Question is ⇒ An RLC series circuit is excited by a step voltage E. The units of roots of characteristic equation are, Options are ⇒ (A) seconds, (B) 1/seconds, (C) tesla, (D) henry, (E) , Leave your comments or Download question paper.

Question is ⇒ An RLC series circuit is excited by a step voltage E. The units of roots of characteristic equation are, Options are ⇒ (A) seconds, (B) 1/seconds, (C) tesla, (D) henry, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An RLC series circuit is excited by a step voltage E. The units of roots of characteristic equation are
A.	seconds [Wrong Answer]
B.	1/seconds [Correct Answer]
C.	tesla [Wrong Answer]
D.	henry [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In fabricating silicon BJT in ICs by the epitaxial process, the number of diffusions used is usually
2
3
4
6

⇒ Modem warfare has changed from large scale clashes of armies to suppression of civilian populations. Chemical agents that do their work silently appear to be suited to such warfare; and regretfully, there exist, people in military establishments who think that chemical agents are useful tools for their cause, which of the following statements best sums up the meaning of the above passage:
Modem warfare has resulted in civil strife.
Chemical agents are useful in modem warfare.
Use of chemical agents in warfare would be undesirable.
People in military establishments like to use chemical agents in war.

⇒ For a series resonant circuit at low frequency circuit impedance is __________ and at high frequency circuit impedance is _______
capacitive, inductive
inductive, capacitive
resistive, inductive
capacitive, resistive

⇒ In waveguide Degenerate modes are
two mode having same cut off frequency
two mode having same power
two mode having same phase velocity
it is a hypothetical mode

⇒ What is the approximate steady state current in the above circ
50 A
25 A
0.208333333333333
0.0416666666666667

⇒ Audio and video signals are called modulating waves.
TRUE
FALSE

⇒ In the circuit shown in the given figure the diode states at the extremely large negative values of the input voltage v_i a
D₁ off, D₂ off
D₁ on, D₂ off
D₁ off, D₂ on
D₁ on, D₁ on, D₂ on

⇒ All network theorems of dc are applicable to ac also with different quantities taken as phasors.
TRUE
FALSE

⇒ The 10 MHz in the specification of CRO means that
the sweep frequency is 10 MHz
the frequency of input signal should not be more than 10 MHz
the vertical amplifier has been designed for 10 MHz
none of the above

⇒ As per BIS, the number of accuracy classes of instrument is
5
6
7
8

⇒ The power gain of a half-wave dipole with respect to an isotropic radiator is
2.15 db
3 db
4.15 db
6 db

⇒ The integral of a unit step function is
a unit impulse function
a unit pulse function
a ramp function of slope 1
none of the above

⇒ If a two port network is represented by an equivalent T network the admittance of series arm in term of ABCD parameter is equal to
C
1/C
(A - 1)/B
1/B

⇒ Atomic number of germanium is
24
28
32
36

⇒ The resistance of a photoconductor
increases with increase in light intensity
decreases with increase in light intensity
may increase or decrease with increase in light intensity
remains constant

⇒ The value of current read by ideal ammeter A in figure is __________ amp
0
3
2.5
5

⇒ Which of the following best represents the output impedance of an actual op-amp?
10 ohm
100 ohm
10 k ohm
100 k ohm

⇒ FET amplifier is more difficult to analyse than BJT amplifier.
TRUE
FALSE

⇒ Discrete transistors T₁ and T₂ having maximum collector current rating of 0.75 amp are connected in parallel as shown in the figure, this combination is treated as a single transistor to carry a total current of 1 ampere, when biased with self bias circuit. When the circuit is switched on, T₁ draws 0.55 amps and T₂ draws 0.45 amps. If the supply is kept on continuously, ultimately it is very likely
Both T₁, and T₂ get damaged
Both T₁, and T₂ will be safe.
T₁ Will get damaged and T₂ will be safe
T₂ will get damaged and T₁, will be safe.

⇒ Which materials find application in MASER?
Diamagnetic
Paramagnetic
Ferromagnetic
Ferrimagnetic

⇒ In drawing phasor diagrams, RMS values are used.
TRUE
FALSE

⇒ Out of S, R, J, K, Preset, Clear inputs to flip flops, the synchronous inputs are
S, R, J, K only
S, R, Preset, Clear only
Preset, Clear only
S, R only

⇒ Which of the following sampling frequencies is considered adequate in voice telephony?
4 kHz
8 kHz
16 kHz
32 kHz

⇒ While selecting a memory chip the feature which should be examined is
capacity
ac characteristics
dc characteristics
all of the above

⇒ The noise margin of a TTL gate is about
0.2 V
0.4 V
0.6 V
0.8 V

⇒ In a JK flip-flop, J is connected to Q and K is connected to Q outputs. The JK FF converts into a
RS FF
D FF
T FF
Clocked RS FF

⇒ The combination of registers in 8085 is B-C, D-E, H-L only.
TRUE
FALSE

⇒ The memory hierarchy in microprocessor based system is
register, cache, primary, mass, off line back up
cache, register, primary, mass, off line back up
cache, register, mass, primary, off line back up
register, cache, mass, primary, off line back up

⇒ The input to a coherent detector is DSB - SC signal plus noise. The noise at the detector output is
in phase component
quadrature component
zero
the envelope

⇒ The Lissajous pattern observed on screen of CRO is a straight line inclined at 45° to x axis. If X-plate input is 2 sin ωt, the Y-plate input is
2 sin ωt
2 sin (ωt + 45°)
2 sin (ωt - 45°)
22 sin ωt + 45°)