Question is ⇒ An RC impedance function has a constant value at s = 0. The last element in the first cauer synthesis, Options are ⇒ (A) will be a capacitor, (B) may be R or C, (C) will be R, (D) will depend on the behaviour of function at s = ∞, (E) , Leave your comments or Download question paper.

Question is ⇒ An RC impedance function has a constant value at s = 0. The last element in the first cauer synthesis, Options are ⇒ (A) will be a capacitor, (B) may be R or C, (C) will be R, (D) will depend on the behaviour of function at s = ∞, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An RC impedance function has a constant value at s = 0. The last element in the first cauer synthesis
A.	will be a capacitor [Wrong Answer]
B.	may be R or C [Wrong Answer]
C.	will be R [Correct Answer]
D.	will depend on the behaviour of function at s = ∞ [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Resistivity of hard drawn copper is
less than that of annealed copper
more than that of annealed copper
same as that of annealed copper
decreasing when temperature increases

⇒ In figure, the current after a long time after closing of switc
0.0416666666666667
0.0833333333333333
0
infinity

⇒ A 6 MHz channel is used by a digital signalling system initializing four-level signals. The maximum possible transmission rate is
6M bands/s
12M bands/s
6 M bits/s
12M bits/s

⇒ The voltage e₀ in the fi
48 V
24 V
36 V
28 V

⇒ IC 74181 performs arithmetic operations when M = 1.
TRUE
FALSE

⇒ In an integrated circuit the SiO₂layers provide
electrical connection to external Ckt.
physical strength
isolation
conducting path.

⇒ I = dq/dt.
TRUE
FALSE

⇒ Read the following statements about TWT

It uses thermionic emission.
It uses an attenuater.
It is inherently a resonant device.
It has broad bandwidth.

Which of the above are correct?
1, 2, 3 and 4
1, 2 and 3
1, 3 and 4
1, 2 and 4

⇒

Assertion (A): For elemental dielectrics, P = Na_eE_i where N is number of atoms/m³, P is polarization, a_e is electronic polarization and E_i is internal electric field.

Reason (R): In elemental dielectrics there are no permanent dipoles or ions.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Inductors used at V.H.F. are made using
air core
cast iron cored
sheet steel cored
thin film technique

⇒ Resistivity of rubber is about
10² Ω-m
10^-2 Ω-m
5 x 10⁸ Ω m
5 x 10¹² Ω-m

⇒ State space analysis is applicable to
time invariant systems
time varying systems
both time invariant and time varying systems
none of the above

⇒ In narrowband FM, the modulation index is
near unity
about 100
about 0.1
about 300

⇒ In a CE amplifier it is desired that the signal should be able to swing equally in both directions. Then the Q point should be
at the centre of ac load line
at the centre of dc load line
at the centre of collector voltage
at the centre of collector current

⇒ In an R-C circuit, the impedance is 40 Ω at a frequency of 100 Hz. At 200 Hz the impedance should be
40 Ω
80 Ω
20 Ω
more than 20 Ω but less than 40 Ω

⇒ Four messages band limited to W, W, 2W and 3W respectively are to be multiplex using Time Division Multiplexing (TDM). The minimum bandwidth required for transmission of this TDM signal is
W
3W
6W
7W

⇒ The inductance of a single layer solenoid of 10 turns is 5 μH. Which one of the following is the correct value of inductance when the number of turns is 20 and the length is doubled.
10 μH
20 μH
40 μH
5 μH

⇒ A rectangular metal waveguide filled with a dielectric of relative permittivity ε_r = 4, has the inside dimensions 3 x 1.2 cm, the cut off frequency for the dominant mode is
2.5 GHz
5 GHz
10 GHz
12.5 GHz

⇒ Which of the following instruction modes does not exist in microprocessor 8085?
Inherent
Immediate
Absolute
Indirect

⇒ The number of cells in a 4 variable K map is
16
8
4
32

⇒

Assertion (A): In liquid system the ratio of change in liquid level to change in flow rate is called resistance of liquid flow.

Reason (R): In liquid level systems the ratio of change in liquid stored in a tank to the change in head is called capacitance of tank.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A dc power supply has no load voltage of 30 V and full load voltage of 25 V at full load current of 1 A. The output resistance and voltage regulation respectively are
5 Ω and 25%
25 Ω and 20%
5 Ω and 16.7%
25 Ω and 16.7%

⇒ The transfer function V₂/V₁ for figure
a zero at origin
a zero at infinity
no zero
a zero at j1

⇒ Even at room temperature, an intrinsic semiconductor has some holes. These holes are due to
electron
doping
thermal energy
free electrons

⇒ A single phase full wave regulator feeds R-L load. The best gating signal is
short duration pulses
long duration pulses
pulse train
either (a) or (b)

⇒ In n-well CMOS fabrication substrate is:
heavily doped n-type
heavily doped p-type
lightly doped n-type
lightly doped p-type

⇒ A 3 bit binary adder can add
2 bits
2 bits
3 bits
8 bits

⇒ Emitter follower is in which of following configuration.
common Base
common Emitter
common collector
common Base or common Emitter

⇒ In the given figure A = 1, B = 1. B is now changed to a sequence 101010................The outputs X and Y wil
fixed at 0 and 1 respectively
X = 1010.......and Y = 0101........
X = 1010..........and Y = 1010
fixed at 1 and 0 respectively.

⇒ In the vacuum diode equation i_b = ke_b^1.5, the current is
temperature limited current
space charge limited current
any of the above
none of the above