Question is ⇒ An RF carrier of 12 kV at 1 MHz is amplitude modulated by 1 kHz signal having peak value of 6 kV. The modulation pattern is seen on CRO screen. The voltage indicated will be, Options are ⇒ (A) 18 kV, (B) 1.001 kV, (C) 6 kV, (D) 36 kV, (E) , Leave your comments or Download question paper.

Question is ⇒ An RF carrier of 12 kV at 1 MHz is amplitude modulated by 1 kHz signal having peak value of 6 kV. The modulation pattern is seen on CRO screen. The voltage indicated will be, Options are ⇒ (A) 18 kV, (B) 1.001 kV, (C) 6 kV, (D) 36 kV, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An RF carrier of 12 kV at 1 MHz is amplitude modulated by 1 kHz signal having peak value of 6 kV. The modulation pattern is seen on CRO screen. The voltage indicated will be
A.	18 kV [Wrong Answer]
B.	1.001 kV [Wrong Answer]
C.	6 kV [Wrong Answer]
D.	36 kV [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In figure, V_{0-1 V
2 V
+1 V
+15 V}

⇒ A two branch parallel circuit has a 20 Ω resistance and 1 H inductance in one branch and a 100 μF capacitor in the second branch. It is fed from 100 V ac supply, at resonance, the input impedance of the circuit is
500 Ω
50 Ω
20 Ω
5 Ω

⇒

Assertion (A): Water waves are longitudinal but EM waves are transverse

Reason (R): In an EM wave electric field, magnetic field and propagation are mutually perpendicular.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Aperture circuit produces __________ in sample hold circuit.
the total sampling time
delay between the instance at which hold command is initiated and the instance at which O/P starts tracking I/P
the time taken by O/P to settle within the specified 1% error band, that of the I/P
time required by holding capacitor to reach upto the level close to input

⇒

Match the following:

	List I		List II
A.	Detection of a periodic signal in noise	1.	Increase in bandwidth
B.	Recovery of a band limited signal from its uniformly sampled values	2.	Slope overload error
C.	Finer quantization of signal	3.	Nyquist rate
D.	Delta modulation	4.	Cross correlation

A-4, B-3, C-1, D-2
A-3, B-4, C-2, D-1
A-4, B-3, C-2, D-1
A-4, B-2, C-1, D-3

⇒ Initially the number decimal 8 is stored. If instruction RAL is executed twice, the final number stored will be
decimals 8
decimal 16
decimal 32
decimal 2

⇒ In a circular waveguide TE₂₁ mode has lowest cutoff frequency
TRUE
FALSE

⇒ A loss less line of characteristic impedance Z₀ is terminated in pure reactance of -jZ₀ value. VSWR is
10
2
1
infinity

⇒ In a phase discriminator f_c, is the IF to which primary circuit is tuned. Consider the following statements: The primary and secondary voltages are

exactly 90° out of phase when input frequency is f_c
more than 90° out of phase when input frequency is higher than f_c
less than 90° out of phase when input frequency is lower than f_c

Which of the above statements is correct?
1 only
1 and 2
1, 2 and 3
2 and 3

⇒ For a series RLC circuit bandwidth is ω₂ - ω₁ = R/2L.
TRUE
FALSE

⇒ (2)₃ + (3)₄ = (?)₅
4
11
none of these
not possible

⇒ The most important set of specifications of transformer oil include
dielectric strength and viscosity
dielectric strength and flash point
viscosity and flash point
flash point and viscosity

⇒ The input to an op-amp integrating amplifier is a constant voltage. The output will be
a constant voltage
a sawtooth wave
a ramp
ac voltage

⇒ Radiation resistance of an antenna is 54 Ω and loss resistance is 6 Ω. If antenna has power gain of 10, then directivity is:
9
11.11
data not sufficient
10

⇒ In which function is each term known as minterm?
SOP
POS
Hybrid
Both SOP and POS

⇒ If a complex voltage wave is applied to a pure inductance, the resulting current wave is much smoother than the voltage wave.
TRUE
FALSE

⇒ For graph of figure, one set of fundamental cutsets woul
abc, cde, afe
afde, afe, abdc
cbfe, afe, bdf
cbd, adbe, cde

⇒ As compared to 17.34° antenna, the total increase in the signal relayed by 4.5° antenna of INTELSAT-IV is
14.85
220
78
3.85

⇒ The number of valence electrons in a silicon atom is
4
2
1
0

⇒ One of the advantages of base modulation over collector modulation of a transistor class C amplifier is
improved efficiency
better linearity
high power output per transistor
the lower modulating power requirement

⇒ Which of the following is not considered as a useful quantity in comparing noise performance of receivers?
Noise temperature
Noise figure
Noise resistance
Input noise voltage

⇒ If x_k = a^k and k &l
TRUE
FALSE

⇒ Three point tracking can be achieved with
gang condenser
variable selectivity
paddar capacitor
any of the above

⇒ A matched generator (Z_g = Z₀) with 1 Ω available. If all ports are matched, the power delivered at ports 1, 2, 3 respectively are
0.5 W, 0.5 W, 0 W
0 W, 0 W, 1 W
0.33 W each
0 W, 0.25 W, 0.25 W

⇒ In 8086 microprocessor, if the segment register contains 1 FAB and IP register contains 10AI, the effective memory address is
20B51
304C
FBC0
FDB5

⇒ Nichols chart consists of M and N locii in log magnitude versus phase diagram.
TRUE
FALSE

⇒ A signal occupies a band 5 kHz to 10 kHz. For proper error free reconstruction at what rate it should be sampled?
10 kHz
20 kHz
5 kHz
(10 + 5) x 2 kHz

⇒ The maximum temperature limit of class B insulation is
90°C
105°C
120°C
130°C

⇒ The Fourier series of an odd periodic function contains
odd harmonics only
even harmonics only
cosine harmonics only
sine harmonics only

⇒ A class C amplifier uses
high Q tuned circuit
low Q tuned circuit
untuned circuit
either (b) or (c)