Question is ⇒ At the peak of negative half cycle in fi, Options are ⇒ (A) diode A is forward biased and diode B is reverse biased, (B) both diodes are reverse biased, (C) both diodes are forward biased, (D) diode A is reverse biased and diode B is forward biased, (E) , Leave your comments or Download question paper.

Question is ⇒ At the peak of negative half cycle in fi, Options are ⇒ (A) diode A is forward biased and diode B is reverse biased, (B) both diodes are reverse biased, (C) both diodes are forward biased, (D) diode A is reverse biased and diode B is forward biased, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	At the peak of negative half cycle in fi
A.	diode A is forward biased and diode B is reverse biased [Wrong Answer]
B.	both diodes are reverse biased [Wrong Answer]
C.	both diodes are forward biased [Wrong Answer]
D.	diode A is reverse biased and diode B is forward biased [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If absolute potential of A is - 8 V and that of B is - 16 V, V_AB is equal to
24 V
8 V
- 8 V
- 24 V

⇒ Natural commutation can be used in :
DC circuits only
AC circuits only
both AC and DC circuits
none of the above

⇒ Master control facility (MCF) for INSAT-2 series satellites is located at
Madras
New Delhi
Leh
Hassan

⇒ A circuit is fed by two sources of the same frequency and values 100 ∠0° V and 20 ∠30°V. The current in a particular branch is 5 ∠19° A. If the magnitudes of the sources and changed to 200 ∠0° V and 40 ∠30° V, the current in that branch should be
5 ∠19° A
10 ∠19° A
10 ∠38° A
10 ∠9.5° A

⇒ In a parallel inverter
the commutating capacitor C is across the primary of transformer and the load is across the secondary
the commutating capacitor and load are connected across the secondary of transformer
the commutating capacitor C and load are connected in series and the combination is across the secondary of transformer
none of the above

⇒ In a 4 bit parallel in parallel out shift register A = 1, B = 1, C = 0, D = 1. The data output after 3 clock pulses is
1101
1001
101
1

⇒ Which of the following pulse modulation is analog?
PCM
Differential PCM
PWM
Delta

⇒ In a ratio detector
the linearity is worse than in a phase discriminator
the output is twice that obtainable from a similar phase discriminator
stabilization against signal strength variations is provided
the circuit is the same as in a discriminator, except that the diodes are reversed

⇒ Data from a satellite is received in serial form (1 bit after another). If this data is coming at a 5 MHz rate and if the clock frequency is 5 MHz how long will it take to serially load a word in a 32-bit shift register?
1.6ms
3.2ms
6.4ms
12.8ms

⇒ A Maxwell's bridge has the unknown inductance in one arm and resistance in the other three arms.
TRUE
FALSE

⇒ In two level logic, logic race does not occur.
TRUE
FALSE

⇒ In a bipolar transistor, the base collector junction has
forward bias
reverse bias
zero bias
zero or forward bias

⇒ Switching systems
are limited to small data networks
require additional lines
are not used in data system
improve the efficiency of data transfer

⇒ If J, I and a denote current density, current and area of cross section of a conductor, then
J = Ia
J = I/a²
J = I/a
J = Ia²

⇒ In a series RLC circuit, the current at resonance is I₀ the total energy stored in the circuit at resonance is
LI₀²
2 LI₀²
2 LI₀²
0.5 LI²

⇒ Which of the following is true?
During addition if the carry into and carry out of the sign bit do not match then an overflow has occurred
During addition if the carry into and carry out of the sign bit don't match then an overflow or underflow has occurred
During addition if the carry into and carry out of the sign bit match then an overflow or underflow has occurred
During addition if the carry into and carry out of the sign bit match then an overflow has occurred

⇒ A standard waveguide W R90 has inside wall dimensions of a = 2.286 cm and b = 1.016 cm. What is the cut-off wavelength for TE₀₁ mode?
4.572 cm
2.286 cm
2.032 cm
1.857 cm

⇒

Match the following:

	List I (Operator)		List II (Description)
A.	& &	1.	Assignment
B.	\| \|	2.	Logical AND
C.	=	3.	Logical OR

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-2, C-1
A-1, B-3, C-2

⇒ The circuit of the given figure gives the output YAB
A + B
A B
A + B

⇒ The difference between phase and frequency modulation
is purely of academic interest
lies in the different definitions of the modulation index
lies in the poor audio response of phase modulation
is too great to make the two systems compatible

⇒ The disadvantage of direct coupled amplifiers is
drift
large size of transistor
low voltage gain
both (b) and (c)

⇒ For a standard 2nd order system the maximum overshoot is 10% to an unit step input. If the magnitude of the input is doubled, then maximum overshoot and percentage of maximum overshoot is:
maximum overshoot doubles and percentage of maximum overshoot is less than double
maximum overshoot doubles and percentage of maximum overshoot do not change
maximum overshoot remain same and percentage of maximum overshoot is double
maximum overshoot more than double and percentage of maximum overshoot is less than double

⇒ Logic analyser is
a multichannel oscilloscope
similar to logic pulser
similar to current tracer
none of the above

⇒ In which function is each term known as minterm?
SOP
POS
Hybrid
Both SOP and POS

⇒ For decimal numbe'r 13.5, the floating point representation in 4 byte excess 128 code is
01101100 00000000 00000000 10000100
00000000 01101100 00000000 10000100
00000000 01101100 10000100 00000000
01101100 00000000 10000100 00000000

⇒ The most commonly used devices for differencing and amplification, in control systems, are
BJT amplifiers
FET amplifiers
operational amplifiers
either (a) or (b)

⇒ A single phase full converter can operate in
4 quadrants
3 quadrants
2 quadrants
1 quadrant

⇒ Evaluate the value of 2 [u (t - 1) - u (1 - 2t)] (u ( t + 1) + u (t)) at t = 3 sec.
0
4
∞
1

⇒ An RLC series circuit has R = 7.07 Ω, L = .707 H and C = 7.07 μF. At Half power frequencies the circuit impedance is likely to be
7.07 Ω
10 Ω
14.14 Ω
20 Ω

⇒ Which of them radiates emission?
LED only
LCD only
Both LED and LCD
Neither LED nor LCD

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math