Question is ⇒ At a P-N junction, the potential barrier is due to the charges on either side of the junction, which consists of, Options are ⇒ (A) fixed donor and acceptor ions, (B) majority carriers only, (C) minority carriers only, (D) both majority and minority carriers, (E) , Leave your comments or Download question paper.

Question is ⇒ At a P-N junction, the potential barrier is due to the charges on either side of the junction, which consists of, Options are ⇒ (A) fixed donor and acceptor ions, (B) majority carriers only, (C) minority carriers only, (D) both majority and minority carriers, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	At a P-N junction, the potential barrier is due to the charges on either side of the junction, which consists of
A.	fixed donor and acceptor ions [Correct Answer]
B.	majority carriers only [Wrong Answer]
C.	minority carriers only [Wrong Answer]
D.	both majority and minority carriers [Wrong Answer]
View Answer 1 -5 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Measurement of Hall coefficient enables the determination of
transportation factor decreases and a increases
transportation factor increases and a increases
transportation factor increases and a decreases
transportation factor decreases and a decreases

⇒ In a single phase semi-converter the number of thyristors is
16
8
4
2

⇒ To measure an unknown ac voltage by an ac potentiometer it is desirable that supply for the potentiometer is taken
from a battery
from a source which is not the same as unknown voltage
from the same source as the unknown voltage
either (a) or (b)

⇒ The properties of JFET resemble those of
thermionic values
N-P-N transistors
P-N-P transistors
unijunction transistor

⇒ In PCM, the quantization noise depends on
sampling rate
signal power
number of quantization level
signal energy

⇒ In which of the following 8085 instructions is the CY flag complemented?
CMA
CMC
STC
RRC

⇒ In a series RLC circuit excited by e = E_m sin ωt is seen that LC < 1/ω². Then
I lags E
I leads E
I leads E are in phase
voltage across L and C are equal

⇒ Figure repres
Adder
Multiplier
Subtractor
Log Amplifier

⇒ In the circuit of figure the d
will conduct as the whole cycle
will conduct in the positive half cycle
will not conduct
will conduct from 30° to 150° in the positive half cycle

⇒ A voltage gain of a CE amplifier connected in collector to base configuration is 50. Collector to base resistor R_F = 1 kΩ, R_C = 4Ω, the O/P resistance R₀ =?
800 Ω
813 Ω
817 Ω
819 Ω

⇒ Consider the following program in Ba
60, 20, 20, 30, 10
10, 30, 20, 20, 60
60, 20, 30, 10, 20
60, 30, 10, 20, 20

⇒ The overall noise temperature T_e, absolute temperature T and noise figure F are related as
T_e = T(F - 1)
T_e = F(T - 1)
T = T_e(F - 1)
T_e = (T)(F)

⇒ Two wires A and B have the same cross-section area and are made of the same material. R_A = 600 Ω and R_B = 100 Ω. The number of times A is longer than B is
6
2
4
5

⇒ In a linear circuit, the superposition principle can be applied to calculate the
voltage and power
voltage and current
current and power
voltage, current and power

⇒ If it is desired to have low output impedance in an amplifier circuit then we should use
common collector circuit
common base circuit
common emitter circuit
either (b) or (c)

⇒ In the graphical analysis of an amplifier circuit, the slope of dc load line depends on
load resistance only
collector supply voltage only
both load resistance and collector supply voltage
none of the above

⇒ How many interrupts are there of 8085 μP?
4
5
6
8

⇒ Which of the following is true in a tape recorder?
Vow is due to variation in motor speed but flutter is due to some other reason
Both vow and flutter are due to variations in motor speed
Flutter is due to variation in motor speed but vow is due to some other reason
Neither vow nor flutter is due to variation in motor speed

⇒ In the given figure the time taken by the wave to make one round tri
10 ns
20 ns
30 ns
40 ns

⇒ Which binary addition is incorrect?
1101.1 + 1011.1 = 11001.0
101101 + 1101101 + 1100011
0.0011 + 0.1110 + 1.0001
1100.001 + 1011.011 = 10111.100

⇒ An amplifier without feedback has a voltage gain of 50, input resistance of 1 kΩ and output resistance of 2.5 kΩ. The input resistance of the current shunt -ve feedback amplifier using the above amplifier with a feedback factor of 0.2 is
1/11 kΩ
1/5 kΩ
5 kW
11 kW

⇒ The phase margin and damping ratio have no relation.
TRUE
FALSE

⇒

Assertion (A): Each memory chip has its own address latch.

Reason (R): ALE signal comes out of microprocessor 8085 and goes to memory chip.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ For the circuit of figure the input and output Miller resistances
5 kΩ each
1 ohm and 5 kΩ respectively
5 kΩ and 1 ohm respectively
1 ohm each

⇒ At very low frequencies a series R-C circuit behaves as almost purely __________ .
resistive
inductive
capacitive
none of the above

⇒ In the given circuit, the switch is open for a long time. At time t = 0, the switch is closed. What are the initial and final values of voltages across the induc
0 V and 0 V
0 V and 80 V
80 V and 0 V
80 V and 80 V

⇒ As per BIS, solid insulators are classified into 6 categories.
TRUE
FALSE

⇒ In a monolithic IC, resistors are formed from
ceramic material
manganin wire
P-type semiconductor
aluminium ribbon

⇒

Assertion (A): When light falls at junction of p-n photodiode, its p side becomes positive and n side becomes negative.

Reason (R): When a photodiode is short circuited, the current in the external circuit flows from p side to n side.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In intrinsic semiconductor, the fermi level
lies at the centre of forbidden energy gap
is near the conduction band
is near the valence band
may be anywhere in the forbidden energy gap