Question is ⇒ Assuming that <i>k</i> is an integer what would the result of following expression, Options are ⇒ (A) 8, (B) 7, (C) 7.5, (D) zero, (E) , Leave your comments or Download question paper.

Question is ⇒ Assuming that <i>k</i> is an integer what would the result of following expression, Options are ⇒ (A) 8, (B) 7, (C) 7.5, (D) zero, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Assuming that k is an integer what would the result of following expression
A.	8 [Correct Answer]
B.	7 [Wrong Answer]
C.	7.5 [Wrong Answer]
D.	zero [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ CMRR of a difference amplifier is equal to
(A_v')/(A_com)
A_v/A_com
A_com/A_v'
(A_v)/(A_com)²

⇒ Which rectifier has the best ratio of rectification?
Half wave rectifier
Full wave rectifier
Bridge rectifier
Three phase full wave rectifier

⇒ Computer virus can hide itself in a diskette but not in a hard disk.
TRUE
FALSE

⇒ The ripple factor from a capacitor filter __________ as the load resistance __________ .
decreases, decreases
decreases, increases
increases, decreases
increases, increases

⇒ A meter has a square law scale. For 2 A current the deflection in 90°. For a deflection of 45°, the current is
0.0416666666666667
1.5 A
1.414 A
1.61 A

⇒ The dc output voltage of the circui
4.3 V
1.369 V
3.87 V
1.94 V

⇒ In a class C amplifier, full cycle conductor of the current is achieved by employing
tuned circuit
transformers
complementary pair
Push pull configuration

⇒ For a voltage transfer function H(s), realizable by RLC network, the following statements are made

H(s) cannot have a pole at s = 0
H(s) cannot have a pole at s = ± j4
H(s) cannot have a pole at s = ∞
H(s) cannot have a pole at s = + 2

Of these statements
3 and 4 are correct
2 and 4 are correct
1 and 2 are correct
1 and 3 are correct

⇒ Resistivity is a property of a semiconductor that depends on
the atomic weight of the semiconductor
the atomic number of the semiconductor
the atomic nature of the semiconductor
the shape of the semiconductor

⇒ If temperature increases by about 50°, the resistance of thermistor changes to
half of its initial value
twice of its initial value
eight times of its initial value
one eight of its initial value

⇒ In an intrinsic semiconductor, at a given temperature T
the number of electrons-hole pairs generated per second due to thermal motion are equal to the number of electron-hole pairs lost per second due to recombination
the number of electron-hole pairs generated per second due to thermal motion is always less than the number of electron-hole pairs lost per second due to recombination
the number of electron hole pairs generated per second due to thermal motion is always more than the number of electron-hole pairs lost per second due to recombination
any of the above

⇒ The output of the circuit shown below will be of the frequ
125 Hz
250 Hz
500 Hz
750 Hz

⇒ In figure the dc emitter current of each transistor is a
4 mA
2 mA
3 mA
1 mA

⇒

Assertion (A): Most of actual systems are non-linear.

Reason (R): Non linearity may be due to saturation, dead zone, square law etc.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Which one of the following is a trivalent material?
Antimony
Phosphorus
Arsenic
Boron

⇒ Consider the following statem
2 and 3
1 only
2 and 4
none

⇒

Match the following:

	List I (Octal)		List II (Decimal number)
A.	35	1.	53
B.	65	2.	62
C.	54	3.	29
D.	76	4.	44

A-4, B-3, C-2, D-1
A-1, B-2, C-3, D-4
A-2, B-3, C-1, D-4
A-3, B-1, C-4, D-2

⇒ Which of the following is the poorest conductor of electricity?
Aluminium
Nichrome
Copper
All of the above

⇒ Which of the following Boolean algebra rules is correct?
A . A = 1
A + AB = A + B
A + A B = A + B
A(A + B) = B

⇒ In microwave detector used in laboratory measurements of relative power levels, standing wave ratio is about
0.1
1.25
5
10

⇒ The combination of registers in 8085 is B-C, D-E, H-L only.
TRUE
FALSE

⇒ For a short dipole having an effective length less than half the wavelength the radiation resistance is
proportional to length
proportional to square root of length
proportional to square of length
none of the above

⇒ In a lead acid battery
the numbers of positive and negative plates are equal
the number of positive plates may be equal to or more than the number of negative plates
the number of positive plates is more than the number of negative plates
the number of negative plates is more than the number of positive plates

⇒ In 8085 the instruction MOV A, B is an example of
Direct addressing
Immediate addressing
Register addressing
Register indirect addressing

⇒

Assertion (A): In p type semiconductor conduction is mainly due to holes.

Reason (R): In p type material the holes are majority carriers.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In the silicon BJT circuit shown below, assume that the emitter area of transistor Q1 is half that of transistor
0.5 mA
2 mA
9.3 mA
15 mA

⇒ An SSB-AM signal cannot be demodulated by
Balanced modulator
Complete phase shift generator
Diode balanced modulator
Product detector

⇒ For the same length of arrays, half power beam-width of binomial array
is equal to that of uniform arrays
is less than that of uniform array
is more than that of uniform array
is negligible as compared to that of uniform array

⇒ The distributors for residential areas are
single phase
three phase three wire
three phase 4 wire
(a) or (b)

⇒ In a moving iron voltmeter the coil has a resistance of 20 Ω and an inductance of 0.3 H. The swamping resistance in 2000 Ω. To ensure correct reading with dc as well as 50 Hz ac, the value of capacitor to be connected in parallel with swamping resistance should be
0.0125 μF
0.0311 μF
0.0521 μF
0.0622 μF