Question is ⇒ As B is increased from zero to about 2T, μr, of a ferromagnetic material, Options are ⇒ (A) increase, (B) decrease, (C) first increases then decreases, (D) remains the same, (E) , Leave your comments or Download question paper.

Question is ⇒ As B is increased from zero to about 2T, μr, of a ferromagnetic material, Options are ⇒ (A) increase, (B) decrease, (C) first increases then decreases, (D) remains the same, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	As B is increased from zero to about 2T, μ_r, of a ferromagnetic material
A.	increase [Wrong Answer]
B.	decrease [Wrong Answer]
C.	first increases then decreases [Correct Answer]
D.	remains the same [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Shift left and shift right operations occur in a calculator.
TRUE
FALSE

⇒

Assertion (A): ECL gate has very high speed of operation.

Reason (R): Transistors in ECL do not go into saturation region.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A transistor is said to be in a quiescent state when
the amplitude of input and output signal is equal
the phase of input and output signal is identical
no signal is applied to the input
the transistor is unbiased

⇒ The output of a full adder is
SUM
CARRY
SUM and CARRY
none of the above

⇒ The attenuation in a waveguide near the cut off frequency is
zero
low
high
very high

⇒ Which of the following is not a general purpose peripheral?
I/O port
Programmable interrupt controller
Programmable CRT controller
Programmable interval timer

⇒ A delta connection contains three impedances of 60 Ω each. The impedances of equivalent star connection will be
15 Ω
20 Ω
30 Ω
40 Ω

⇒ If A = 3 + j1, A⁴
100 ∠18.43°
100 ∠73.72°
10 ∠18.43°
10 ∠73.72°

⇒ The transmitting antennas for lower frequencies (below 500 kHz) are generally
vertical grounded wire type
horizontal suspended wire type
parabolic reflector type
any of the above

⇒ The efficiency of a full wave rectifier using centre tapped transformer is twice that in full wave bridge rectifier.
TRUE
FALSE

⇒ A hollow rectangular waveguide has dimensions a = 2b. Calculate the amount of attenuation, if the frequency is 3 GHz, and b = 1 cm.
49
47.33
50.33
50

⇒ Ferrite have
low copper loss
low eddy current loss
low resistivity
higher specific gravity compared to iron

⇒ In a low level amplitude modulated system, the amplifier modulated stage must be
class C
linear
non linear
harmonic

⇒ The total number of leads in SUS, SBS and SCS respectively are
3, 3, 4,
3, 3, 3
2, 3, 3
3, 3, 5

⇒ Which of the following is known as insulated gate FET?
JFET
MOSFET
Both JFET and MOSFET
None of the above

⇒ A system with input x[n] and output y[n] is given as y[n] = (sin 5/6 pn) x(n) The system is
linear, stable and invertible
non-linear, stable and non-invertible
linear stable, non invertible
linear, unstable, invertible

⇒ A voltage of about 200 V dc can be measured
directly by dc potentiometer
by dc potentiometer in conjunction with a volt ratio box
a dc potentiometer in conjunction with a known resistance
both (b) and (c)

⇒ In standing wave pattern on a transmission line
voltage and current nodes coincide
voltage and current antinodes coincide
voltage nodes and current antinodes as well as current nodes and voltage antinodes coincide
both (a) and (b)

⇒ A variable resistance R and capacitive reactance X_C are connected in series. As R is varied, the locus of Z is
a straight line parallel to Y axis in 4th quadrant
a straight line parallel to X axis in 4th quadrant
a straight line parallel to Y axis in second quadrant
a straight line parallel to Y axis in first quadrant

⇒ Class C operation finds application in
RF power amplifiers
frequency multipliers
both (a) and (b)
neither (a) nor (b)

⇒ A TTL circuit with totem pole output has
high output impedance
low output impedance
very high output impedance
none of the above

⇒ A boot strap generally incorporates
CB configuration
CE configuration
emitter follower
none of the above

⇒ If poles lie in first quadrant, damping ratio is
1
more than 1
less than 1
zero

⇒

Assertion (A): The root locus of a control system is symmetrical about real axis.

Reason (R): For all polynomials with real coefficients, complex poles always occur in conjugate pairs.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒

Assertion (A): Microprocesspr 8085 has six 8 bit registers B, C, D, E, H L.

Reason (R): B - C, D - E, H - L may be combined to form register pairs to hold 16 bits data.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ If f_s be the signal frequency and f_i be the intermediate frequency then image frequency is given by
f_s + f_i
f_s ± f_i
f_s ± 2f_i
f_s + 2f_i

⇒ In radar system which of the following is called A scope
deflection modulation of CRT
intensity modulation of CRT
computer display
none of the above

⇒ Consider the following statements as regards BPSK and QPSK:

In BPSK we deal individually with each bit of duration T_b
In QPSK we lump two bits to form a symbol
In both BPSK and QPSK signal changes occur at bit rate
In QPSK the symbol can have any one of four possible values

Which of the above statements are correct?
1, 2, 3, 4
1, 2, 3
1, 2, 4
2, 3, 4

⇒ In the 8421 BCD code, the decimal number 125, is written as
1111101
0001 0010 0101
7 D
none of these

⇒

Assertion (A): The output voltage of an inverter can be controlled by PWM technique

Reason (R): In a current source inverter the input current is constant.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct