Question is ⇒ As applied to a flip flop the word edge triggered's means, Options are ⇒ (A) flip flop can change state when clock transition occurs, (B) flip flop can change state when clock signal goes from LOW to HIGH only, (C) flip flop can change state when clock signal goes from HIGH to LOW only, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ As applied to a flip flop the word edge triggered's means, Options are ⇒ (A) flip flop can change state when clock transition occurs, (B) flip flop can change state when clock signal goes from LOW to HIGH only, (C) flip flop can change state when clock signal goes from HIGH to LOW only, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	As applied to a flip flop the word edge triggered's means
A.	flip flop can change state when clock transition occurs [Correct Answer]
B.	flip flop can change state when clock signal goes from LOW to HIGH only [Wrong Answer]
C.	flip flop can change state when clock signal goes from HIGH to LOW only [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In full wave rectification, if the input frequency is 50 Hz, then frequency at the output of filter is
50 Hz
0 Hz
100 Hz
75 Hz

⇒ In p type semiconductor holes are majority carriers.
TRUE
FALSE

⇒ For satellite communication, the frequency should be
equal to the critical frequency
more than the critical frequency
less than the critical frequency
none of these

⇒ A geostationary satellite
is located at a height of 358, 00 km
appears stationary over earth's magnetic pole
is motionless in space but keeps spinning
orbits the earth within a 24 hour period

⇒ Which of the following is used in lightning arresters?
Thermistor
Photoconductor
Transistor
Varistor

⇒ After reflection from a plane conducting surface, the apparent velocity of electromagnetic wave becomes greater than the velocity of light in free space is called
conventional velocity
phase velocity
propagation velocity
group velocity

⇒ A 4 bit DAC gives an output of 4.5 V for input of 1001. If input is 0110, the output is
1.5 V
2.0 V
3.0 V
4.5 V

⇒ The refractive index of E layer at frequency of 81 N
0
∞
1
0.5

⇒ For a circular wave guide
cutoff frequency for TE₁₀ and TE₀₁ modes are same
cutoff frequency for TE₁₀ and TE₀₁ modes are different
cutoff frequency for TE₁₀ mode = twice the cutoff frequency for TE₂₀ mode
cutoff frequency for TE₁₀ mode = haf the cutoff frequency for TE₂₀ mode

⇒ An impulse function consist of
pure dc
pure a.c
entire frequency range with constant phase
infinite bandwidth with linear phase vaariations

⇒ Which of the following is the disadvantage of PDM and PPM?
It requires pulses of larger widths
More samples are needed per second
More powerful transmitter is required
None of the above

⇒ Consider the following statements

A 33 MHz 486 has higher MIPS than 33 MHz 386.
A 33 MHz 486 has higher MFLOPS than 33 MHz 386 of these statements.

Both are true
Both are false
1 is true and 2 is false
1 is false and 2 is true

⇒ In single tone AM modulation, the transmission efficiency for m = 1 is
0.333
0.5
1
0.1665

⇒ Two similar mutually coupled coils have a total inductance of 900 mH and coefficient of coupling 0.5. The self inductance of each coils is
300 mH
150 mH
75 mH
50 mH

⇒ Vidicon and plumbicon operate on the principle of
photo conduction
photo emission
photo voltaic
none of the above

⇒ In a JFET avalanche breakdown occurs when V_DS = 22 V and V_GS = 0. If V_GS = -1 V, the avalanche breakdown will occur at
V_DS = 22 V
V_DS more than 22 V
V_DS equal to or more than 22 V
V_DS less than 22 V

⇒

Assertion (A): A binary number is a string of zeros and ones only

Reason (R): The base in a binary system is 2

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The V MOS can handle __________ currents than a conventional MOSFET.
much lower
almost same
almost half
much larger

⇒ F = ∑(0, 3, 4, 5, 7) =
[B ⊕ C] + AC
B'C' + BC + AC
AB + BC + CA
None

⇒ If f(t) ↔ F(jω), f(- t) ↔
- F(jω)
F(- jω)
F(jω)
0.5 F(jω)

⇒ The V_o of the op-amp circuit shown in the give
11 V_i
10 V_i
V_i
zero

⇒ Consider the following Statements regarding resistance strain gauge

The gauge factor is in the range of 2 to 5.
The resistance changes due to change in specific resistance with strain.
The resistance increases with increase in temperature.

Of the above statements, which are correct?
1, 2, 3
1 and 2
2 and 3
1 and 3

⇒ In a step down chopper using pulse width modulation, T_on = 3 x 10^-3 and T_off = 1 x 10^-3 s. The chopping frequency is
333.33
250
500
1000

⇒ A narrowband amplifier is one that has a passband
limited to 2000 Hz only
limited to audio frequency range only
near cut off region of active device
approximately 10% of its central frequency

⇒ A 75 ohm line is first short terminated and minima locations are noted. Then the short is replaced by resistive load and minima location are again noted. If minima location are not altered and VSWR is 3, the value of resistive load is
25 Ω
50 Ω
225 Ω
250 Ω

⇒ The speed at which axial electric field due to signal advances in a TWT is equal to
speed of light
(speed of light) (helix pitch helix circumference)
(speed of light) (helix circumference helix pitch)
(speed of light) (helix pitch) (helix circumference)

⇒ In figure, voltage across R₂ = + 10 V. If V_BE = 0.7 V and V_E = 0.7 V and R_E = 10 kΩ, current through R_{E1 mA
0.93 mA
2 mA
1.86 mA}

⇒ Consider the common emitter amplifier shown below with the following circuit parameters: β = 100, g_m = 0.3861 A/V, r₀ = ∞ r_p = 259 Ω, R_s = 1 kΩ, R_B = 93 kΩ, R_C = 250 Ω, R_L = 1 kW, C₁ = ∞ and C₂ = 4.
258 Ω
1258 Ω
93 kΩ
∞

⇒ A sample of N-type semiconductor has electron density of 6.25 x 10¹⁸/cm³ at 300k. If the intrinsic concentration of carriers in this sample is 2.5 x 10¹³/cm³ at this temperature the hole density works out to be
10⁶/cm³
10⁸/cm³
10¹⁰/cm³
10^l2/cm³

⇒

Match the following:

	List I (Symbol in Java comparison operator)		List II (Meaning)
A.	= =	1.	Greater than or equal to
B.	! =	2.	Equal
C.	> =	3.	Not equal

A-1, B-2, C-3
A-3, B-2, C-1
A-1, B-3, C-2
A-2, B-3, C-1