Question is ⇒ BCD input 1000 is fed to a 7 segment display through a BCD to 7 segment decoder/driver. The segments which will lit up are, Options are ⇒ (A) a, b, d, (B) a, b, c, (C) all, (D) a, b, g, c, d, (E) , Leave your comments or Download question paper.

Question is ⇒ BCD input 1000 is fed to a 7 segment display through a BCD to 7 segment decoder/driver. The segments which will lit up are, Options are ⇒ (A) a, b, d, (B) a, b, c, (C) all, (D) a, b, g, c, d, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	BCD input 1000 is fed to a 7 segment display through a BCD to 7 segment decoder/driver. The segments which will lit up are
A.	a, b, d [Wrong Answer]
B.	a, b, c [Wrong Answer]
C.	all [Correct Answer]
D.	a, b, g, c, d [Wrong Answer]
View Answer 5 -6 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An SCR has a turn on time of 4 μs. The gate pulse should have a duration of about
2 μs
5 μs
20 μs
50 μs

⇒ In a material, the Fermi level is located between the centre of the forbidden band and the conduction band. Then what is that material?
A p-type semiconductor
An n-type semiconductor
An intrinsic semiconductor
An insulator

⇒ What is the address space of 8086 CPU?
One Megabyte
256 Kilobytes
1 K Megabytes
64 Kilobytes

⇒ With respect to the following 555 timer circuit what will be the value of R_A and R such that the LED turns on for a duration of 10 ms every time it receives negative trigger pulse. LED operating current = 20 mA, V_f = 1.4 V, Vo _on = 13.4 V and C = 0.22 nf
41.4 KΩ, 600 Ω
45 KΩ, 630 Ω
43.5 KΩ, 580 Ω
44.9 KΩ, 600 Ω

⇒ If average correlation between v₁(t) and v₂(t) is R₁₂(t) and average correlation between v₂(t) and v₁(t) is R₂₁(t) then
R₁₂(t) = R₂₁(t)
R₂₁(t) = R₁₂(t)
R₁₂(t) = - R₂₁(t)
none of these

⇒ Given figure is the voltage transfer characteristi
an N MOS inverter with enhanced mode transistor as load
an N MOS inverter with depletion mode transistor as load
a CMOS inverter
BJT inverter

⇒ Under ordinary circumstances, impulse noise can be reduced in
FM only
AM only
both AM and FM
none of the above

⇒ The timing difference between a slow memory and fast processor can be resolved if
processor is capable of waiting
external buffer is used
either (a) or (b)
neither (a) nor (b)

⇒ Find R_L for maximum power trans
3 Ω
1.125 Ω
4.1785 Ω
None of these

⇒ The 8085 instruction LDA FFA is an example of
Direct addressing
Register addressing
Immediate addressing
Register indirect addressing

⇒ The turn off time of a bipolar transistor is about
0.5 ns
10 ns
70 ns
150 ns

⇒ What can be the maximum dimension of an array in C language program?
3
4
5
It is compiler dependent

⇒ In a directional coupler
isolation (dB) equals coupling plus directivity
coupling (dB) equals isolation plus directivity
directivity (dB) equals isolation plus coupling
isolation (dB) equals (coupling) (directivity)

⇒ A magnet does not attract
nickel
iron
copper
iron and copper

⇒ The resonant frequency of a series resonant circuit is
arithmetic mean of half power frequencies
independent of inductance of the circuit
independent of capacitance of the circuit
geometric mean of half power frequencies

⇒ An A/D converter uses for reference purposes
DC voltage
a saw tooth generator
set of keys
a flip-flop

⇒ The circuit shown in figure
oscillate at 456 kHz
oscillate at 228 kHz
oscillate at microwave frequency
not oscillate

⇒ Coupling and bypass filters can be a source of
low-frequency parasitics
high-frequency parasitics
carrier frequency parasitics
none of the above

⇒ The radiation resistance of a rod tubing antenna is
55 Ω to 60 Ω
60 to 100 Ω
0 to 377 Ω
60 to 200 Ω

⇒ Which op-amp circuit uses a diode as one of the circuit components?
Integrating amplifier
Differentiating amplifier
Logarithmic amplifier
Summing amplifier

⇒ A series RLC circuit has a resonant frequency of 2000 Hz. The maximum voltage across C is likely to occur at a frequency of about
1000 Hz
4000 Hz
2025 Hz
1975 Hz

⇒ FET can used in
buffer amplifier circuits
cascade amplifier circuits
digital circuits
all of the above

⇒ The useful operational life of INSAT-IB (launched in 1983) is expected to end by
1992-93
1991-92
1989-90
1993-94

⇒ A resistor is rated at 0.75 watt, 1 kΩ. Its current rating is
1 mA
27.386 mA
1.268 mA
5.393 mA

⇒ Which of the following components is essential for a voltage multiplier circuit?
Resistor
Inductor
Capacitor
Both (a) and (c)

⇒ The rule that resistivity of conductors can be separated into two parts viz. temperature independent and temperature dependent is known as
Matthiessen's rule
Debye rule
Curie rule
Onne's rule

⇒ Highest resistivity of the following is
nichrome
constantan
metal
manganin

⇒ The value of parameter r_e used in r_e transistor model
increases with increase in temperature
decreases with increase in temperature
is not affected by increase in temperature
either (b) or (c)

⇒ Decimal 8 in excess-3 code =
1000
1001
1011
1111

⇒
Match the following:
List I List II
A. DMA controller 1. Interface between computer and video display adapter
B. CKT controller 2. Used to read data directly from disk into directly memory
C. Interrupt controller 3. Supervises the operation of control signal

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-2, C-1
A-2, B-1, C-3

	List I		List II
A.	DMA controller	1.	Interface between computer and video display adapter
B.	CKT controller	2.	Used to read data directly from disk into directly memory
C.	Interrupt controller	3.	Supervises the operation of control signal

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math