Question is ⇒ As the number of flip flops are increased, the total propagation delay of, Options are ⇒ (A) ripple counter increases but that of synchronous counter remains the same, (B) both ripple and synchronous counters increase, (C) both ripple and synchronous counters remain the same, (D) ripple counter remains the same but that of synchronous counter increases, (E) , Leave your comments or Download question paper.

Question is ⇒ As the number of flip flops are increased, the total propagation delay of, Options are ⇒ (A) ripple counter increases but that of synchronous counter remains the same, (B) both ripple and synchronous counters increase, (C) both ripple and synchronous counters remain the same, (D) ripple counter remains the same but that of synchronous counter increases, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	As the number of flip flops are increased, the total propagation delay of
A.	ripple counter increases but that of synchronous counter remains the same [Correct Answer]
B.	both ripple and synchronous counters increase [Wrong Answer]
C.	both ripple and synchronous counters remain the same [Wrong Answer]
D.	ripple counter remains the same but that of synchronous counter increases [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following logic no resistors are used?
CMOS
TTL
4 n sec ECL
8 sec ECL

⇒ The following program starts at location 0
20 H
02 H
00 H
FFH

⇒ In 8085 microprocessor, what is the length of IR (instruction register)?
6 bits
8 bits
12 bits
16 bits

⇒ In which of the following schemes are several channels interleaved and transmitted together?
TDM
FDM
group
subgroup

⇒ Four sig
2f₀
3f₀
4f₀
8f₀

⇒ In an amplifier circuit the emitter is at ac ground potential in a
CB circuit
CC circuit
CE circuit
both CB and CE circuit

⇒ In grid bias modulation system the power required for modulating amplifier
is negligibly low since grid is negative
is large as compared to that for plate modulation
is almost the same as compared with plate modulation
is small as compared to that for plate modulation

⇒ A conductor in x-y plane and having length 1 m is moving with a velocity V = (2i + 3j + k) m/sec. A magnetic induction field B = (i + 2j) Wb/m² is applied to the conductor. The potential difference between the ends of the conductor is
0
4.88 V
6 V
None of these

⇒ A + A . B =
B
A . B
A
A or B

⇒ The speeds used in recording audio programs in house hold recorders are
38 cm/s and 9.5 cm/s
38 cm/s and 19 cm/s
9.5 cm/s and 4.75 cm/s
38 cm/s and 4.75 cm/s

⇒ Figure repres
Adder
Multiplier
Subtractor
Log Amplifier

⇒ In the circuit shown in the given figure, R_L will absorb maximum power when its valu
2.75 Ω
7.5 Ω
25 Ω
27 Ω

⇒ A compensated wattmeter has its reading corrected for error due to which one of the following parameters?
Frequency
Friction
Power consumed in current coil
Power consumed in pressure coil

⇒ Which one is a non-causal system?
y(n) = x(2n)
y(n) = x(n/2)
y(n) = x(n/2) + x(n)
all

⇒ Choose the correct option
tree does not contain any loop
tree contain all the nodes
tree is always open
all

⇒ A 20 m antenna gives a certain uplink gain at frequencies of 4/6 GHz. For getting same gain in the 20/30 GHz band, antenna size required is metre.
100
4
1
10

⇒ In the circuit of figure, v₁ = v₂ = 10 V.
I₁ = I₂
I₁ > I₂
I₂ > I₁
I₁ = 0

⇒ Consider the differential amplifier shown in figure. (Assume β is very hi
1 MΩ
100 kΩ
15 kΩ
≈ 0

⇒ The phase of colour subcarrier burst in PAL is along the axis at
+180°
-180°
±180°
±45°

⇒ Parabolic and lens antenna used at
microwave frequency
medium frequency
low frequency
high frequency

⇒ In figure, I_D = 4 mA. Then V_{DS20 V
16 V
4 V
0.4 V}

⇒ Which of the following is the poorest conductor of electricity?
Copper
Aluminium
Manganin
Nichrome

⇒ Expression ++i is equivalent to
i = i + 2
i = i + 1
i = i - 1
i = i + i + i

⇒ For the characteristic equation s⁵ + s⁴ + 2s³ + 2s² + 3s + 15 = 0, the number of roots in left half s plane are
1
2
3
5

⇒ During induction heating of metals which of the following is abnormally high?
Frequency
Voltage
Current
Power factor

⇒ The circuit show in the figure has 4 boxes each described by inputs P, Q, R and outputs y, z
4 bit adder giving P + Q
4 bit subtractor P - Q
4 bit subtractor Q - P
4 bit adder P + Q + R

⇒ The noise figure of individual stages of a two stage amplifier is 2.03 and 1.54 respectively. If gain of first stage is 62, the overall noise figure is
2.03
2.055
3.05
6.05

⇒ The circuit in the given figur
low pass filter
high pass filter
band Pass filter
band reject filter

⇒ A signum function is
zero for t greater than zero
zero for t less than zero
unity for t greater than zero
2∪(t) - 1

⇒ A depletion type NMOS is operated in enhancement mode. V_p = - 4 volts. For V_GS = + 3 volts as V_DS is increased, I_D becomes nearly constant when V_ps equals
1 volt
3 volts
4 volt
7 volts