Question is ⇒ Bode magnitude plot is drawn between, Options are ⇒ (A) magnitude of network function and ω, (B) dB magnitude and log ω, (C) dB magnitude and ω, (D) loge (magnitude) and log ω, (E) , Leave your comments or Download question paper.

Question is ⇒ Bode magnitude plot is drawn between, Options are ⇒ (A) magnitude of network function and ω, (B) dB magnitude and log ω, (C) dB magnitude and ω, (D) loge (magnitude) and log ω, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Bode magnitude plot is drawn between
A.	magnitude of network function and ω [Wrong Answer]
B.	dB magnitude and log ω [Correct Answer]
C.	dB magnitude and ω [Wrong Answer]
D.	log_e (magnitude) and log ω [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Dielectric constant is independent of temperature unless the temperature is extremely high.

Reason (R): For normal temperatures the number of atoms per unit volume is constant.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The use of coaxial microwave line should be restricted to frequencies
below cut off frequency of TE₁₁ mode
above cut off frequency of TE₁₁ mode
at frequencies much lower than cut off frequency of TE₁₁ mode
at frequencies much higher than cut off frequency of TE₁₁ mode

⇒ For the network shown below, determine f_Hi and f_HO, if, r₀ = ∞, C_be = 36 Pf, C_bc = 4 Pf, C_ce = 1 Pf, C_wo = 8 Pf, C_wi = 6 Pf<
738.24 KHz, 8.6 MHz
781.2 KHz, 10.6 MHz
838.32 KHz, 9.2 MHz
938.24 KHz, 8.2 MHz

⇒ The current rating of a cable depends on
length of cable
diameter of cable
both length and diameter of cable
none of the above

⇒ Which of the following lines behaves as infinite line?
a line terminated in inductance
a line terminated in capacitance
a short line
a line terminated in z₀

⇒ In the given fi
42737
42739
2
1

⇒ e^-3^t is a
energy signal
power signal
Both (a) and (b)
none

⇒ The typical squelch circuit
cuts off an IF amplifier when the AGC is maximum
cuts off an IF amplifier when the AGC is minimum
cuts off an audio amplifier when the carrier is absent
eliminates the RF interference when the signal is weak

⇒ When a ferromagnetic substance is magnetised, there are small changes in its dimensions. This phenomenon is called
hysteresis
magnetostriction
diamagnetism
bipolar relaxation

⇒ In push button type telephone set, pressing a button generates
one frequency
two high frequencies
two low frequencies
one low frequency and one high frequency

⇒ The equivalent inductance measured between the terminals 1 and 2 for the circuit shown in the figur
L₁ + L₂ + M
L₁ + L₂ - M
L₁ + L₂ + 2M
L₁ + L₂ - 2M

⇒ In the dimension statement DIMENSION A (50, 50), K (100, 100) the total number of locations reserved will be
2500
100000
125000
250000

⇒ Figure represen
Esaki diode
Triac
Varactor
Gunn diode

⇒ The output data lines of microprocessor and memories are usually tristated because
more than one device can transmit information over the data bus by enabling only one device at a time
more than one device can transmit information over the data bus at the same time
the data lines can be multiplexed for both I/P and O/P
it increases the speed of data transfers over the data bus

⇒ The braking torque in single phase energy meter is proportional to speed of disc.
TRUE
FALSE

⇒ For the circuit of figure the input and output Miller resistances
5 kΩ each
1 ohm and 5 kΩ respectively
5 kΩ and 1 ohm respectively
1 ohm each

⇒ Two coil have their axis perpendicular to each other. The coefficient of coupling k is
1
0.5
more than 0 but less than 1
0

⇒ An atom of a rare gas is placed is an electric field E. Then
the nucleus will be shifted in the direction of E by an amount which is proportional to E.
the nucleus will not be shifted.
the nucleus will be shifted in the direction of E by an amount which is independent of E.
the nucleus will be shifted in a direction opposite to that of E.

⇒ For an RC admittance function
the lowest critical frequency is a zero
the highest critical frequency is a pole
the lowest critical frequency is zero and the highest critical frequency is a pole
the lowest critical frequency is a pole

⇒ In a NAND SR latch S = R = 1. Then
Q = 1, Q = 0
Q = 0, Q = 1
both Q and Q will be same as before
the latch will be set

⇒ In a second order undamped system, the poles are on
positive real axis
imaginary axis
negative real axis
either (a) or (c)

⇒ A steel bar needs 1200 AT to magnetise it. The voltage that must be applied to the magnetising coil of 100 turns and 10 Ω resistance is __________ volt.
120
12
1200
10

⇒ The maximum effective aperture of λ/2 (half-wave) antenna is
0.013 λ²
0.13 λ²
1.3 λ²
13 λ²

⇒ The logic operations of the two circuits given below
complementary
identical
entirely different
none of these

⇒ In a series circuit with fixed R and variable X_L, the current locus lies in the fourth quadrant.
TRUE
FALSE

⇒ Which of the following is a disadvantage of Vestigial Sideband (VSB) system?
Low video frequencies are attenuated
Bandwidth is conserved resulting in a saving of 2 MHz per channel over DSB system
It results in a power boost of two video frequencies
It possess the advantages of both DSB and SSB system

⇒
Assertion (A): A dual converter may be circulating current type or non circulating current type.
Reason (R): In circulating current dual converter only one converter can be operated at one time.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following is not advantage of FM over AM?
Noise immunity
Capture effect
Fidelity
Spluttering effect

⇒
Assertion (A): Doping level in extrinsic semiconductors is very small.
Reason (R): Additional of impurity in the ratio of 1 part in 10⁸ parts increases the number of charge carriers by about 20.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ For signal diodes the PIV rating is usually in the range
1 V to 10V
10 V to 30V
30 V to 150V
150 V to 400V

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math