Question is ⇒ An RC snubber circuit is used to protect a thyristor against :, Options are ⇒ (A) false triggering, (B) failure to turn on, (C) switching transients, (D) failure to commutate, (E) , Leave your comments or Download question paper.

Question is ⇒ An RC snubber circuit is used to protect a thyristor against :, Options are ⇒ (A) false triggering, (B) failure to turn on, (C) switching transients, (D) failure to commutate, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An RC snubber circuit is used to protect a thyristor against :
A.	false triggering [Wrong Answer]
B.	failure to turn on [Wrong Answer]
C.	switching transients [Correct Answer]
D.	failure to commutate [Wrong Answer]
View Answer 4 -5 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ RAM can be expanded to
increase word size
increase word number
either increase word size or increase word number
none of the above

⇒ For an ac sinusoidal wave, the rms value is 10 A. For the same wave delayed by 60° in each half cycle, the rms value is likely to be
0.416666666666667
7.07 A
6.35 A
3.5 A

⇒ Frequency band used for radar is generally
VLF
VHF
UHF
EHF

⇒ In Bode plots the frequency at which two asymptotes meet is called corner frequency.
TRUE
FALSE

⇒ An ac circuit has an impedance of (3 + j6) ohm for fundamental. The impedance for fifth harmonic is
(15 + j 30) Ω
(15 + j 6) Ω
(3 + j 30) Ω
(3 + j 1.2) Ω

⇒ In a good voltage amplifier, its input impedance
must be high compared to the resistance of the source
must be low compared to the resistance of the source
must be equal to the resistance of the source
must be half the resistance of the source

⇒ The fourier transform of the half cosine pulse as shown below is _______
0.5 {sin [0.5(f - 1)] + sin [0.5 (f + 1)]}
0.25 [sin c[0.25 (f - 2)1 + sin c[0.25(f + 2)]]
0.5 {sin c [0.5 (f - 1)] + sin c [0.5 (f + 1)]}
sin c(f - 0.5) + sin c (f + 0.5)

⇒ In a rectangular waveguide cutoff wavelength for TE₁₀mode is 8 cm. Then cutoff wavelength for TE₂₀ mode is
8 cm
6 cm
4 cm
2 cm

⇒ For a 400 kHz transmission line having L = 0.5 mH/km, C = 0.08 mF and negligible R and G, the characteristic impedance will be
14 Ω
28 Ω
39 Ω
79 Ω

⇒ Read the following statements about Excel

It supports many arithmetic functions like SUM, ABS, EXP, INT, MOD etc.
It supports many trigonometric functions.
It supports IRR function to calculate interest rate.
It supports PV function to calculate the present value of future receipts.

Which of the above are correct?
All
1, 2 and 3 only
1, and 2 only
1 only

⇒ A 10 km long line has a characteristic impedance of 400 ohms. If line length is 100 km, the characteristic impedance is
4000 Ω
400 Ω
40 Ω
4 Ω

⇒ Why npn-transistors are preferred over pnp-transistors?
Leakage current in npn-transistors is less than pnp-transistors
Mobility of majority carrier in npra-transistors is greater than the mobility of majority carrier in pnp-transistors
Bias voltage required in npn is less than in/wp-transistors
Bias voltage required in npn is greater than in pnp-transistors

⇒ The property not valid for basic singularity function is
it is even signal
convolution of any arbitrary function x{t) and an impulse is the original function itself.
the sum of two impulses at same location is the impulse with the strength equal to the summation of individual strengths.
none of these.

⇒ The advantage of Weinbridge oscillator over the phase shift oscillator is that oscillator the frequency may be varied over a range of
0.0430555555555556
0.04375
0.0451388888888889
0.0486111111111111

⇒ Which one of the following is transferred locking electron device C antenna?
BARITT diode
IMPATT diode
Gunn diode
Step recovery diode

⇒

Assertion (A): The main use of Miller integrator is to generate ramp

Reason (R): An inverting amplifier can handle more than one input at the same time.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒

Match the following:

	List I (Set operation)		List II (Set operator)
A.	Set equality	1.	-
B.	Set inclusion	2.	=
C.	Set intersection	3.	< =
D.	Set difference	4.	∗

A-2, B-3, C-4, D-1
A-3, B-2, C-4, D-1
A-1, B-2, C-3, D-4
A-4, B-2, C-3, D-1

⇒

Match the following:

	List I		List II
A.	Continuous and aperiodic	1.	Fourier representation is continuous and aperiodic
B.	Continuous and Periodic	2.	Fourier representation is discrete and aperiodic
C.	Discrete and aperiodic	3.	Fourier representation is continuous and periodic
D.	Discrete and periodic	4.	Fourier representation is discrete and periodic

A-3, B-2, C-4, D-1
A-1, B-3, C-2, D-4
A-1, B-2, C-3, D-4
A-2, B-1, C-4, D-3

⇒ The number of address lines in EPROM 4096 x 8 is
2
4
8
12

⇒ In admittance parameter set, the dependent variables are the currents at the two ports.
TRUE
FALSE

⇒ The input to a parity detector is 1001. The output is
0
1
0 or 1
indeterminate

⇒ Nichrome is used for
overhead line wires
heater coils
lamp filaments
all of the above

⇒ Consider the following statements:

Acceptor level is formed very close to the conduction band.
The effective mass of the free electron is same as that of a hole.
The magnitude of the charge of a free electron is same as that of a hole.
Addition of donor impurities adds holes to the semiconductor.

Which of the above statements are correct?
1 and 3
2 and 3
2 and 4
3 and 4

⇒ Which one is true for writing array variable in Pascal?
The general form of an array variable is an integer or a real variable name followed by subscripts enclosed within square brackets. The subscripts are separated by commas
The general form of an array variable must be an integer name followed by subscripts enclosed within square brackets. The subscripts are separated by commas
The subscripts in array variable must be separated by dots
The subscripts must be enclosed within parenthesis

⇒ In the expression a = 5 * 2 / 3.2 + 4 / 8 - 2 + 5 / 9 which operation will have the first priority in C?
5*2
2 / 3.2
5 * 2 / 3.2
42833

⇒ In a 3 phase full wave regulator feeding resistance load connected in star, the possible range of firing angle a is
0 ≤ a ≤ 180°
0 ≤ a ≤ 150°
0 ≤ a ≤ 120°
0 ≤ a ≤ 90°

⇒ A 1 ms pulse can be converted into a 10 ms pulse by using which one of the following
An astable multivibrator
Stable multivibrator
A bistable multivibrator
A J-K flip-flop

⇒ The sampling frequency in CD is 10 kHz.
TRUE
FALSE

⇒ Which of the following assembler directives in 8085 does not cause any memory location to be used μp?
D S
D B
D W
E Q U

⇒

Assertion (A): The main use of positive feedback is in oscillator circuits.

Reason (R): In an oscillator the loop gain Aβ is kept slightly more than unity

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct