductor
Trisate Transistor Logic and Complementary Metal Oxide Silicon

⇒ Which SNR denotes excellent picture quality in TV?
50 dB
30 dB
15 dB
5 dB

⇒ Figure shows an RC circuit. The magnitude plot V₂/V_{1will rise exponentially to R₂/(R₁ + R₂) as ω → ∞
will rise linearly to R₂/(R₁ + R₂) as ω → ∞
will decrease to zero as ω → ∞
will rise 1 at ω = 0 and then decrease as ω → ∞}

⇒ Which of the following is the common feature between FETs and bipolars?
Have low input impedance
Have low voltage gain
Are difficult to bias
None of them

⇒ Maxterm designation for A + B + C is
M₀
M₁
M₃
M₄

⇒ The rule that resistivity of conductors can be separated into two parts viz. temperature independent and temperature dependent is known as
Matthiessen's rule
Debye rule
Curie rule
Onne's rule

⇒ The Table given below is the mark obtained by 2 students in 8 different subjec
-0.4748
0.4748
-0.0338
0.0338

⇒ Which of the following instructions in 8085 does not belong to data transfer group?
LDA addr
STA addr
XCHG
SUB r

⇒ The temperature of cathode is increased from 2500K to 2600K. The increase in thermionic emission current is about
0.001
0.04
0.5
1.5

⇒ In the circuit of figur
I₁ will always lag I₃
I₂ may be in phase or lag I₃
I₃ will always lag I₂
I₂ and I₃ will be in phase

⇒ The resonance frequency is
ω_r = a
ω_r = b
ω_r = k
ω_r = ba

⇒ The sensitivity of electromagnetic digital flow meter can be increased by increasing
circumferential width of rotor teeth
radial depth of rotor teeth
thickness of rotor teeth
number of teeth

⇒

Match the following:

	List I		List II
A.	Very low response at very high frequencies	1.	Low-pass system
B.	Over shoot	2.	Velocity damping
C.	Synchro-control transformer output	3.	Natural frequency
		4.	Phase-sensitive modulation
		5.	Damping ratio

A-1, B-5, C-4
A-3, B-2, C-4
A-2, B-5, C-4
A-4, B-1, C-3

⇒ What is the frequency of audio modulation?
1000 Hz
2000 Hz
3000 Hz
2000 kHz

⇒ In figure, the current after a long time after closing of switc
0.0416666666666667
0.0833333333333333
0
infinity

⇒ The expression Y = pM (0, 1, 3, 4) is
POS
SOP
Hybrid
none of the above

⇒ Which mode is usually preferred for cascading?
CE
CB
CC
Any of the above