Question is ⇒ At midband frequencies the coupling capacitor in RC coupled CE amplifier may be considered as, Options are ⇒ (A) open circuit, (B) short circuit, (C) a reactance equal to load resistance, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ At midband frequencies the coupling capacitor in RC coupled CE amplifier may be considered as, Options are ⇒ (A) open circuit, (B) short circuit, (C) a reactance equal to load resistance, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	At midband frequencies the coupling capacitor in RC coupled CE amplifier may be considered as
A.	open circuit [Wrong Answer]
B.	short circuit [Correct Answer]
C.	a reactance equal to load resistance [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the given figure, if R = X_C, voltage gai
0 dB
3 dB
-3 dB
20 dB

⇒ In a flip-flop with a NAND latch, a low R and a low S produces
active condition
inactive condition
race condition
dead condition

⇒ In graphical analysis of BJT amplifier the slope of ac line is more than that of dc load line.
TRUE
FALSE

⇒ An unmodulated voltage 10 V effective is applied to a dioxide detector in which load resistance is 4 x 10^-5 ohms. A micrometer shows that the rectified DC current in this resistance is 30 A. The efficiency of detection is
0.34
0.555
0.688
0.847

⇒ A dipole antenna was radiating with some excitation in free space radiating a certain amount of the power. If this antenna is immersed in a lake where water is non-dissipative but has a dielectric constant of 81, the radiated power with the same excitation will
decrease to finite non-zero value
remain the same
increase
decrease to zero

⇒ To protect an SCR against high di/dt we connect
a capacitance in series with SCR
a capacitance in parallel with SCR
an inductance in parallel with SCR
an inductance in series with SCR

⇒ The v-i characteristic of an element is shown in below figure the elemen
non-linear, active, non-bilateral
linear, active, non-bilateral
non-linear, passive, non-bilateral
non-linear, active, bilateral

⇒ The number of counter states which an 8 bit stair step A/D converter has to pass through before conversion takes place is equal to
1
8
255
256

⇒

Assertion (A): In 8085, the zero flag is set when ALU operation results in 0. If the result is not 0, this flag is reset.

Reason (R): In 8085 the S flag is set when the contents of accumulator become negative during execution of an instruction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which variety of copper has the best conductivity?
Pure annealed copper
Hard drawn copper
Induction hardened copper
Copper containing traces of silicon

⇒ In the circuit of figure the function of resistor R and diode D
to limit the current and to protect LED against over voltage
to limit the voltage and to protect LED against over current
to limit the current and protect LED against reverse breakdown voltage.
none of the above.

⇒ The function of interface circuit is
to match output conditions of driver with input conditions of load device
to match output conditions of load device with input conditions of driver
both (a) and (b)
neither (a) nor (b)

⇒ The internal structure of PL A is similar to
RAM
ROM
both RAM and ROM
neither RAM nor ROM

⇒ The noise performance of a square law demodulator of AM signal is
better than that of an envelope detector
better than that of a synchronous detector
identical with that of a synchronous detector
poorer than that of an envelope detector

⇒ A narrow band FM does not have the following feature
it has two sidebands
both sideband equal in magnitude
both sideband have same Phase Difference
it does not show Amplitude variation

⇒ The slew rate of an ideal op-amp is
very slow
slow
fast
infinitely fast

⇒ An RL series circuit has an impedance of 20 Ω when frequency is 25 Hz. At f= 50 Hz, the impedance will be
40 Ω
20 Ω
less than 40 W but more than 20 Ω
less than 20 W but more than 10 Ω

⇒ A signal x(n) = sin(ω₀n + φ) is the input to a linear time invariant system having a frequency response H(e^jω) If the O/P of the system is Ax(n -n₀), then the general form of H(e^jω) will be
- n₀ω₀ + β for any arbitrary real β
- n₀ω₀ + 2pk for any arbitrary integer k
n₀ω₀ + 2pk for any arbitrary integer k
- n₀ω₀ + φ

⇒ A casual LTI system is described by the difference equat
|a| = 2 |β| < 2
|a| > 2 |β| > 2
|a| < 2 any value of β
|β| < 2, any value of a

⇒ For a push pull circuit the most favoured biasing method is
self bias
emitter bias
diode bias
collector bias

⇒ If the functions w, x, y, z are as foll
w = z x = z
w = z, x = y
w = y
w = y = z

⇒ AM amplifier having noise figure of 20 dB and available power gain of 15 dB is followed by a mixer circuit having noise figure of 9 dB. The overall noise figure as referred to input in dB is
10.44
11.07
21.52
0.63

⇒ A voltage v(t) which is a gaussian ergodic random process witha mean of zero and a varance of 4 volt² is measured by a meter which first square and then reads its dc component. The reading will be
0
4
16
2

⇒ A single phase half wave converter is feeding a resistive load. Just before triggering, the voltage across thyristor is
zero
about 1 V
same as input voltage
twice the input voltage

⇒ 71₈ = __________ .
111000₂
111001₂
100001₂
110001₂

⇒ In a differential amplifier, CMRR can be improved by using an increased
emitter resistance
collector resistance
power supply voltages
source resistance

⇒ For an RC admittance function Y, the slope dY/dσ
is positive
is negative
may be positive or negative
0

⇒ A sinusoidal voltage amplitude modulates a carrier of peak value 5 kV. Each side band has an amplitude of 500 V. The modulation index is
0.1
0.2
0.4
0.8

⇒ A transmission line discontinuity is defined as any interruption in the uniformity of the line.
TRUE
FALSE

⇒ A single turn loop is situated in air, with a uniform magnetic field normal to its plane. The area of the loop is 5 m² and the rate of change of flux density is 2 Wb/m²/s. What is the emf appearing at the terminals of the loop?
-5 V
-2 V
-0.4 V
0 V