Question is ⇒ Bit is a unit of, Options are ⇒ (A) entropy, (B) information, (C) channel capacity, (D) rate of information, (E) , Leave your comments or Download question paper.

Question is ⇒ Bit is a unit of, Options are ⇒ (A) entropy, (B) information, (C) channel capacity, (D) rate of information, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Bit is a unit of
A.	entropy [Wrong Answer]
B.	information [Correct Answer]
C.	channel capacity [Wrong Answer]
D.	rate of information [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Two sinusoidal signals of equal amplitude and frequency are applied to X and Y plate of CRO respectively. The observed Lissajous pattern is a straight line. The phase shift between signals is
zero
90°
either zero or 180°
either 90° or 270°

⇒ In one time constant, the current in a circuit reaches __________ percent of its final value.
10
37
63
85

⇒ In 8085, which instructions are useful for writing and using subroutines?
CALL
RET
CALL and RET
none of the above

⇒ The superposition theorem is applicable to
linear, non-linear and time variant responses
linear and non-linear resistors only
linear responses only
none of the above

⇒ The memory hierarchy in microprocessor based system is
register, cache, primary, mass, off line back up
cache, register, primary, mass, off line back up
cache, register, mass, primary, off line back up
register, cache, mass, primary, off line back up

⇒ The pointer of an indicating instrument should be
very light
very heavy
neither heavy nor light
heavy

⇒ The complement of exclusive OR function is
AB + A B
AB + A B
A B + A
AB + A B

⇒ When an ac circuit has sources of different frequencies, the only method of analysis is superposition theorem.
TRUE
FALSE

⇒ In parallel in-parallel out shift register all bits are loaded and read simultaneously.
TRUE
FALSE

⇒ In an Anderson bridge the unknown inductance is measured in terms of
known inductance and resistance
known inductance
known capacitance and resistance
known capacitance

⇒ Common emitter transistor has
high current and high voltage gain
low current gain and low voltage gain
high current gain and low voltage gain
low current and voltage gain

⇒ If a 'live' conductor of a public supply touches earth metal
supply voltage will increase
supply voltage will decrease
no current will flow
current will flow to earth

⇒ For an m-derived filter, attenuation is infinite when f = f_∞.
TRUE
FALSE

⇒ In the figure circuit, V₁ = 40 V. When R is 10 Ω. When R is zero, the value of V₂ wil
40 V
30 V
20 V
10 V

⇒ The service area of a TV transmitter is a little beyond radio horizon.
TRUE
FALSE

⇒

Assertion (A): A half wave controlled rectifier has poorer efficiency and higher ripple factor than a full wave controlled rectifier.

Reason (R): The use of a freewheeling diode in half wave controlled rectifier circuit improves the waveform of load current and circuit power factor.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ When large amount of power is required, a push pull amplifier is designed for operation as
class A
class B
class C
class AB

⇒ Some typical examples of macroscopic quantities are
conductivity
µ_r
dielectric constant
all of the above

⇒ The common-drain amplifier, better known as the source follower, has a voltage gain __________ and the output signal is __________ with the input signal.
approaching unity, in phase
approaching unity, out of phase
is very high, in phase
is very high, in reverse phase

⇒ If f_h(t) is Hilbert transform of f(t), then Hilbert transform of f_h(t) is
-f(t)
+f(t)
f²(t)
f(t)

⇒ In an amplifier the stray capacitances assume impedance at low frequencies
TRUE
FALSE

⇒ Class A and class B chopper
operate in first quadrant
operate in second quadrant
class A chopper operates in first quadrant while class B operates in second quadrant
may operate in either first or second quadrant

⇒

Assertion (A): Hall effect is used to find the type of semiconductor.

Reason (R): When a specimen of semiconductor carrying current I lies in a magnetic field the force on electrons and holes is in opposite directions.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In calculating input impedance, the load impedance is considered to be connected at the output.
TRUE
FALSE

⇒ In a current transformers
the number of turns in primary and secondary windings are nearly equal
the number of primary turns is very small as compared to number of secondary turns.
the number of secondary turns is very small as compared to the number of primary turns
either (a) or (c).

⇒ The diffusion current is proportional to
applied electric field
concentration gradient of charge carrier
square of the electric field
cube of the applied electric field

⇒ A high resistance was measured by loss of charge method. The voltmeter resistance was 10¹⁰ ohms. The calculation gave the value of unknown resistance as 0.8 x 10⁹ ohms. The true value of resistance is
0.8 x 10⁹ Ω
less than 0.8 x 10⁹ Ω
more than 0.8 x 10⁹ Ω
either (b) or (c)

⇒ So-called 'grounded' antennas are often found insulated from the ground electrically.
TRUE
FALSE

⇒ In modern MOSFET_S, the material used for the gate is
high purity silicon
high purity silica
heavily doped polycrystalline silicon
epitaxial grown silicon

⇒ Piezoelectric quartz crystal resonators find application where
signal amplification is required
rectification of the signal is required
signal frequency control is required
modulation of signal is required