Question is ⇒ As the temperature increases the mobility of electrons __________ ., Options are ⇒ (A) decreases because the number of carries increases with increased collisions, (B) increases because the number of carries decreases with decreased collisions, (C) remains same, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ As the temperature increases the mobility of electrons __________ ., Options are ⇒ (A) decreases because the number of carries increases with increased collisions, (B) increases because the number of carries decreases with decreased collisions, (C) remains same, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	As the temperature increases the mobility of electrons __________ .
A.	decreases because the number of carries increases with increased collisions [Correct Answer]
B.	increases because the number of carries decreases with decreased collisions [Wrong Answer]
C.	remains same [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The inputs to a 3 bit binary adder are 111₂ and 110₂. The output will be
101
1101
1111
1110

⇒ If operator 'a' = 1 ∠120° then (1 - a²) =
1 ∠ - 30°
1 ∠ 30°
1 ∠ - 60°
1 ∠60°

⇒ In an oscillator crystal, the parallel resonant frequency is
equal to
higher than
less than
series resonant frequency

⇒ A two branch parallel tuned circuits has a coil of resistance R and inductance L in one branch and capacitance C in the second branch. The bandwidth is 200 radians/sec. A load of resistance R_L is connected in parallel. The new bandwidth will be
200 rad/sec
more than 200 rad/sec
less than 200 rad/sec
200 rad/sec or less

⇒ In van der walls crystals, there exists a high degree of stability of the outer electron shell.
TRUE
FALSE

⇒ Which one of the following is non-resonant antenna?
Folded dipole
Broad side array
End fire array
Rhombic antenna

⇒ In standard TTL the totem pole stage refers to
multiemitter input stage
phase splitter
output buffer
open collector output stage

⇒ A sinusoidal voltage is written as v = I_m (R² + X_C²)^0.5 sin 314 t. Its peak value and frequency are
I_m and 50
I_m (R₂ + X²_C)^0.5 and 50
0.707 I_m (R₂ + X²_C)^0.5 and 50
2 I_m (R₂ + X²_C)^0.5 and 50

⇒ An 8 bit wide 4 word sequential memory has
Eight 4 bit shift registers
Eight 8 bit shift registers
Four 8 bit shift registers
Foui 4 bit shift registers

⇒ The ability of a radio receiver to discriminate between different input signals and to accept only one definite signal is called its
sensitivity
attenuation
selectivity
modulation

⇒

Assertion (A): Atomic number of sodium is 11.

Reason (R): Sodium has a body centred cubic lattice.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): CMOS devices have very high speed.

Reason (R): CMOS devices have very small physical size and simple geometry.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Assertion (A): In microprocessor 8085 instruction LXIB, 90 FF H means register B and C are loaded with upper and lower bytes to get B = 90 H and C = FFH.

Reason (R): In 8085 the stack pointer indicates which memory location is to accessed.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Hall coefficient is reciprocal of charge density.
TRUE
FALSE

⇒ Which of the following 8085 instructions do not effect CY flag?
SEE M
SEE R
DCRM
ADC M

⇒ In the saturation region of CE output characteristics of n-p-n transistor, V_CE is about
0.5 V
15 V
- 0.5 V
- 15 V

⇒ The advantage of transistor over vacuum tube is
no heat is required
small size and light in weight
very low power consumption
all of the above

⇒ The triangular wave of the given figure can be written as v(t) = u(t) - tu(t) + (t - 1) u(t
TRUE
FALSE

⇒ Two sinusoidal waves 1 and 2 have peak values V_m1 and V_m2. Wave 1 is leading wave 2 by ∠θ. Which of the following is correct?
v₁ = V_m1 sin θ and v₂ = V_m2 cos θ
v₁ = V_m1 sin ωt and v₂ = V_m2 sin (ωt - θ)
v₁ = V_m1 sin (ωt + θ/2) and v₂ = V_m2 sin ωt
none of the above

⇒ In an op-amp a common mode signal is applied to
inverting terminal
non-inverting terminal
both terminals
one or both the terminals

⇒ The fourier transform of a voltage signal x(t) is X(f). The unit of X(f) is __________ .
volts
volt²
volt/sec
volt-sec

⇒

Assertion (A): A high density IC has more diodes, transistors and resistors per unit surface area.

Reason (R): A high density IC can handle high voltages.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ An inverting amplifier has R₁ = 10 kΩ, and R_f = 150 kΩ then the O/P voltage, if input voltage V_i = 1 volt.
-15 V
-10 V
15 V
-14 V

⇒ The factor which will have least effect on the voltage at the load end of a two-wire supply circuit is
length of the circuit
whether supply frequency is 25 Hz or 50 Hz
amount of load on the circuit
cross-section of the circuit wires

⇒ The peak factor is
rms value/peak value
rms value/average value
peak value/rms value
peak to peak value/rms value

⇒ Consider the following statements about mutual inductances:

The value should remain constant under all conditions.
The mutual inductance should not vary with temperature.
The inductance should be independent of excitation.
They have two coils wound on a bobbin of hard magnetic material, coils being separated by a range.

Out of the above, correct statement are
2, 3, 4
1, 2, 3
1, 3, 4
1, 2, 4

⇒ If zeros at infinity are included in the count, the number of zeros of G(s) H(s) is
equal to number of poles
one more than the number of poles
one less than the number of poles
none of the above

⇒ If X(z) = (1 - az^-1), and |a| < |z|, the initial value x₀ is
1
0
2
∞

⇒ Barkhausen criterion of oscillation is
Aβ > 1
Aβ = 1
Aβ = < 1
Aβ ≤ 1

⇒ A dynamometer wattmeter can be used for
dc only
ac only
dc and 50 Hz ac
dc and high frequency ac