Question is ⇒ Automatic sensitivity control by target voltage control is easily possible in, Options are ⇒ (A) Vidicon, (B) Plumbicon, (C) New vicon, (D) both (b) and (c), (E) , Leave your comments or Download question paper.

Question is ⇒ Automatic sensitivity control by target voltage control is easily possible in, Options are ⇒ (A) Vidicon, (B) Plumbicon, (C) New vicon, (D) both (b) and (c), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Automatic sensitivity control by target voltage control is easily possible in
A.	Vidicon [Correct Answer]
B.	Plumbicon [Wrong Answer]
C.	New vicon [Wrong Answer]
D.	both (b) and (c) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The main advantage of CMOS circuit is
high gain
high output impedance
low power consumption
high gain and high output impedance

⇒ A 0-200 V voltmeter has a sensitivity of 1 kΩ per volt. The resistance of voltmeter is
1 kΩ
200 kΩ
100 kΩ
50 kΩ

⇒ The 1150 kg geosynchronous satellite INSAT-IA parked 36000 km above India had greatly improved India's
intelligence gathering capacity
domestic communications
meteorological capability
both (b) and (c)

⇒ A typical error rate on satellite circuits is one bit error in
10⁷
10³
10²
10¹⁰

⇒ A XOR gate has inputs A and B and output Y. Then the output equation is
Y = AB
Y = AB + A B
Y = A B + A B
Y = A B + A B

⇒ Consider an angle modulated si
10W
18W
20W
28W

⇒ Peak inverse voltage will be highest for
half wave rectifier
full wave rectifier
bridge rectifier
three phase full wave rectifier

⇒ When Z₁ << Z, The circuit of figure work
inverting amplifier
Schmitt trigger
non-inverting amplifier
source follower

⇒ Which of the following diode is designed to operate in the breakdown region?
Signal diode
Power diode
Zener diode
None of the above

⇒ A Darlington pair is used for
low distortion
high frequency range
high power gain
high current gain

⇒ Electrons within a metal have energy levels from zero to Fermi level E_F.
TRUE
FALSE

⇒ In a current mirror
the i - v curve of compensating diode is similar to collector curve of transistor
the i - v curve of compensating diode is similar to transconductance curve of transistor
either (a) or (b)
neither (a) nor (b)

⇒ A white noise X(t) with two-sided power spectral density 1 x 10^-10 W/Hz is input to a filter whose magnitude squared response is shown be
5 x 10^-7W
1 x 10^-6W
2 x 10^-6W
5 x 10^-6W

⇒ Super high frequency means more than 3000 MHz.
TRUE
FALSE

⇒ From an n channel JFET for V_DS constant and if V_GS is made more negative, pinch off would occur at
higher value of drain current
saturation value of drain current
zero drain current
gate current equal to drain current

⇒

Assertion (A): An inverter does not require forced commutation

Reason (R): A series inverter is a forced commutation inverter.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following is not a valid variable name in C?
1 a
a 1 2
a b 123
a b c 123

⇒ In the given figure the ratio T/d is the duty fac
TRUE
FALSE

⇒ In a class C operation V_CC = 30 V and V_CE(sat) = 2 V. The efficiency is
0.9375
0.88
0.0666
0.0333

⇒ In the given figure shows a negative logic AND gate. If positive logic is used this gate is equivalen
AND gate
OR gate
NOR gate
NAND gate

⇒ For the wave shown in figure, the average valu
14.14 A
15 A
17.17 A
19.19 A

⇒ A full wave bridge diode rectifier uses diodes having forward resistance of 50 ohms each. The load resistance is also 50 ohms. The voltage regulations is
0.2
0.5
1
2

⇒ The derating factor, for ambient temperature higher than specified, for a transistor is about
2.5 mW/°C
0.5 mW/°C
10 mW/°C
20 mW/°C

⇒ The D.C. alpha(a) of a transistor is approximately
unity
10 to 50
100 to 500
1000 to 5000

⇒ In a bipolar transistor, the emitter base junction has
forward bias
reverse bias
zero bias
zero or reverse bias

⇒ Which of the following expressions is true for apparent power in an A.C. circuit?
VI cos Φ
V_av x I_av
V_r.m.s x I_r.m.s
V_peak x I_peak

⇒ When the modulating frequency is doubled, the modulation index is halved and the modulating voltage remains constant. The modulation system is
FM
AM
phase modulation
none of the above

⇒ If temperature increases by about 50°, the resistance of thermistor changes to
half of its initial value
twice of its initial value
eight times of its initial value
one eight of its initial value

⇒ Maxwell's divergence equation for the magnetic field is given as
∇ . B = 0
∇² . B = 0
∇ . B = constant
∇² . B = constant

⇒ A line has an attenuation of 0.054 Np/m. The attenuation in decibels is
4.7 dB/m
0.47 dB/m
0.54 dB/m
5.4 dB/m