Question is ⇒ As per Hartley law, Options are ⇒ (A) redundancy is essential, (B) it is necessary to use only binary codes, (C) maximum rate of information transmission depends on the channel bandwidth, (D) the maximum rate of information depends on depth of modulation, (E) , Leave your comments or Download question paper.

Question is ⇒ As per Hartley law, Options are ⇒ (A) redundancy is essential, (B) it is necessary to use only binary codes, (C) maximum rate of information transmission depends on the channel bandwidth, (D) the maximum rate of information depends on depth of modulation, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	As per Hartley law
A.	redundancy is essential [Wrong Answer]
B.	it is necessary to use only binary codes [Wrong Answer]
C.	maximum rate of information transmission depends on the channel bandwidth [Correct Answer]
D.	the maximum rate of information depends on depth of modulation [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): The velocity of electromagnetic waves on overhead lines and coaxial cables is the same.

Reason (R): Free space has an intrinsic impedance of 377 ohms.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In low pass filter of figure R₀ = 1 Ω and cut off frequency is 1 rad/sec. The values of L and C
1 H and 2 F
1 H and 1 F
2 H and 1 F
1 H and 2 F

⇒ A function Z(s) has zero at infinity if
the degree of numerator and denominator are equal
the numerator of Z(s) is one degree higher than denominator
the denominator of Z(s) is one degree higher than numerator
the degree of numerator and denominator are either equal or differ by one

⇒ What was the first commercial geostationary communication satellite?
INTELSAT 1
ECHO
INSAT-1A
SPUTNIK

⇒ In h parameter representation, the independent variables are
I₁ and V₂
I₂ and V₁
V₁ and V₂
I₁ and I₂

⇒ Which of the following noise sources is different from others?
Cosmic
Solar
Atmospheric
Galactic

⇒ Consider the following statements as regards DPSK and DEPSK

DPSK demodulator requires a device which operates at carrier frequency and provides a delay of bit time T_b
In DPSK, synchronous demodulation recovers the signal b(t) and the decoding of b(t) to generate d(t) is done at base band
In both DPSK and DEPSK errors always occur in pairs

Which of the above statements are correct?
1 and 3
1 and 2
2 and 3
1, 2 and 3

⇒ HVDC systems are preferable for only long distances.
TRUE
FALSE

⇒ Consider the following Statements regarding resistance strain gauge

The gauge factor is in the range of 2 to 5.
The resistance changes due to change in specific resistance with strain.
The resistance increases with increase in temperature.

Of the above statements, which are correct?
1, 2, 3
1 and 2
2 and 3
1 and 3

⇒ A signal x(n) = sin(ω₀n + φ) is the input to a linear time invariant system having a frequency response H(e^jω) If the O/P of the system is Ax(n -n₀), then the general form of H(e^jω) will be
- n₀ω₀ + β for any arbitrary real β
- n₀ω₀ + 2pk for any arbitrary integer k
n₀ω₀ + 2pk for any arbitrary integer k
- n₀ω₀ + φ

⇒ A number is expressed in binary 2's complement as 10011 decimal equivalent value is
19
13
-19
-13

⇒ In figure, the magnitude
must be more than that of V_a
must be more than that of V_b
must be more than that of V_a or V_b
can be equal to or less than or more than that of V_a or V_b

⇒ Which family of logic circuits uses field effect transistors?
TTL
CMOS
Both LED and well as LCD
None of the above

⇒ Which instrument is based on induction principle?
Dynamometer wattmeter
Induction wattmeter
Energy meter
Both (b) and (c)

⇒ A sequential multiplexer is connected as shown in figure. Each time the multiplexer receives the clock, it switches to the next channel from 6 to 1. If the input signals a
8 kHz
50 kHz
20 kHz
10 kHz

⇒ A casual LTI system is described by the difference equat
|a| = 2 |β| < 2
|a| > 2 |β| > 2
|a| < 2 any value of β
|β| < 2, any value of a

⇒ A 3 bit synchronous counter uses FF with propagation delay time of 20 ns each. The maximum possible time required for change of state will be.
60 ns
40 ns
20 ns
None

⇒ Y signal has maximum percentage of
red colour
blue colour
green colour
red and blue colours

⇒ Find V_o(t) for the following circ
0 V
5 V
3 V
2 V

⇒ An RLC series circuit has Q = 100 and ω₀ = 20 rad/sec. The bandwidth is
0.2 rad/sec
2 rad/sec
20 rad/sec
2000 rad/sec

⇒ Which of the following theorems can be conveniently used to find power consumed in 10 Ω resistor in fig
Thevenin theorem
Maximum power transfer theorem
Millman's theorem
Superposition theorem

⇒ A conditionally stable system has
one phase crossover frequency
two phase crossover frequencies
two or more phase crossover frequencies
one or more phase crossover frequencies

⇒ A colour monitor usign 16 bits at a resolution of 600 x 400 pixels needs a memory of
240000 B
9600 B
6400 B
480000 B

⇒ Which of the following are the memory performance parameters?

Access time and latency
Block size and Block access time
Cycle time and Bandwidth

Select the correct answer from the codes given below:
1 only
1 and 2 only
2 and 3 only
1, 2 and 3

⇒ If a sample of Ge and a sample of Si have the same impurity density are kept at room temperature
both will have equal value of resistivity
both will have equal - ve of resistivity
resistivity of germanium will be higher than that of silicon
resistivity of silicon will be higher than of Ge

⇒ In load commutated chopper, the commutating element
is capacitor
is capacitor and inductor
is capacitor, inductor and auxiliary thyristor
any of the above depending on load

⇒ A phasor is
a line representing the magnitude and direction of an alternating quantity
a line which represents the magnitude and phase of an alternating quantity
an instrument used for measuring phases of an unbalanced 3-phase load
a coloured tag or band for distinguishing between different phases of a 3-phase supply

⇒ All of the output pulses are at full transmitter power for a strong signal in all of the following except
PWM
PAM
PFM
PCM

⇒ The instruction MVI A, 20 in 8085 means
contents of memory location 20 are brought into the accumulator
the value 20 is brought into accumulator
either (a) or (b)
neither (a) nor (b)

⇒ As per Hartley law
redundancy is essential
it is necessary to use only binary codes
maximum rate of information transmission depends on the channel bandwidth
the maximum rate of information depends on depth of modulation