Question is ⇒ An op-amp has zero gain for common mode inputs. Then CMRR =, Options are ⇒ (A) zero, (B) infinite, (C) high, (D) low, (E) , Leave your comments or Download question paper.

Question is ⇒ An op-amp has zero gain for common mode inputs. Then CMRR =, Options are ⇒ (A) zero, (B) infinite, (C) high, (D) low, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An op-amp has zero gain for common mode inputs. Then CMRR =
A.	zero [Wrong Answer]
B.	infinite [Correct Answer]
C.	high [Wrong Answer]
D.	low [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Figure represen
Tunnel diode
PNP transistor
Photo sensitive diode
Photo emissive diode

⇒ Which of the following integer expressions is correct in Pascal?
- A + B + M
A div B * mod C
A - 4.0
A / B + D

⇒ The circuit given below
counter
digital to analog converter
two-bit series-to-parallel converter
analog-to digital converter

⇒ Maximum undistorted power output of a transmitter is obtained when its modulation is __________ percent.
more than 100
100
less than 100
50

⇒ A Weston frequency meter is
moving coil instrument
moving iron instrument
dynamometer instrument
induction instrument

⇒ In high power AM transmission, modulation is done at
IF stage
buffer stage
RF stage
oscillator stage

⇒ A radio frequency signal contains the following three frequencie
Push pull amplifier
Wideband amplifier
Audio frequency amplifier
Tuned voltage amplifier

⇒ In figure, the curre
is 2 A from A to B
is 2 A from B to A
depends on the value of R
none of the above

⇒ Which of the following is not a valid variable name in C?
p o, t
p o t
po_t
p_ot

⇒ The ratio of active power to apparent power is known as __________ factor.
power
load
form
demand

⇒ The value of the inductance of coil in which a current increases linearly from zero to 0.1A in 0.2 second producing a voltage of 5 volts is __________ .
2.5
5
10
20

⇒ When a transistor is connected in common emitter mode, it with have
negligible input resistance and high output resistance
high input resistance and low output resistance
medium input resistance and high output resistance
low input resistance as well as output resistance

⇒ An accelerometer has a seismic mass of 0.05 kg and spring constant of 3 x 10⁵ N/m. If maximum displacement of mass is ± 1 mm, the maximum acceleration which can be measured is
30 m/s²
60 m/s²
90 m/s²
120 m/s²

⇒ In which one of the following types of analog to digital convertors the conversion time is practically independent of the amplitude of the analog signal?
The dual slope integrating type
Successive approximation type
Counter ramp type
Tracking type

⇒ E_G for silicon is 1.12 eV and that for germanium is 0.72 eV. Therefore it can be concluded that
more number of electron-hole pairs will be generated in silicon than in germanium at room temperature
less number of electron hole pairs will be generated in silicon than in germanium at room temperature
equal number of electron-hole pairs will be generated in both at lower temperatures
equal number of electron-hole pairs will be generated in both at higher temperatures

⇒ A current of 3.18 A is flowing through resistance of 35.68 Ω. The voltage drop across resistance to the appropriate number of significant figures is
113.4624 V
113.462 V
113.46 V
113 V

⇒ To produce p type semiconductor we add
acceptor atoms
donor atoms
pentavalent impurity
trivalent impurity

⇒ The relative permittivity of the ionosphere at ratio frequencies is
> 1
< 1
1
≥ 1

⇒ In an n-p-n transistor biased for operation in forward active region
emitter is positive with respect to base
collector is positive with respect to base
base is positive with respect to emitter and collector is positive with respect to base
none of the above

⇒ The useful magnetic flux obtainable from any closed surface is
unity
constant
both (a) and (b)
none of the above

⇒ A typical error rate on satellite circuits is one bit error in
10⁷
10³
10²
10¹⁰

⇒ The gain of collinear arrays is maximum when the spacing between the elements is
0.1 λ to 0.3 λ
0.3 λ to 0.9 λ
0.5 λ to 0.7 λ
0.7 λ to 0.9 λ

⇒ The primary colours are
blue and green
blue and red
red and green
blue, red and green

⇒ In the given figure forward current wave has a magnitud
0.45 A
0.3 A
0.2 A
0.1 A

⇒ In PCM, the quantization noise depends on
sampling rate
signal power
number of quantization level
signal energy

⇒ Choose the correct statement/statements :
In case of an antenna, the antenna resistance and loss resistance are not two different quantities.
The loss resistance includes loss by eddy currents, improper earth connections, insulation leakages, etc., but not I²R losses.
Radiation resistance varies directly as square-root of frequency
None

⇒ A parallel in-parallel out shift register can be used to introduce delay in digital circuits.
TRUE
FALSE

⇒ If the energy gap of a semiconductor is 1.1 eV, then it would be
opaque to visible light
transparent to visible light
transparent to ultraviolet radiation
transparent to infrared radiation

⇒ Zero bias works only with
D MOSFETs
E MOSFETs
both D and E MOSFETs
neither D nor E MOSFETs

⇒ Let the initial contents of ACC and CY in 8085 be

CY = 1
ACC = 10000001

After the instruction RAL is executed twice the contents of CY and ACC respectively will be
1 and 00000011
0 and 00000111
1 and 00000111
0 and 00000011