Question is ⇒ As wavelength decrease the size of high directivity antenna, Options are ⇒ (A) decreases, (B) increases, (C) is not affected, (D) either (b) or (c), (E) , Leave your comments or Download question paper.

Question is ⇒ As wavelength decrease the size of high directivity antenna, Options are ⇒ (A) decreases, (B) increases, (C) is not affected, (D) either (b) or (c), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	As wavelength decrease the size of high directivity antenna
A.	decreases [Correct Answer]
B.	increases [Wrong Answer]
C.	is not affected [Wrong Answer]
D.	either (b) or (c) [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In asynchronous TDM, for n signal sources, each frame contains m slots, where m is usually
Less than n
2n
n
greater than 2n

⇒ If the energy is supplied from a source, whose resistance is 1 ohm, to a load of 100 ohms the source will be
a voltage source
a current source
both of the above
none of the above

⇒ When a complex voltage wave is applied to a capacitor the resulting current wave is more distorted than the voltage wave.
TRUE
FALSE

⇒ In a single phase full wave ac regulator the rms value of load current is 20 A load is purely resistive. Then
average thyristor current will be less than 20 A but rms thyristor current will be more than 20 A
both the average and rms thyristor currents will be less than 20 A
both the average and rms thyristor currents will be more than 20 A
rms thyristor current will be 20 A and average thyristor current will be 10 A

⇒

Assertion (A): Resistivity of a perfect single crystal of a metal goes to zero as T approaches zero.

Reason (R): Scattering of electrons is due to deviations from perfect periodicity of lattice.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ When the video signal is applied to the picture tube in a TV receiver, the strength of video signal is about
1000 V
200 V
50 V
1 V

⇒ If the Nyquist plot does not encircle the (-1 + j0) point the system is always stable.
TRUE
FALSE

⇒ A uniform plane EM wave incident normally on a plane surface of a dielectric material is reflected with a VSWR of 3. What percentage of incident power that is reflected?
0.1
0.25
0.5
0.75

⇒ The simplified logic expression for the circuit of the given figur
Y = A
Y = AB
Y = A + B
Y + A + B

⇒ The core of a coil has a length of 10 cm. The self inductance is 8 mH. If the core length is doubled, all other quantities remaining the same, the self inductance will be
32 mH
16 mH
8 mH
4 mH

⇒ The capacitance of a capacitor is not affected by
area of plates
thickness of plates
∈_r
distance between plates

⇒ In the given figure assume that initially Q = 1 with Clock Pulses being given, the subsequent states of Q wil
1, 0, 1, 0, 1......
0, 0, 0, 0, 0......
1, 1, 1, 1, 1......
0, 1, 0, 1, 0......

⇒ An inductance having X_L = 5 Ω and a capacitance having X_C = 5 Ω are connected in parallel across 100 V, 50 Hz supply. The current drawn from source is
zero
20 A
40 A
28.28 A

⇒ If absolute potential of A is - 8 V and that of B is - 16 V, V_AB is equal to
24 V
8 V
- 8 V
- 24 V

⇒ An amplitude modulated signal occupies a frequency range from 395 kHz to 405 kHz. If can be demodulated by which of the following?
Using an envelope detector and filter
Multiplying with a 395 kHz local signal
Multiplying with a 405 kHz local signal
Low pass filtering with cut off at 400 kHz

⇒ A device that converts from decimal to binary numbered is called
decoder
encoder
CPU
converter

⇒ Which of the following should dominant wave have?
Lowest cut off frequency
Highest cut off frequency
No attenuation
No phase shift

⇒ E_g is the band gap, A is pre-factor, k is Boltzmann constant? Which one of the following is the remaining grade of paper used in paper capacitor, besides the other two grade of paper-low and extra low loss?
Strong dielectric
Regular
Rough
High loss

⇒ The coupling capacitor in amplifier circuits
affects dc biasing
does not affect dc biasing
affects dc biasing to some extent
both (a) and (c)

⇒ In figure, the value of R shoul
0.2 Ω
0.1 Ω
0.05 Ω
0.1 Ω

⇒ In communication systems the frequency range used for voice is
15 Hz to 150 Hz
30 Hz to 1000 Hz
100 Hz to 1500 Hz
300 Hz to 3800 Hz

⇒ 2N 2430 could be a
semi-conductor diode
dual gate MOSFET
BJT
UJT

⇒ For the given figure C(s)/R(s<
K
0.5 K
2 K
0.25 K

⇒ The output of basic DTL configuration is
low when one of the input is high
low when all inputs are high
high when all inputs are high
high when all inputs are low

⇒ Which of these has semi-conductor metal junction?
PIN diode
Photo diode
Tunnel diode
Schottky diode

⇒ A thyristor has maximum allowable junction temperature of 110° C and the ambient temperature is 40°C, If the maximum internal power dissipation is 50 W, the thermal resistance is
2° C/W
1.4° C/W
0.7°C/W
2.2° C/W

⇒ In case of surface waves the field strength at a point is directly proportional to
antenna height
wave frequency
current of the antenna
distance of the point from the antenna

⇒ The advantage of Marconi antenna over the ungrounded antenna is that
only one fourth of the height is required as compared to undergrounded antenna
one-half of the height is required as compared to undergrounded antenna
no capacitance required
none of the above

⇒ The IF amplifier in a superheterodyne receiver is
single-stage single-timed amplifier
two stage of single tuned amplifier
double tuned amplifier
class-C amplifier

⇒ 2's complement of binary number 0101 is
1011
1111
1101
1110

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math