Question is ⇒ Bipolar signalling uses the following bits, Options are ⇒ (A) -1, +1, (B) -1, 0, +1, (C) 0, 1, (D) -1, 0, (E) , Leave your comments or Download question paper.

Question is ⇒ Bipolar signalling uses the following bits, Options are ⇒ (A) -1, +1, (B) -1, 0, +1, (C) 0, 1, (D) -1, 0, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Bipolar signalling uses the following bits
A.	-1, +1 [Wrong Answer]
B.	-1, 0, +1 [Correct Answer]
C.	0, 1 [Wrong Answer]
D.	-1, 0 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the real expression in Pascal language XZ and MP + K
XZ + Y and MP + K
(MP + K + X) / Y
Y / (MP + K)

⇒ Consider the following statement: At finite temperature, magnetic dipoles in a material are randomly oriented giving low magnetization. When magnetic field H is applied, the magnetization?

Increases with H
Decreases with H
Decreases with temp for constant H

Which of the statement given above is/are correct?
1
2
2, 3
1 and 3

⇒ The number of operator to accomplish basic arithmetic in Java is
4
5
6
7

⇒ A Hartley oscillator uses
a tapped capacitor
a tapped inductor
a tapped inductor for inductive feedback
none of the above

⇒ The mean life time of the minority carriers is in the range of a few
seconds
milli seconds
micro seconds
nano seconds

⇒ The important postulate arising out of Maxwell's modification of Ampere's law is
a changing magnetic field produces an electric field
a changing electric field produces a magnetic field
a motional e.m.f. is produced by a coil moving in a magnetic field
a steady current produce a magnetic field

⇒ In which function is each term known as maxterm?
SOP
POS
Hybrid
SOP and Hybrid

⇒ Pulse stuffing is used in
synchronous TDM
asynchronous TDM
Any TDM
All

⇒ In a single phase full wave regulator feeding an R-L load, the power factor angle of load is θ. The range of control of firing angle a is
0 ≤ a ≤ p
θ ≤ a ≤ p
0 ≤ a ≤ (p - θ)
θ ≤ a ≤ (p + θ)

⇒ The noise margin of a TTL gate is about
0.2 V
0.4 V
0.6 V
0.8 V

⇒ In the analogy between electric and magnetic circuits permeability is analogous to
resistivity
conductivity
electric field intensity
current density

⇒ In 8085, the pairing of registers B, C, D, E, H, L is
B - C, D - E, H - L
B - D, C - E, H - L
B - C, D - L, H - E
B - H, D - E, C - L

⇒ The parallel RLC circuit shown in figure is in resonance
I_R < 1 mA
| I_R + I_L | > 1 mA
| I_R + I_L | < 1 mA
| I_L + I_C | > 1 mA

⇒ The value of current read by ideal ammeter A in figure is __________ amp
0
3
2.5
5

⇒ In the circuit shown in figure, maximum power will be transferred
Z_L = 13 - j 9
Z_L = 13 + j 9
Z_L = 9 - j 13
Z_L = 9 + j 13

⇒ 1111 + 11111 =
101111
101110
111111
11111

⇒ In a synchro transmitter-control transformer, the voltage induced in rotor winding of control transformer is zero when the angular displacement between rotors of transmitter and transformer is
0°
90°
180°
either (a) or (c)

⇒ A 1000 kHz carrier is simultaneously modulated with 300 Hz, 800 Hz and 2 kHz audio sine waves. Which of the following frequency is least likely to be present in the output?
1002 kHz
1000 kHz
999.2 kHz
998.0 kHz

⇒ The time base of a high frequency CRO whose screen diameter is 10 cm is set at 10 μ sec/cm. The lowest frequency which can be fully displayed on the screen is
more than 100 kHz
equal to 100 kHz
equal to 10 kHz
less than 10 kHz

⇒ A constant k band stop filter has cutoff frequencies of 1000 and 4000 Hz. The attenuation will be maximum when frequency is
4000 Hz
3000 Hz
2000 Hz
1000 Hz

⇒ Intrinsic or characteristic impedance of free space has a value of
120 ohm
73 ohm
73 ε ohm
120 ε ohm

⇒ A push pull amplifier balance out
odd harmonics
even harmonics
both odd as well as even harmonics
neither odd nor even harmonics

⇒ As per Boolean algebra, inputs can be interchanged in
OR gates
AND gates
both OR and AND gates
none of the above

⇒

Assertion (A): Power transistor has lower switching time than SCR

Reason (R): Power transistor has greater switching time than SCR

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The root locus branches
start from open loop poles and terminate at zeros
start from open loop zeros and terminate at poles
may start from pole or zero and terminate at another pole or zero
none of the above

⇒ For the differential equation (D³ - D² + D -1) [y(t)] = 0 the root of auxiliary equation
-j, j, 1
-j, j, 2
1, 2, j
1, 2, -j

⇒ The magnetic field due to current I equals
I/2 pr
I/4 pr
I²/2 pr
I²/4 pr

⇒ The HV supply to a TV receiver is 25 kV and the total beam current for the three electron guns is 2000 μA. The power handled by IHVT is
5W
0.5 W
50 W
500 W

⇒ Which is correct for a vacuum triode?
μ = r_pg_m
r_p = μg_m
g_m = μr_p
r_pg_m

⇒ The skin depth at 1000 MHz as compared to that at 500 MHz is
2
12
0.707
0.5