Question is ⇒ An oscillator requires an amplifier, Options are ⇒ (A) with negative feedback, (B) with positive feedback, (C) with either positive or negative feedback, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ An oscillator requires an amplifier, Options are ⇒ (A) with negative feedback, (B) with positive feedback, (C) with either positive or negative feedback, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An oscillator requires an amplifier
A.	with negative feedback [Wrong Answer]
B.	with positive feedback [Correct Answer]
C.	with either positive or negative feedback [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a type 1 system and unit parabolic input, the steady state error is
0
∞
1
1/K_v

⇒ In a JFET V_DS exceeds the rated value. Then it operates in
active region
ohmic region
cut off region
either cut off or active region

⇒

Match the following:

	List I (Characteristics)		List II (Decrease)
A.	Paramagnetic	1.	All dipoles are aligned is one preferred direction
B.	Ferromagnetic	2.	Half the dipoles are aligned in opposite direction and have equal magnitude
C.	Antiferromagnetic	3.	Half the dipoles (with equal magnitudes) are aligned in opposite direction to the other half having equal but lower magnitude
D.	Ferrimagnetic	4.	All dipoles have equal magnitude but are randomly oriented

A-4, B-3, C-2, D-1
A-4, B-1, C-2, D-3
A-2, B-1, C-4, D-3
A-2, B-3, C-4, D-1

⇒ A single phase step up cycloconverter changes 50 Hz to 100 Hz. Then one half wave of input will give rise to
one half wave of output
one full wave of output
two full waves of output
either (b) or (c)

⇒ Good frequency stability can be available
crystal oscillators
Hartley oscillators
colpitts oscillators
none of the above

⇒ Which one of the following parameters does not exist for the two port network shown in the given fig
ABCD
y
h
z

⇒ Without a spectrum analyser, it is not possible to determine
carrier frequency
antenna pattern
pulse width
spurious signal strength and its location

⇒ For a 400 kHz transmission line having L = 0.5 mH/km, C = 0.08 mF and negligible R and G, the value of propagation constant P will be
15.9 radians/km
31.8 radians/km
63.6 radians/km
105.4 radians/km

⇒ In a base driver amplifier the voltage gain is the ratio of
ac collector voltage to ac base voltage
ac emitter voltage to ac base voltage
ac collector voltage to ac emitter voltage
ac base voltage to ac emitter voltage

⇒ The voltage e₀ in the fi
48 V
24 V
36 V
28 V

⇒

Assertion (A): In a series resonant circuit current is maximum at resonance.

Reason (R): The inductive and capacitive reactances are equal.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Consider the following statements

Impedance of Gunn diode is about tens of ohms.
Impedance of Impatt diode is a few ohms.
Impedance of Impatt diode are of the same order.
Impedance of Impatt diode is more than that of Gunn diode.

Which of the above statement are correct?
all
1 and 2 only
1, 2 and 3
1, 2 and 4

⇒ With I_s disconnected I = - 1, when I_s = b is connected, the value of I will be
0.0833333333333333
-1 A
0.0416666666666667
0.125

⇒ IN 3242 is a
P-N-P transistor
N-P-N transistor
UJT
semi-conductor diode

⇒ A monostable multivibrator is used to generate PWM because it can
differentiator
integrator
voltage-to-frequency converter
generate pulses

⇒ With 2's complement representation, the range of values that can be represented on the data bus of an 8 bit microprocessor is given by
-128 to 127
-128 to +128
-127 to 128
-256 to 256

⇒ The pressure coil of a wattmeter should be connected to the supply side of the current coil when
load impedance in high
load impedance is low
voltage is high
voltage is low

⇒

Assertion (A): Silicon is the most favoured semiconductor material.

Reason (R): PIV for silicon diode is more than that for germanium diode.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following lines is non-radiating?
Open two wire
Coaxial
Both
None of the above

⇒ Hall effect is observed in a specimen when it is carrying current and is placed in a magnetic field. The resultant electric field inside the specimen is
normal to both current and magnetic field
in the direction of current
antiparallel to magnetic field
in arbitrary direction

⇒ The input differential stage of op-amp. 741 is baised at about 10 μA current such a low current of the input stage gives

high CMRR
high differential gain
low differential
high input impedance

Which of these are correct?
1 and 2
1, 2 and 4
3 and 4
1, 2, 3 and 4

⇒ In which of the following device electrons will be the majority carriers?
P-type semiconductor
N-type semiconductor
N-P-N transistor
P-N-P transistor

⇒ In PCM, if the number of quantization levels is increased from 4 to 64, then the bandwidth requirement will approximately be increased __________ times.
8
16
3
32

⇒ The input resistance R, of an ideal voltage amplifier is __________ and that of a current amplifier is __________ .
zero, zero
infinite, infinite
zero, infinite
infinite, zero

⇒ If f(t) is an odd func
TRUE
FALSE

⇒ In the given figure shows a 3 bit shift register using TTL flip flops. Initially all the flip flops are set to 0 state. After 8 clock pul
A = 1, B = 1, C = 1
A = 1, B = 1, C = 0
A = 0, B = 1, C = 1
A = 0, B = 0, C = 1

⇒ A 12 kHz pulse wave-form is amplified by a circuit having an Upper cut-off frequency of 1 MHz. The minimum input pulse width that can be accurately reproduced is
83.33 μ sec
1 μ sec
0.1 m sec
3.5 m sec

⇒ The maximum theoretical efficiency for class A amplifier is
0.125
0.25
0.5
0.75

⇒ An LED has a rating of 2 V and 10 mA. It is used along with 6V battery. The range of series resistance is
0 to 200 Ω
200 - 400 Ω
200 Ω and above
400 Ω and above

⇒ In Bode diagrams an octave is a frequency band from
ω₁ to 10 ω₁
ω₁ to 8 ω₁
ω₁ to 4 ω₁
ω₁ to 2 ω₁