Question is ⇒ An LED has a rating of 2 V and 10 mA. It is used along with 6V battery. The range of series resistance is, Options are ⇒ (A) 0 to 200 Ω, (B) 200 - 400 Ω, (C) 200 Ω and above, (D) 400 Ω and above, (E) , Leave your comments or Download question paper.

Question is ⇒ An LED has a rating of 2 V and 10 mA. It is used along with 6V battery. The range of series resistance is, Options are ⇒ (A) 0 to 200 Ω, (B) 200 - 400 Ω, (C) 200 Ω and above, (D) 400 Ω and above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An LED has a rating of 2 V and 10 mA. It is used along with 6V battery. The range of series resistance is
A.	0 to 200 Ω [Wrong Answer]
B.	200 - 400 Ω [Wrong Answer]
C.	200 Ω and above [Wrong Answer]
D.	400 Ω and above [Correct Answer]
View Answer 2 -4 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In VHS format each video head is tilted from azimuth by
20°
10°
6°
1°

⇒ When energy is fed into open wire transmission line the energy may get dissipated due to
radiation
conductor heating
dielectric heating
all of the above

⇒ When temperature is more than ferromagnetic curie temperature, the behaviour of a ferromagnetic material is similar to that of paramagnetic material.
TRUE
FALSE

⇒ In the circuit of figure the current through 3 Ω resistance at t = 0^{+0.166666666666667
2.5 A
3.1 A
0}

⇒ Which of the following term does not apply to the Yagi-Uda array?
High gain
Folded dipole
Parasitic
Good bandwidth

⇒ Permittivity has the units of F/m.
TRUE
FALSE

⇒ A Charge Couple Device (CCD) is a
RAM
sequential accessed memory
content addressable memory
read only memory

⇒ Bandwidth is proportional to speed of response.
TRUE
FALSE

⇒ A JK flip flop has t_pd= 12 ns. The largest modulus of a ripple counter using these flip flops and operating at 10 MHz is
16
64
128
256

⇒ Epitaxial growth is used in ICs
because it produces low parasitic capacitance
because it yields back to back isolating pn junction
to grow single crystal n doped silicon on a single crystal p type substrate
to grow selectively single crystal p doped silicon of one resistivity on a p type substrate of a different resistivity

⇒ In a square law modulator, the carrier frequency should be __________ times than the highest modulating frequency.
1
2
4
3

⇒ For the two ports in figure, y₁₁ = 8 mho, y₁₂ = y₂₁ = -6 mho and y₂₂ = 6 mho. The values of Y_A, Y_B, Y_C respectively
2, 6, 6 mho
2, 6, 0 mho
2, 0, 6 mho
2, 6, 8 mho

⇒ Two similar coupled coils are connected in series. The total inductance in series aiding connection is 100 mH. If currents is 3 A, the energy stored in magnetic field is
0.9 J
0.45 J
0.225 J
1.8 J

⇒ In a highly capacitive circuit the
apparent power is equal to the actual power
reactive power is more than the apparent power
reactive power is more than the actual power
actual power is more than its reactive power

⇒ In the op-amp circuit of figure, V_{0V_i
3 V_i
5 V_i
0.5 V_i}

⇒ In 8085 the term 'absolute addressing' means
Direct addressing
Immediate addressing
Register addressing
Register indirect addressing

⇒ In PCM, if the number of quantization levels is increased from 4 to 64, then the bandwidth requirement will approximately be increased __________ times.
8
16
3
32

⇒ In n channel JFET, the gate voltage is made more negative
the channel width will increase
the channel width will decrease
the channel width and drain current will decrease
the channel width will decrease and drain current will increase

⇒ In a crystal
the frequencies of series and parallel resonance are equal
the frequency of series resonance is more than frequency of parallel resonance
the frequency of parallel resonance is more than frequency of series resonance
None of the above

⇒ Two wattmeter method of 3-phase power measurement can be used to find
total active power
total active power and power factor
total active power and reactive power
total active power, power factor, apparent power, and reactive power

⇒ Antenna used for T.V. broadcasting is
long dipole
metal horn
crossed dipole
log periodic

⇒ Which one of the following can be used as parallel to series converter?
Decoder
Digital counter
Multiplexer
Demultiplexer

⇒ The units for apparent power are watts.
TRUE
FALSE

⇒ Skin effect is more pronounced at high frequencies.
TRUE
FALSE

⇒ The chip 8254 is a 40 pin programmable interval timer. The number of its independent 16 bit counters is
2
3
4
5

⇒ Two resistances of 2 Ω each are connected in series. A shunt having zero resistance is connected across the combination. The overall resistance will be
4 Ω
1 Ω
0.5 Ω
zero

⇒ Which of the following is a valid real variable in FORTRAN 77?
KPR
LINE
JOB
RATE

⇒

Assertion (A): The resolution of a DAC depends on the number of bits

Reason (R): Low resolution leads to fine control.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The power factor at the input terminals of a cyclo- converter is generally
low and leading
low and lagging
high and leading
high and lagging

⇒

Assertion (A): The condition of minimum distortion in a transmission line is L = RC/G.

Reason (R): Line loading means addition of inductance to satisfy the condition L = RC/G.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct