Question is ⇒ An LVDT is used to measure displacement. The LVDT feeds a Voltmeter of 0-5 V range through a 250 gain amplifier. For a displacement 0.5 mm the output of LVDT is 2 mV. The sensitivity of instrument is, Options are ⇒ (A) 0.1 V/mm, (B) 0.5 V/mm, (C) 1 V/mm, (D) 5 V/mm, (E) , Leave your comments or Download question paper.

Question is ⇒ An LVDT is used to measure displacement. The LVDT feeds a Voltmeter of 0-5 V range through a 250 gain amplifier. For a displacement 0.5 mm the output of LVDT is 2 mV. The sensitivity of instrument is, Options are ⇒ (A) 0.1 V/mm, (B) 0.5 V/mm, (C) 1 V/mm, (D) 5 V/mm, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An LVDT is used to measure displacement. The LVDT feeds a Voltmeter of 0-5 V range through a 250 gain amplifier. For a displacement 0.5 mm the output of LVDT is 2 mV. The sensitivity of instrument is
A.	0.1 V/mm [Wrong Answer]
B.	0.5 V/mm [Wrong Answer]
C.	1 V/mm [Correct Answer]
D.	5 V/mm [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Two capacitors of 20 μF each are in series. The total capacitance is
5 μF
10 μF
40 μF
400 μF

⇒ Which among the following waveforms can be reconstructed from its samples without distort
1 and 2
2 and 3
1 and 3
Only 2

⇒ The temperature coefficient of resistivity of semiconductors is
positive
negative
may be positive or negative
very low

⇒ Which of the following is not an integer constant?
2.3
156231
10
-256

⇒ RMS value of a square wave is the same as peak value.
TRUE
FALSE

⇒ An op-amp uses
RC coupling
direct coupling
transformer coupling
either (b) or (c)

⇒ The number of leads in a power semiconductor diode are
2
3
4
2 or 3

⇒ A constant k low pass T section filter has a characteristic impedance of 600 p at zero frequency. At f = f_c the characteristic impedance is
600 Ω
zero
infinite
more than 600 ohms

⇒ The divergence of the electric field intensity at any point equals
1/4 pε₀ times the volume charge density
l/ε₀ times the volume charge density at that point
ε₀ times the volume charge density at that point
the volume charge density at that point

⇒ An antenna having a high Q has
lower BW
higher BW
flat response
none of the above

⇒ The following Variable Entered Map (VEM) represents which of the following funct
f(A, B, C, D) = ∑(1, 2, 3, 4, 7, 8, 9, 14, 15) + Φ(3, 5, 12, 13)
f(A, B, C, D) = ∑(1, 2, 4, 8, 10, 8, 13, 15) + Φ(3, 6, 12, 14)
f(A, B, C, D) = ∑(1, 2, 4, 7, 8, 10, 13, 15) + Φ(6, 12, 13)
f(A, B, C, D) = ∑(1, 2, 4, 7, 8, 9, 12, 13) + Φ(3, 5, 14, 15)

⇒ Resistivity of copper is lower than that of nickel. When a small percentage of copper is added to nickel, the resistivity
increases
decreases
may increase or decrease
remains the same

⇒ Which of the following antennas is λ /4 length?
Dipole
Marconi
Monopole
Parabolic

⇒ When P-N junction is in forward bias, by increasing the battery voltage
current through P-N junction reduces
current through P-N junction increases
circuit resistance increases
none of the above

⇒ In the state equation x = AX + Bu is a n x m matrix.
TRUE
FALSE

⇒ In tape recorder erase head is active during recording.
TRUE
FALSE

⇒ The forbidden energy gap between the valence band and conduction band will be wide in case of
semiconductors
all metals
good conductors of electricity
insulators

⇒ For an amplifier the power gain in decibels will be equal to voltage gain in decibels only when
R₀ = 0
R₀ = R_i = 90
R₀ = R_i
R_i = 0

⇒ For an amplifier the input output signals are shown in figure. The class of amplifie
A
AB
B
C

⇒ In a CE amplifier the collector resistance is short circuited. The ac output voltage will
increases
remains the same
increases or decreases
decreases

⇒ In a full wave rectifier, the current in each of the diodes flows for
the complete cycle of the input signal
half cycle of the input signal
less than half cycle of the input signal
one-fourth cycle of the input signal

⇒

Match the following:

	List I		List II
A.	Detection of a periodic signal in noise	1.	Increase in band-width
B.	Recovery of a band limited signal from its uniformly sampled values	2.	Slope over load error
C.	Finer quantization	3.	Nyquist rate of signals
D.	Delta modulation	4.	Cross correlation

A-4, B-3, C-1, D-2
A-3, B-2, C-1, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-4, D-1

⇒ The poles of an RC function
are simple and lie or negative real axis
are simple and lie on ω axis
must be complex conjugate
may be anywhere on s plane

⇒ A fully charged mobile phone with a 12 V battery is good for a 20 minute talktime. Assume that, during the talk time, the battery delivers a constant current of 2 A and its voltage drops linearly from 12 V to 10 V as shown in the figure. How much energy does the battery deliver during this talk t
220 J
12 kJ
13.2 kJ
14.4 kJ

⇒ In a P-N-P transistor, with normal bias, the emitter junction
is always reverse biased
offers very high resistance
offers a low resistance
remains open

⇒ The output impedance of a logic pulser is
low
high
may be Low or High
can't say

⇒ 1's complement of 11100110 is
11001
10000001
11010
0

⇒ A discrete zero memory information source has 40 symbols and each symbol is equally likely. The minimum number of bits required to code the source with uniform length code and entropy of the source are
5 and 5.03
6 and 5.83
5 and 6.64
6 and 5.32

⇒ In FM modulation pre-emphasis is done for
high frequency components
low frequency components
middle frequency components
both (a) and (b)

⇒ The term efficacy, is defined by
same as efficiency
measure of the ability of a device to produce a desired effect
input/output
(efficiency)²