Question is ⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after SBI 0B7H?, Options are ⇒ (A) 12 H, 0, (B) 12 H, 1, (C) DDH, 0, (D) DDH, 1, (E) , Leave your comments or Download question paper.

Question is ⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after SBI 0B7H?, Options are ⇒ (A) 12 H, 0, (B) 12 H, 1, (C) DDH, 0, (D) DDH, 1, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after SBI 0B7H?
A.	12 H, 0 [Wrong Answer]
B.	12 H, 1 [Wrong Answer]
C.	DDH, 0 [Wrong Answer]
D.	DDH, 1 [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The most commonly used transistor amplifier circuit is
CB
CC
CE
CE or CC

⇒ A sinusoidal signal with peak to peak amplitude of 1.536 volt is quantized into 128 levels using a mid-rise uniform quantizer. The quantization noise power is
0.768 V
48 x 10^-6 V
12 x 10^-6 V
3.072 Volt

⇒

Assertion (A): In 8085 when RESET OUT goes low processing begins.

Reason (R): CPU remains reset till RESET IN signal goes high.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In energy band diagram of p type semiconductor the acceptor energy level is
in valence band
in conduction band
slightly above valence band
slightly below conduction band

⇒ Network transients are due to
circuit resistance
circuit voltage
changes in energy stored in L and C
circuit admittance

⇒ The magnitude response of a normalised Butterworth low pass filter is
linear starting with value of unity at zero frequency and 0.707 at cut off frequency
non linear all through but with values of unity at zero frequency and 0.707 at cut off frequency
linear upto cut off frequency and nonlinear thereafter
nonlinear upto cut off frequency and linear thereafter

⇒ A signal m(t) amplitude modulates a carrier A_c cos ω_ct. The final signal will be
[A_c m(t)] cos ω_ct]
A_c . [1 + m(t)] cos ω_ct
A_c + [m(t)] cos ω_ct
A_c cos ω_ct + m(t)

⇒ Without any addition circuitry, an 8:1 MUX can be used to obtain.
some but not all Boolean functions of 3 variables
all functions of 3 variables but none of 4 variables
all functions of 3 variables and some but not all of 4 variables
all functions of 4 variables

⇒ The number of registers and flags in 8086 are
13 and 5 respectively
9 and 5 respectively
13 and 9 respectively
9 and 9 respectively

⇒ For an ideal noise free transistor amplifier the noise factor is
zero
zero dB
1 dB
depends on other factors

⇒ A single phase series converter is used for
high voltage output
high current output
high voltage and high current output
improving the circuit efficiency

⇒ Junction temperature is always the same as room temperature.
TRUE
FALSE

⇒ In 8085, which of the following registers cannot be paired?
A
E
C
both (b) and (c)

⇒ In 8085 the time required to add two 32 bit numbers is (if clock frequency is 5 MHz)
about 1 ns
about 1 μs
about 30 μs
about 100 μs

⇒ For maximum transfer of power, internal resistance of the source should be
equal to load resistance
less than the load resistance
greater than the load resistance
none of the above

⇒ A CMOS amplifier when compared to an N-channel. MOSFET, has the advantage of
higher cut off frequency
higher voltage gain
higher current gain
lower current drain from the power supply, there by less dissipation

⇒ In Bode diagram (log magnitude plot) of the factor 1/(1 + jωT) in the transfer function the log magnitude for ω << 1/T can be approximated by
0 dB
20 log ωT dB
-20 log ωT dB
none of the above

⇒ It is desired to evaluate the expression F = B * COS (Y) + C * SQR (COS (Y) + A * COS (Y) * COS (Y) * COS (Y)
F = B * COS (Y) + C * SQR [COS (Y)] + A * COS (Y) * SQR [COS (Y)]
F = B * COS (Y) + C * COS(Y) * COS (Y) + A * COS (Y) * COS (Y) * COS (Y)
X = COS(Y)



⇒ Resonant circuits are used in
audio amplifiers
RF amplifiers
both audio and RF amplifiers
none of the above

⇒ Consider the following statements about mutual inductances: The value should remain constant under all conditions.
The mutual inductance should not vary with temperature.
The inductance should be independent of excitation.
They have two coils wound on a bobbin of hard magnetic material, coils being separated by a range.
 Out of the above, correct statement are
2, 3, 4
1, 2, 3
1, 3, 4
1, 2, 4

⇒ The wavelength of an electromagnetic wave after reflection at angle on a surface
remains same as the wavelength perpendicular to the surface
remains same in the free space
increases in actual direction of propagation
decreases in actual direction of propagation

⇒ X and Y are two random variables and Z = X + Y . Letmz, m_z, m_x, m_y represent mean of Z, X and Y. Then
m_z = m_x + m_y
m_z ≤ m_x + m_y
m_z< m_x + m_y
m_z > m_x + m_y

⇒ Which one of the following logic families can be operated using a supply voltage from 3 V to 15 V?
TTL
ECL
PMOS
CMOS

⇒ A two port network is reciprocal if and only if
Z₁₁ = Z₂₂
BC - AD = - 1
Y₁₂ = Y₂₁
h₁₂ = h₂₁

⇒ Which of these is also called 'hot carrier diode'?
PIN diode
LED
Photo diode
Schottky diode

⇒ In a CE amplifier, the output voltage is equal to product of
ac collector current and ac collector resistance
ac base current and ac collector resistance
ac emitter current and ac emitter resistance
ac collector current and source resistance

⇒ CMOS is widely used in
digital wrist watches
analog circuits
high power circuits
all of the above

⇒ High frequency waves are
absorbed by the F₂ layer
reflected by the D layer
affected by the solar cycle
none of the above

⇒ A radar has a maximum range of 120 km. The maximum allowable pulse repetition frequency for unambiguous reception is
1250
330
2500
8330

⇒ Match the following:
 List I (Characteristics)  List II (Decrease) 
A. Paramagnetic 1. All dipoles are aligned is one preferred direction
B. Ferromagnetic 2. Half the dipoles are aligned in opposite direction and have equal magnitude
C. Antiferromagnetic 3. Half the dipoles (with equal magnitudes) are aligned in opposite direction to the other half having equal but lower magnitude
D. Ferrimagnetic 4. All dipoles have equal magnitude but are randomly oriented

A-4, B-3, C-2, D-1
A-4, B-1, C-2, D-3
A-2, B-1, C-4, D-3
A-2, B-3, C-4, D-1

	List I (Characteristics)		List II (Decrease)
A.	Paramagnetic	1.	All dipoles are aligned is one preferred direction
B.	Ferromagnetic	2.	Half the dipoles are aligned in opposite direction and have equal magnitude
C.	Antiferromagnetic	3.	Half the dipoles (with equal magnitudes) are aligned in opposite direction to the other half having equal but lower magnitude
D.	Ferrimagnetic	4.	All dipoles have equal magnitude but are randomly oriented









Users Also Read
Previous Papers
Aptitude
Reasoning
Gen.Knowledge
Speak English
English / Verbal
Online / Mock Test
Vedic Math







    
	
	




    
	StudySite.org is world's best free online study content provider, Copyright © 2025 by 
StudySite.org All Rights Reserved