Question is ⇒ Angular velocity is generally represented by, Options are ⇒ (A) ω, (B) π, (C) ∝, (D) θ, (E) , Leave your comments or Download question paper.

Question is ⇒ Angular velocity is generally represented by, Options are ⇒ (A) ω, (B) π, (C) ∝, (D) θ, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Angular velocity is generally represented by
A.	ω [Correct Answer]
B.	π [Wrong Answer]
C.	∝ [Wrong Answer]
D.	θ [Wrong Answer]
View Answer 10 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The angles between two forces to make their resultant a minimum and a maximum respectively are
0° and 90°
180° and 90°
90° and 180°
180° and 0°

⇒ If F is the limiting friction, R = normal friction then coefficient of friction µ will be equal to
µ = F + R
µ = F R
µ = F/R
µ = R/F

⇒ Cartesian form of the equation of catenary is
y = c cosh x/c
y = c sinh x/c
y = c tan x/c
y = c sin"1 x/c

⇒ The centre of gravity of a plane lamina will not be at its geometrical centre if it is a
Circle
Right angled triangle
Square
Rectangle

⇒ A ladder is resting on a smooth ground and leaning against a rough vertical wall, the force of friction acts
Towards the wall at its upper end
Downwards at its upper end
Upward at its upper end
Away from the wall at its upper end

⇒ It is observed that in a certain sinusoidal oscillation, the amplitude is linearly dependent on the frequency f. If the maximum velocity during the oscillation is V, then V must be proportional to
f
1/f
1/f2
f2

⇒ Minimum pull in a suspended cable with supports at two ends is equal to
horizontal thrust
support reactions
resultant of horizontal thrust and support reaction
half the weight of the cable

⇒ A symmetrical body is rotating about its axis of symmetry, its moment of inertia about the axis of rotation being 2 kg m2 and its rate of rotation 2 revolutions/see. The angular momentum of the body in kg-m2/sec is
4
6 7i
8TC
8

⇒ Generally in most of the machines, when mechanical advantage is greater than one, then its velocity ratio should also be
Less than one
Equal to one
Greater than one
Equal to efficiency

⇒ Rate of change of angular momentum is equal to
force
torque
linear momentum
impulse

⇒ Minimum potential energy of a system will be in the position of
stable equilibrium
unstable equilibrium
neutral equilibrium
all of the above

⇒ Which one of the following substances has the largest value of Young's modulus ?
Rubber
Nylon
Iron
Copper

⇒ A structure which offers negligible or zero resistance on bending at any point is known as
Beam
Girder
Arch
Cable or string

⇒ The maximum displacement of a body, from its mean position is known as
Amplitude
Oscillations
Beat
Frequency

⇒ A shell travelling with a horizontal velocity of 100 m/sec explodes and splits into two parts, one of mass 10 kg and the other of 15 kg. The 15 kg mass drops vertically downward with initial velocity of 100 m/sec and the 10 kg mass begins to travel at an angle to the horizontal of tan"1 x, where x is
3/4
4/5
5/3
3/5

⇒ Due to the creep of belts, in a belt driven system there will be
Loss of motion
Loss of power to be transmitted
Extra movement of belt as compared to the follower
All the above are correct

⇒ A particle of mass 2 kg executes simple harmonic motion of frequency 6/71 Hz and amplitude 0.25 m. Its maximum kinetic energy is
4.5 J
9.0 J
12.0 J
18.0 J

⇒ In SI units, the units of force and energy are respectively
Newton and watt
Dyne and erg
Newton and joule
kg-wt and joule

⇒ Joule is the unit of
power
impulse
work
momentum

⇒ The set of forces, whose resultant is zero, are known as
Equilibrium forces
Collinear forces
Coplanar forces
Concurrent forces

⇒ Mechanical advantage is the ratio between
Load and distance moved by the effort
Load and distance moved by the load
Load and effort
Effort and load

⇒ A cube on a smooth horizontal surface
cannot be in stable equilibrium
cannot be in neutral equilibrium
cannot be in unstable equilibrium
can be in any of these states

⇒ The angular speed of a car taking a circular turn of radius 100 m at 36 km/hr will be
0.1 rad/sec
1 rad/sec
10 rad/sec
100 rad/sec

⇒ Strain energy of any member may be defined as work done on it
To deform it
To resist elongation
To resist shortening
All the above

⇒ The time period of a second pendulum is
1/2 second
1 second
2 second
5 second

⇒ The dimensions of power are.
M'L2T2
M'L'T3
M'L'r2
M'L-'T*

⇒ If a body is acted upon by a number of coplanar non-concurrent forces it may
Rotate about itself without moving
Move in any one direction
Move in any direction rotating about itself
All the above

⇒ A stone is thrown up a slope of inclination 60° to the horizontal. At what angle to the slope must the stone be thrown so as to land as far as possible from the point of projection ?
15°
30°
45°
75°

⇒ Force is
Scalar quantity
Linear quantity
Vector quantity
Non-measurable quantity

⇒ The area under velocity-time graph gives
Acceleration
Total distance travelled
Velocity
Speed